聚四氟乙烯和石墨对聚醚酰亚胺摩擦学性能的影响

将聚四氟乙烯(PTFE)和石墨两类减摩耐磨填料填充到聚醚酰亚胺(PEI)中,表征其摩擦性能,利用扫描电子显微镜分析了磨损表面的显微结构,并分析了磨损机制.研究结果表明,PTFE和石墨的填充明显改善了PEI的摩擦磨损性,摩擦系数降低到0.3以下(纯PEI的摩擦系数为0.41),磨损率降低了3个数量级.在PTFE体系中,PTFE质量分数为10%时,PEI基共混材料的摩擦系数最低为0.23;而在质量分数为15%的石墨体系中,PEI基共混材料摩擦系数最低为0.27.磨损率随着填料含量的增加而逐渐下降,在填料质量分数为20%之后,摩损率下降平缓.因此PTFE和石墨的填充对PEI的摩擦学性能起到了很好的改善作用,而且PTFE比石墨的改善效果更优益.共混物的机械性能测试结果表明,在填料质量分数为5%~15%时,共混物具有良好的机械性能.     

Isolation of three glucaric acids from Leonurus japonicus Houtt. by using high-speed countercurrent chromatography combined with semi-preparative high-performance liquid chromatography

The isomerism of glucaric acids and the complexity of the composition of Leonurus japonicus Houtt. increased the difficulty of the separation of glucaric acids from the herb. In the present study, three glucaric acids were isolated from Leonurus japonicus Houtt. by using high-speed countercurrent chromatography combined with semi-preparative high-performance liquid chromatography. Cation exchange resin chromatography was applied to remove the alkaloids and enrich the glucaric acid fractions. Preliminary separation of the glucaric acid extract by high-speed countercurrent chromatography was carried out at 45℃ by using an optimized solvent system of ethyl acetate/n-butanol/formic acid/water (1:1:0.01:2, v/v/v/v) with satisfied stationary phase retention and separation factor. The semi-preparative high-performance liquid chromatography was used for further separation and purification of the target fractions, and three monomeric compounds were obtained with purities of 90.0, 91.0, and 95.3%. UV spectroscopy, NMR spectroscopy, and mass spectrometry were employed to identify their structures, which were assigned as 2-syringyl glucaric acid, 2,4-disyringyl glucaric acid, and 3,4-disyringyl glucaric acid, respectively, and 2,4-disyringyl glucaric acid was reported for the first time.     

Recent Process of Photo-responsive Materials with Aggregation-induced Emission

The research of photo-responsive materials, with changed absorption and emission under light stimulus, has drawn more and more attention due to their wide applications. However, most of them suffered from the notorious aggregation-caused quenching(ACQ) effect, which often led to the unconspicuous luminescent change in photo-responsive process. To solve this problem, the strategy of combining aggregation-induced emission(AIE) and photochromic properties was utilized, which largely enriched the phenomenon and application of photo-responsive materials. This short review summarized the recent progress of photo-responsive AIE materials with changed UV absorbance or PL phenomenon under UV-irradiation, including the types of molecular structures, internal mechanisms and the practical applications. Also, some outlooks were given on the further exploration of this field at the end of this paper.     

基于联合分步APIT定位算法的改进

本文研究了无线传感网络( Wireless Sensor Network,WSNs)的节点定位问题,并针对APIT由于锚节点在低密度环境下的节点误判和节点失效等问题给出了改进,在APICT定位算法的基础提出了联合分步定位算法UNION-APICT(Union Approximate Point-In-Circumcircle Test),该算法是结合连通性的测距技术,RSSI测距技术以及质心定位和APICT等技术,来联合解决对未知节点定位问题。通过仿真实验结果表明,改进后的UNION-APICT在APICT算法的基础之上平均定位误差减少了10%-25%,定位性能有了明显的提升;随着通信半径R和最大探测距离rmax的增加,定位误差也在逐渐减小,该算法较APIT和APICT定位算法在锚节点密度、节点覆盖率和定位精度上都有所提高。     

Tunable Oxygen Activation for Catalytic Organic Oxidation: Schottky Junction versus Plasmonic Effects

The charge state of the Pd surface is a critical parameter in terms of the ability of Pd nanocrystals to activate O₂ to generate a species that behaves like singlet O₂ both chemically and physically. Motivated by this finding, we designed a metal–semiconductor hybrid system in which Pd nanocrystals enclosed by {100} facets are deposited on TiO₂ supports. Driven by the Schottky junction, the TiO₂ supports can provide electrons for metal catalysts under illumination by appropriate light. Further examination by ultrafast spectroscopy revealed that the plasmonics of Pd may force a large number of electrons to undergo reverse migration from Pd to the conduction band of TiO₂ under strong illumination, thus lowering the electron density of the Pd surface as a side effect. We were therefore able to rationally tailor the charge state of the metal surface and thus modulate the function of Pd nanocrystals in O₂ activation and organic oxidation reactions by simply altering the intensity of light shed on Pd–TiO₂ hybrid structures.     

