Rational synthesis of covalently bonded organic-inorganic hybrids

Hybrid materials based on covalently linked inorganic polyoxometalates (POMs) and organic species containing a delocalized pi system have drawn increasing attention. These hybrids, traditionally prepared by cluster assembly approaches that lack predictability and controllability, can now be synthesized through common organic reactions by using organically functionalized POM clusters as building blocks. This minireview highlights some of the most recent advances on a particular type of hybrids where the organic and inorganic components are connected by an imido linkage.     

Thermal decomposition of the composite hydrotalcites of iowaite and woodallite

The thermal stability and thermal decomposition pathways for synthesized composite iowaite/woodallite have been determined using thermogravimetry analysis in conjunction with evolved gas mass spectrometry. Dehydration of the hydrotalcites occurred over a range of 56–70°C. The first dehydroxylation step occurred at around 255°C and, with the substitution of more iron(III) for chromium(III) this temperature increased to an upper limit of 312°C. This trend was observed throughout all decomposition steps. The release of carbonate ions as carbon dioxide gas initialised at just above 300°C and was always accompanied by loss of hydroxyl units as water molecules. The initial loss of the anion in this case the chloride ion was consistently observed to occur at about 450°C with final traces evolved at 535 to 780°C depending of the Fe:Cr ratio and was detected as HCl (m/z=36). Thus for this to occur, hydroxyl units must have been retained in the structure at temperatures upwards of 750°C. Experimentally it was found difficult to keep CO₂ from reacting with the compounds and in this way the synthesized iowaite-woodallite series somewhat resembled the natural minerals.     

河南贫煤不同温度燃烧烟气中环烃类产物的分析研究

本文用色谱／质谱／红外联用系统研究了河南贫煤在不同温度下燃烧释放的烟气二氯甲烷富集液中的脂环烃，苯系物，多环芳烃及杂多环芳烃等环烃类物的组成和差异，尤其是对多环芳烃的种类，含量及分布特征进行了较详细的探讨。并与原煤常温二氯甲烷浸取中各化合物组成进行了对照。     

LaNi4Fe催化合成氨反应性能的研究

用冶金法、还原扩散法、共沉淀法制得了LaNiFe,并对其催化合成氨反应性能进行了研究。实验结果表明:还原扩散法,共沉淀法制得的LaNi_4Fe催化活性均比冶金法好。X—射线分析指出LaNi_4Fe在合成氨反应过程中变为Ni_4Fe和LaN。     

Ni-SDC固体氧化物燃料电池阳极的合成和性质

采用柠檬酸-硝酸盐溶胶-凝胶低温自蔓延燃烧法制备氧化镍（NiO）粉末和Ce0.8Sm0.2O1.9（SDC）粉末，并将NiO与SDC按不同质量比和不同制备工艺制备了固体氧化物燃料电池（SOFC）的阳极前身。再用自组装的还原装置将其在820℃经2．5h还原后，采用四端子法测量其电导率值。分析了阳极片电导率与阳极片微结构、Ni的质量百分数、混合研磨时间及烧结温度之间的关系。结果显示，阳极片的电导率强烈依赖于镍含量和制备工艺。     

不同方法掺杂Au对纳米α-Fe2O3气敏性能的影响

分别采用共沉淀法、浸渍法、紫外辐照法制备了掺杂不同Au含量的α-Fe2O3纳米粉体,并制作了旁热式厚膜型气敏元件.用XRD、TG-DTA和TEM技术对纳米晶的晶型、晶粒大小及形貌进行了表征.考察了掺杂方法、Au含量及焙烧温度对α-Fe2O3气敏性能的影响.结果表明,采用三种方法掺杂适量Au后,都使α-Fe2O3的气敏性有了显著提高,其中采用共沉淀法,在400℃焙烧的Au质量分数为1.5%的α-Fe2O3的气敏性最佳.     

新型固液双重致孔球形离子交换剂的制备及其性能研究

以甲基丙烯酸缩水甘油酯为单体 ,采用固液联合致孔方式 ,通过一步悬浮聚合制备了一种新型双孔高分子球形载体 .经化学修饰后 ,得到含二乙胺羟丙基的阴离子交换剂 (介质A) .优化了制备条件 .并与用相同方法制备的但仅含有机溶剂致孔剂的介质B进行了比较 .介质A和B均具有较高的静态吸附容量和机械强度 .由于介质A内含有流动相可以对流通过的大孔 ,因此其动态吸附容量远高于介质B ,并且在较高的流速下表现出较好的色谱流动性能     

集化学家与化学教育家于一身的一代化学大师李比希--纪念李比希诞辰200周年

在德国著名化学家李比希诞辰200周年之际，对这位集化学家与化学教育家于一身的一代化学大师对科学和科学教育以及人类社会作出的贡献进行了评述。     

Mesoporous micelle templated silica with incorporated C<Subscript>8</Subscript> and C<Subscript>18</Subscript> phase

Mesoporous silica material of MCM-41 type was synthesized by co-condensation of highly concentrated octyltriethoxysilane (OTEOS), octadecyltriethoxysilane (ODTEOS) and tetraethoxysilane (TEOS). The obtained hybrid materials were characterized using XRD, TG-DSC and low temperature adsorption/desorption of nitrogen. It was shown that the applied method of synthesis allows to obtain silica of MCM-41 type with a high degree of hydrocarbon saturation.