烷基硫酸盐表面张力的量子化学研究

用AMl量子化学计算法优化了十三烷基硫酸根阴离子和——CH3在不同取代位的十二烷基硫酸根阴离子的几何构型，得到最优构型时最高占据分子轨道能级EHOMO、最低空轨道能级ELUMO、电子能量Eele和偶极矩μ等数据．将这些电子结构数据分别与表面张力相拟合，得到很好的相关性。文中讨论了——CH3在不同位置取代对表面张力的影响。     

Fuzzy convex sets in median algebras

The fuzzification of convex sets in median algebras is considered, and some of their properties are investigated. A characterization of finite valued fuzzy convex set is given.     

U：CaF2晶体的分凝特性与光谱性质

应用TGT法生长了直径为75mm的U：CaF2晶体，宏观上透明完整.应用公式K0=Cs/Cl计算了U在CaF2晶体中的分凝系数等于0.53.应用溶质分布一般公式Cs=K0C0(1-g)K0-1，计算U的浓度分布与测量值，数值符合说明晶体生长过程接近平衡状态.分析不同条件下生长的U: CaF2晶体的晶胞参数和吸收光谱，结果表明生长气氛决定U的价态及电荷补偿机理：无PbF2存在的条件下，U为+4价，晶体呈绿色；PbF2的加入起到氟化去氧作用，U倾向于以离子半径最接近于Ca2+的U3+存在，晶体呈红色.从晶体生长开始到结束的部位，U3+:CaF2晶体吸收光谱的峰位不变，峰强呈现与U浓度相同的增加趋势.U3+:CaF2晶体外层厚约5mm处呈黄色，含有U3+和U2+的混合价态离子，其原理是石墨坩埚的还原作用通过单质铅，使部分的U3+进一步还原成了U2+. 关键词： 铀 氟化钙晶体 分凝系数 晶胞参数     

液体CO2在毛细管内的质量流量及临界流实验研究

本文进行了液体CO2在长度为0.5～5.9 m,内径为0.7 mm和2.0 mm,入出口压差为2.2 MPa和2.5 MPa的毛细管内的质量流量及临界流的实验研究.实验结果表明液体CO2在毛细管中的质量流量随毛细管内径、入出口压差的增大而增大,随长度的增加而逐渐减小;结果同时表明液体CO2在毛细管中产生了临界流现象,临界流随毛细管内径的增大而增大.在实验基础上回归出了适用于本实验条件的液体CO2在毛细管内的质量流量经验关联式,具有一定的工程指导意义.     

推广的奇轮的圆色数

图G的圆色数(又称"星色数")xc(G)是Vince在1988年提出的,它是图的色数 的自然推广.本文由奇轮出发构造了一族平面图,并证明了此类图的圆色数恰恰介于2和 3之间,填补了该领域的空白.     

Efficient microwave induced direct α-halogenation of carbonyl compounds

A novel and direct method for the synthesis of α-halocarbonyl compounds using sequential treatment of carbonyl compounds with [hydroxy(tosyloxy)iodo]benzene followed by magnesium halides under solvent-free microwave irradiation conditions is described.     

The Iyengar Type Inequalities with Exact Estimations and the Chebyshev Central Algorithms of Integrals

In this paper, both low order and high order extensions of the Iyengar type inequality are obtained. Such extensions are the best possible in the same sense as that of the Iyengar inequality. hzrthermore, the Chebyshev central algorithms of integrals for some function classes and some related problems are also considered and investigated.     

The Analysis and Improving of the Microwave Exciter in the Lower Hybrid Wave System

When we carry out lower hybrid wave heating and current driving plasma experiment at tokamak, we need mega-watt order of microwave power. The microwave signal at frequency of 2450 MHz is generated by a microwave exciter. According to the experiment＇s demands, the microwave exciter must provide output power of 1.5～ 2. 5 W with stabilized frequency and amplitude tobe used as the klystron input. Being amplified by the klystron, the microwave signal is transmitted through the transmitting system to the antenna and is emitted into the HL-2A tokamak. So we can see that the microwave exciter＇s function is very important to the lower hybrid wave heating and current driving plasma experiment.     

Fabrication of Dendrimer－like PAMAM Based on Silica Nanoparticles

A G 4.0 dendrimer-like poly (amido amine) (PAMAM) based on silica nanoparticles was fabricated via a divergent approach.It was built from γ-aminopropyi silica nanoparfides (APSN) core via repetitive addition of acrylate (MA) and hexylenediamine (HDA). FT-IR and EA were used to monitor the progress of dendrimer during each step. The amino group content of the resulting product increased from 0.49 to 3.72 mmol/g after the 4th generation. In addition, the percentage of grafting increased with increasing generation and reached to 65.9% after 4th generation. It was found that the resulting silica nanoparticles could be dispersed in methanol with a mean hydrodynamic particle diameter of 152.7 nm although the silica nanoparticles had agglomerated during the storage period.