QuEChERS结合高效液相色谱-串联质谱法测定饲料中的18种β-兴奋剂

建立了饲料中克仑特罗、莱克多巴胺、喷布特罗、妥布特罗等18种β-兴奋剂的QuEChERS结合高效液相色谱-串联质谱的检测方法。饲料样品加水分散后经4%(v/v)氨水乙腈提取,加入25 mg十八烷基硅烷(C18)和50mg N-丙基乙二胺(PSA)吸附剂分散固相萃取净化后,以高效液相色谱-串联质谱进行定性和定量分析。采用Agilent Zorbax Eclipse XDB-C18(50 mm×4.6 mm,1.8μm)分析柱,以甲醇-0.1%(v/v)甲酸水溶液为流动相进行梯度洗脱,串联质谱在多反应监测(MRM)正离子模式下进行检测,基质外标法定量。结果表明,18种待测物在质量浓度为5~200μg/L范围内线性关系良好,相关系数为0.9912~0.9995;在0.05、0.1、0.5 mg/kg 3个浓度加标水平下,饲料中18种β-兴奋剂的平均回收率为78.4%~107.1%,相对标准偏差(RSD)为3.5%~12.3%,定量限(以信噪比≥10计)均为0.05 mg/kg。该方法准确、灵敏,前处理简单,可作为饲料中克仑特罗等18种β-兴奋剂筛选和确认的检测方法。     

Integrating bimetallic AuPd nanocatalysts with a 2D aza-fused π-conjugated microporous polymer for light-driven benzyl alcohol oxidation

Efficient catalytic system with low energy consumption exhibits increasing importance due to the upcoming energy crisis.Given this situation,it should be an admirable strategy for reducing energy input by effectively utilizing incident solar energy as a heat source during catalytic reactions.Herein,aza-fused7 r-conjugated microporous polymer(aza-CMP)with broad light absorption and high photothermal conversion efficiency was synthesized and utilized as a support for bimetallic AuPd nanocatalysts in light-driven benzyl alcohol oxidation.The AuPd nanoparticles anchored on aza-CMP(aza-CM P/Au_xPdy)exhibited excellent catalytic performance for benzyl alcohol oxidation under 50 mW/cm^2 light irradiation.The improved catalytic performance by the aza-CMP/Au_xPdy is attributed to the unique photothermal effect induced by aza-CMP,which can promote the catalytic benzyl alcohol oxidation occurring at Au Pd.This work presents a novel approach to effectively utilize solar energy for conventional catalytic reactions through photothermal effect.     

Construction of Liposomes Mimicking Cell Membrane Structure through Frame‐Guided Assembly

The shape of eukaryotic cells is determined by the cytoskeleton associated with membrane proteins; however, the detailed mechanism of how the integral morphologies with structural stability is generated and maintained is still not fully understood. Here, based on the Frame‐Guided Assembly (FGA) strategy, we successfully prepared hetero‐liposomes with structural composition similar to that of eukaryotic cells by screening a series of transmembrane peptides as the leading hydrophobic groups (LHGs). It was demonstrated that the conformation and transmembrane mode of the LHGs played dominant roles during the FGA process. The FGA liposomes were formed with excellent stability, which may further provide evidence for the cytoskeleton–membrane protein–lipid bilayer model. Taking advantage of the biocompatibility and stability, the FGA liposomes were also applied to prepare novel drug delivery vehicles, which is promising in diagnostic imaging and cancer therapy applications.     

Modification of Adhesive and Latex Properties for Starch Nanoparticle‐Based Pressure Sensitive Adhesives

Starch nanoparticle (SNP)‐based pressure sensitive adhesives (PSAs) with core‐shell particle morphology (starch nanoparticle core/acrylic polymer shell) are produced via seeded, semi‐batch emulsion polymerization at 15 wt% SNP loading (relative to total polymer weight) and 40 wt% latex solids. Crosslinker and chain transfer agent (CTA) are introduced to the acrylic shell polymer formulation at a range of concentrations according to a 3² factorial design to tailor the latex and adhesive properties of SNP‐based latexes. The crosslinker and CTA show no significant effect on polymerization kinetics, particle size, and viscosity. Latex gel content is predicted using an empirical model, which is a function of crosslinker and CTA concentration. Both the gel content and glass transition temperature strongly affect the adhesive properties (tack, peel strength, and shear strength) of the SNP‐based latex films. 3D response surfaces for the adhesive properties are constructed to facilitate the design of SNP‐based PSAs with desired properties.     

成都平原典型地区水果-土壤重金属污染特征研究

为摸清成都平原土壤-水果系统中重金属污染水平和富集特征,通过对成都平原典型地区333个水果作物及其根部表层土壤中Hg、As、Pb、Cd、Cu、Cr和土壤理化指标的测定,结果表明：（1）研究区土壤养分整体呈现出有效磷和碱解氮较丰富,有机质和速效钾较缺乏的特征,可通过增施有机肥、地面覆草、施用绿肥等方式提升土壤肥力水平。（2）研究区土壤重金属存在部分点位超标,以Cd的超标率最高。土壤重金属单因子评价污染等级为清洁,土壤综合污染指数评价污染等级为中度污染,其主要贡献为Cd。研究区重金属存在一定程度的富集,Cd和Hg的污染指数高,潜在生态风险强,应重点关注土壤Cd污染和Hg含量水平的增加趋势,将Cd污染作为下一步土壤风险管控和修复治理的重点目标。（3）研究区水果Pb、Cd的超标率分别为5.7%、7.8%,不同水果Pb、Cd的超标率差异显著,草莓Cd的超标率最高。研究区水果中重金属未对成人构成非致癌健康风险,而水果中的As和Cu对儿童构成了非致癌健康风险,As和Cu对水果重金属非致癌总指数的贡献超过70%,应特别关注水果中As和Cu的管控,以免造成较大的食源性危害。（4）重金属在水果与土壤中的含量水平关联性较低,水果中重金属的含量与水果富集重金属的能力关联度极高,应进一步查明水果重金属与土壤重金属形态的关系,并结合调整水果种植结构、筛选重金属低积累水果品种等方式降低水果重金属的健康风险。