分子筛体系的氢溢出效应

分子筛体系的氢溢出效应李晓燕，盛太成，杨孔章（山东大学化学院，济南２５０１００）关键词铂／分子筛催化剂，氢溢出，程序升温脱附负载型金属催化剂的表面氢溢出效应近年来引起了人们的重视．人们采用不同的实验方法对此进行了广泛的研究，但对以分子筛为担体的负载型...     

Preparation and properties of aromatic polyamides from 5-t-butylisophthalic acid and various aromatic diamines

Aromatic polyamides (aramids) having pendant t-butyl group were synthesized by the direct polycondensation of 5-t-butylisophthalic acid with various aromatic diamines in N-methyl-2-pyrrolidone (NMP) using triphenyl phosphite and pyridine as condensing agents. The aramids having inherent viscosities of 0.6–2.4 dL/g were obtained in quantitative yields. These polymers were readily soluble in various solvents such as NMP,N,N-dimethylacetamide, dimethyl sulfoxide, and pyridine, and gave transparent, tough and flexible films by casting from the NMP solutions. The aramids had glass transition temperatures between 250 and 330°C, and started to lose weight around 350°C, with 10% weight loss being recorded at about 450°C in air.     

Microwave digestion and matrix separation for the determination of cadmium in urine samples by electrothermal atomization atomic absorption spectrometry using a fast temperature program

 A method is proposed which involves sample pretreatment followed by electrothermal atomic absorption spectrometry (ETAAS) for determination of cadmium in human urine. A microwave digestion system was devised to accommodate double-closed vessels for simultaneous digestion of batches of up to 24 urine samples in about 20 min. After digestion, matrix substances which might interfere were removed using silica-immobilized 8-hydroxyquinoline (I-8HOQ) columns. The analyte adsorbed on the column was then eluted with dilute nitric acid solution and determined by ETAAS using a fast temperature program. Neither ashing steps in the furnace heating program nor use of matrix modifiers was necessary. The accuracy, precision, limit of detection, and sample throughput of the method were evaluated. With meticulous control of systematic errors which may be introduced in the pretreatment procedures, the present method can serve as a reference technique for the analysis of Cd in urine samples. Received: 29 July 1996/Revised: 30 September 1996/Accepted: 13 October 1996     

Microwave digestion and matrix separation for the determination of cadmium in urine samples by electrothermal atomization atomic absorption spectrometry using a fast temperature program

 A method is proposed which involves sample pretreatment followed by electrothermal atomic absorption spectrometry (ETAAS) for determination of cadmium in human urine. A microwave digestion system was devised to accommodate double-closed vessels for simultaneous digestion of batches of up to 24 urine samples in about 20 min. After digestion, matrix substances which might interfere were removed using silica-immobilized 8-hydroxyquinoline (I-8HOQ) columns. The analyte adsorbed on the column was then eluted with dilute nitric acid solution and determined by ETAAS using a fast temperature program. Neither ashing steps in the furnace heating program nor use of matrix modifiers was necessary. The accuracy, precision, limit of detection, and sample throughput of the method were evaluated. With meticulous control of systematic errors which may be introduced in the pretreatment procedures, the present method can serve as a reference technique for the analysis of Cd in urine samples. Received: 29 July 1996/Revised: 30 September 1996/Accepted: 13 October 1996     

Direct determination of cadmium at parts-per-billion level in waters by derivative atomic absorption spectrometry using atom trapping technique

A method has been described for the direct determinations of trace cadmium using derivative atom trapping flame atomic absorption spectrometry with an improved water-cooled stainless steel trapping equipment. The characteristic concentration (gave a derivative absorbance of 0.0044) and detection limit (3sigma) of cadmium were 0.028 and 0.02 ng ml(-1) when collecting for a 1 min, respectively, which were 992 and 145-fold better than those of the conventional flame atomic absorption spectrometry. The detection limit and sensitivity of the proposed method for a 2 min collection time were 1 and 2 orders of magnitude higher than those of conventional flame atomic absorption spectrometry. The present method was applied to the determinations of cadmium in water samples with a recovery range of 91 approximately 111% and a relative standard deviation of 4.7 approximately 5.6%.     

LBL分子沉积法制备葡萄糖氧化酶电极

采用以静电力为主的逐层分子交替沉积技术制备葡萄糖氧化酶（GOD）电极.通过带有正电荷的聚二甲基二烯丙基铵盐酸盐（PDDA）和带有负电荷的GOD交替沉积在修饰有3-巯基-1-丙基磺酸钠（MPS）的金电极表面.以甲酸二茂铁为电子媒介体,用循环伏安法检测GOD电极对葡萄糖的响应.结果表明,当GOD电极组装层数小于4时,电流响应随着层数的增加而增大,超过4层时电流响应减小.其中4层GOD修饰电极的线性范围为0.55～6.63 mmol•L－1,当pH为7.0时,响应最大.同时电极的检测重现性能良好,相对标准偏差为2.4％.     

Synthesis, structural characterization and ferrimagnetic property of MnPS3 intercalated with nickel(II) cyclopolyamine complex cations

Two new intercalation compounds were prepared by the reactions of Ni(II) cyclopolyamine complex cations with a preintercalate Mn_1−xPS₃K_2x(H₂O)_y, respectively, through “ion exchange” process. Their structures were characterized by elemental analysis, X-ray powder diffraction and infrared spectroscopy. The lattice spacing increased 0.567 and 1.093 nm with respect to the pristine MnPS₃. Ferrimagnetism of the intercalates was confirmed by SQUID experiment with T_c at 40 and 33 K, respectively.     

Patterned langmuir-blodgett films of monodisperse nanoparticles of iron oxide using soft lithography

Langmuir-Blodgett (LB) films of monodisperse iron oxide nanoparticles have been successfully deposited onto patterned poly(dimethylsiloxane) surfaces. These patterned LB films of iron oxide nanoparticles were transferred onto solid substrates using micro contact printing.     

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

The performance of uspported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investgated.An evaluation of the catalysts indicates that bulk molybdenum carbied has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products.The rapid deactivation of the catalyst is also a significant problem.However,the supported molybdenum carbide catalyst shows a much higher methane conversion,increased selectivity and significantly improved catalytic stability.The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier.The bulk or the supported molybdenum carbide exists in the β-Mo2C phase,while it is transformed into molybdenum dioxide postcatalysis which is an improtant cause of molybdenum carbide deactivation.     

The thermodynamic model of inorganic arsenic species in aqueous solutions Potentiometric study of the hydrolitic equilibrium of arsenic acid

Protonation constants of arsenic acid were determined at different ionic strengths in NaClO(4) (0.1, 0.5, 1.0, 3.0 mol dm(-3)), NaCl (0.5 and 1.0 mol dm(-3)) and KCl (0.5, 1.0 and 3.0 mol dm(-3)) ionic media by means of a potentiometric study. The distribution of arsenate species was defined depending on two important variables in natural environments: pH and composition. All the experimentation was performed at 25 degrees C. The differences found in the protonation constants for different medium compositions, were explained by the different behaviour of the interaction parameters of the species considered in the different media and ionic strengths. These parameters were reported for all hydrolitic As(V) species and were calculated using the Modified Bromley's Methodology (MBM). The corresponding thermodynamic stepwise formation constants were also determined (log degrees K(1)=11.58+/-0.01, log degrees K(2)=7.06+/-0.01, log degrees K(3)=2.25+/-0.01). All the results obtained showed not only the importance of the ionic strength but also of the composition of the ionic medium on the distribution of the acid-base species of As(V) as a function of pH in natural waters.