钠硼硅酸盐玻璃分相及浸析的NMR研究

用多种ＮＭＲ方法，包括＾２９Ｓｉ、＾２３Ｎａ，＾１１Ｂ ＭａＳ及＾２９Ｓｉ ＣＰ／ＭＡＳ ＮＭＲ，研究了一定组成的ａ２Ｏ－Ｂ２Ｏ３－ＳｉＯ２三元体系玻璃在不同温度下分相处理２４小时及用酸浸析处理后的结构变化。结果表明，在低于分相上界临界温度的范围内，存在着一个温度转折点，低于这一温度时，受动力学因素影响，分相未达平衡态，温度愈低，距平衡态愈过，分相愈下完全。超过这一温度，分相可达平衡态，受热力学控     

Effects of sugar inhibition on cellulases and β-glucosidase during enzymatic hydrolysis of softwood substrates

A quantitative approach was taken to determine the inhibition effects of glucose and other sugar monomers during cellulase and β-Glucosidase hydrolysis of two types of cellulosic material: Avicel and acetic acid-pretreated softwood. The increased glucose content in the hydrolysate resulted in a dramatic increase in the degrees of inhibition on both β-Glucosidase and cellulase activities. Supplementation of mannose, xylose, and galactose during cellobiose hydrolysis did not show any inhibitory effects on β-Glucosidase activity. However, these sugars were shown to have significant inhibitory effects on cellulase activity during cellulose hydrolysis. Our study suggests that high-substrate consistency hydrolysis with supplementation of hemicellulose is likely to be a practical solution to minimizing end-product inhibition effects while producing hydrolysate with high glucose concentration.     

聚丙烯中空纤维膜的微孔结构的控制

通过熔纺／冷拉伸法制备了微孔聚丙烯中空纤维膜。研究了工艺条件对微孔聚丙烯中空纤维膜的微孔结构与性能的影响。结果表明：随着纺丝温度的下降或熔体拉伸比的提高，最大可几孔径及孔隙率增大；熔纺中冷却风速提高，最大可几孔径及孔隙率较大；温度低于110℃时，热处理对最大可几孔径及孔隙率的影响较小，在120－130℃时，随着热处理温度的增加，最大孔径及孔隙率有明显增加的趋势；随着初纺中空纤维拉伸倍数的增加，孔隙率先增加而后下降。     

壳聚糖固体聚合物电池用膜

壳聚糖是甲壳素脱乙酰基的产物，具有良好的成膜性、生物相容性、环保以及价格低廉等特点。作为一种碱性高分子膜材料，近年来已成为聚电解质研究领域中的研究热点。本文综述了壳聚糖固体聚合物电池用膜的研究现状，其改性工艺主要包括共混、化学改性、质子酸掺杂、无机盐掺杂等方法，比较了各种工艺处理后壳聚糖固体聚合物电解质膜的性能差异，并就壳聚糖固体聚合物电解质膜中离子传导机理中有待解决的问题进行探讨，并提出了进一步改进壳聚糖固体聚合物电解质膜性能的研究思路。     

DNA intercalating studies of [Ru(bpy)<Subscript>2</Subscript>HPIP]<Superscript>2+</Superscript> with intramolecular hydrogen bond ligand based on introduction of copper ion

The effects of copper ion on the interaction of [Ru(bpy)₂HPIP]²⁺(bpy = 2,2′-bipyridine, HPIP = 2-(2-hydroxyphenyl) imidazo [4,5-f] [1, 10] phenanthroline) with DNA have been investigated by electronic absorption spectroscopy and fluorescence spectroscopy. HPIP ligand of the complex with an intramolecular hydrogen bond can bind Cu²⁺ in the absence of DNA, as revealed by the absorbance and fluorescence decrease for [Ru(bpy)₂HPIP]²⁺. The resultant heterometallic complex binds to DNA via intercalation of HPIP into the DNA base pairs and its DNA-binding ability is stronger than [Ru(bpy)₂HPIP]²⁺ itself. The DNA bound [Ru(bpy)₂HPIP]²⁺ cannot bind Cu²⁺ at low Cu²⁺ concentration and the intramolecular hydrogen bond in HPIP is located inside the DNA helix. While the Cu²⁺ concentration is relative high, Cu²⁺ can quench the fluorescence of DNA bound [Ru(bpy)₂HPIP]²⁺. The quenching reason is proposed.     

Fabrication of hexaphenylsilole nanowires and their morphology-tunable photoluminescence.

Immersion of nanoporous alumina membranes into saturated solutions of hexaphenylsilole with subsequent solvent evaporation affords aligned organic nanowires. The luminescent properties of the hexaphenylsilole nanowires can be manipulated by varying their morphologies, which were controlled by changing the channel sizes of the alumina templates.     

1，2—二氯丙烷裂解反应光窗结焦机理的研究

有机化合物在光窗上的结焦严重地影响激光引发化学反应及光学原位实时探测。本文报道在1，2－二氯丙烷反应系统中，光窗结焦现象同时存在于激光引发反应及热反应过程中，对光窗在300℃条件 下的结焦机理研究表明，少量氧气在光窗结焦过程中起关键作用。结焦前驱体的红外光谱研究表明，前驱体的可能结构为1－丙炔－1，3－二醇的缩聚体。该化合物极易通过缩聚反应形成更大的分子，最终导致光 窗结焦。对系统及反应物进行彻底除氧，光窗结焦现象大为改善。     

合成1，3－二（3－羟丙基）四甲基二硅氧烷的新方法

用二乙氧基二甲基硅烷与３－氯丙醇反应，合成了新化合物３－氯丙氧基乙氧基二甲基硅烷，然后用格氏反应代替Ｗａｌｔｅｒ的钠缩合反应，最后经水解制备了１，３－二（３－羟丙基）四甲基二硅氧烷，总收率为４２．０％。     

A microfluidic device using a green organic light emitting diode as an integrated excitation source

A simply fabricated microfluidic device using a green organic light emitting diode (OLED) and thin film interference filter as integrated excitation source is presented and applied to fluorescence detection of proteins. A layer-by-layer compact system consisting of glass/PDMS microchip, pinhole, excitation filter and OLED is designed and equipped with a coaxial optical fiber and for fluorescence detection a 300 microm thick excitation filter is employed for eliminating nearly 80% of the unwanted light emitted by OLEDs which has overlaped with the fluorescence spectrum of the dyes. The distance between OLED illuminant and microchannels is limited to approximately 1 mm for sensitive detection. The achieved fluorescence signal of 300 microM Rhodamine 6G is about 13 times as high as that without the excitation filter and 3.5 times the result of a perpendicular detection structure. This system has been used for fluorescence detection of Rhodamine 6G, Alexa 532 and BSA conjugates in 4% linear polyacrymide (LPA) buffer (in 1 x TBE, pH 8.3) and 1.4 fmol and 35 fmol mass detection limits at 0.7 nl injection volume for Alexa and Rhodamine dye have been obtained, respectively.     

苯丙氨酸改性树枝状聚赖氨酸的合成及表征

以双芴甲氧羰基赖氨酸(Di- Fmoc -Lysine)为支化单元采用固相多肽合成技术制备了一种树枝状聚赖氨酸.该聚合物表面活性氨基通过与芴甲氧羰基苯丙氨酸(Fmoc- Phe)反应获得表面完全替代的苯丙氨酸改性树枝状聚赖氨酸.产物的分子量和结构经MS和NMR进行了表征.研究结果表明,利用该方法得到的产物分子量单一,是一种潜在的理想非病毒治疗载体.