质子辐照硼硅酸盐玻璃盖片的物理效应分析

作为航天器电源系统的重要组成部分,太阳电池需要更高的转换效率和可靠性以及更长的使用寿命。通过在太阳电池表面覆盖抗辐照玻璃盖片,可以增强太阳电池对粒子辐射的防护,延长太阳电池的服役寿命,使航天器获得可靠的能源供应。硼硅酸盐玻璃就是一种理想的太阳电池玻璃盖片材料。采用蒙特卡罗方法,结合SRIM软件模拟研究质子辐照硼硅酸盐玻璃的损伤物理机理。基于粒子与物质相互作用的理论以及基本公式,通过分析不同入射能量的质子在硼硅酸盐玻璃中的阻止本领、电离能损、位移能损、空位的产生情况,对辐照损伤的物理机制进行研究。结果表明：能量为30～120 keV的质子辐照损伤主要发生在硼硅酸盐玻璃表面;质子沉积、空位分布等均为Bragg峰型分布;电离能损是能量损失的主要部分,随入射能量的增加而增大,导致电子的电离和激发;位移能损在玻璃内部随能量降低而增大,导致硼、氧和硅等空位缺陷的产生;电离效应和缺陷的产生是硼硅酸盐玻璃色心形成的重要原因。     

GaInP/GaAs/Ge三结太阳电池不同能量质子辐照损伤模拟

以GaInP/GaAs/Ge三结太阳电池为研究对象,开展了能量为0.7, 1, 3, 5, 10 MeV的质子辐照损伤模拟研究,建立了三结太阳电池结构模型和不同能量质子辐照模型,获得了不同质子辐照条件下的I-V曲线,光谱响应曲线,结合已有实验结果验证了本文模拟结果,分析了三结太阳电池短路电流、开路电压、最大功率、光谱响应随质子能量的变化规律,利用不同辐照条件下三结太阳电池最大输出功率退化结果,拟合得到了三结太阳电池最大输出功率随位移损伤剂量的退化曲线.研究结果表明,质子辐照会在三结太阳电池中引入位移损伤缺陷,使得少数载流子扩散长度退化幅度随质子能量的减小而增大,从而导致三结太阳电池相关电学参数的退化随质子能量的减小而增大.相同辐照条件下,中电池光谱响应退化幅度远大于顶电池光谱响应退化幅度,中电池抗辐照性能较差,同时中电池长波范围内光谱响应的退化幅度比短波范围更大,表明中电池相关电学参数的退化主要来源于基区损伤.     

Ka波段螺旋波纹波导回旋行波管

螺旋波纹波导回旋行波管与采用圆波导的回旋行波管相比,有较大的带宽。介绍了它的线性注波互作用理论,并用该理论计算了不同的磁场与波导表面微扰幅度对Ka波段螺旋波纹波导回旋行波管线性增益的影响。计算结果与已报道的实验结果基本符合,说明该理论可以初步确定螺旋波纹波导回旋行波管的各项参数。     

Investigation of luminescence properties in SiO2: Tb,Yb upconversion inverse opal

The SiO₂: Tb, Yb inverse opals with photonic band gap at 465 or 543 nm were prepared, and an effect of photonic band gap on upconversion spontaneous emission from Tb³⁺ was investigated. The results show that the photonic band gap has a significant influence on the upconversion emission of the SiO₂: Tb, Yb inverse opals. The upconversion luminescence of the Tb³⁺ ions is suppressed in the inverse opal compared with the luminescence of that of the reference sample.     

Analysis and optimization of a new photonic crystal filters in near ultraviolet band

Transmission characteristics of one-dimensional (1D) photonic crystals (PCs) heterostructures containing defective are studied using the transfer matrix method. The key is to search the best combination style for different 1D PCs to form heterostructures. It is shown that the non-transmission range over near ultraviolet and visible range can be substantially enlarged and the phenomenon of narrow band PC filter in near ultraviolet can be realized by adjusting the repeat cycle counts of various photonic crystals. The theoretical results on multiple heterostructures containing TiO₂/SiO₂ multilayer films are presented. With a perfect omni-directional and high peak transmission filters for TE modes, this structure opens a promising way to fabricate ultra-narrow band PC filters with wide non-transmission range in near ultraviolet and visible range.     

Surface modification of Mg2B2O5 whisker and its effect on the mechanical properties and thermostability of polycarbonate/Mg2B2O5w composites

The Mg₂B₂O₅ whiskers (Mg₂B₂O₅w) were modified by boric acid ester (BE) coupling agent and used to prepare polycarbonate (PC) composites. Surface wettability test and evaluation of dispersibility of BE-modified Mg₂B₂O₅w (BE-Mg₂B₂O₅w) in n-heptane were carried out by water contact angle measurement and polarizing microscopy, respectively. The surface chemical characteristics of BE-Mg₂B₂O₅w and estimation of the amount of tightly bonded organic modifier were examined by Fourier transform infrared spectrometry (FT-IR) and thermogravimetric analysis (TGA), respectively. The influence of BE-Mg₂B₂O₅w on the mechanical property, morphology and thermostability of PC composites was investigated by using universal testing machine, scanning electron microscopy (SEM), dynamic mechanical analysis (DMA) and TGA, respectively. It was found that BE was successfully grafted to the surface of Mg₂B₂O₅w, and the hydrophobic BE-Mg₂B₂O₅w leads to high ratio of adhesion work to interfacial tension between PC and BE-Mg₂B₂O₅w, and its better dispersibility in n-heptane. Furthermore, the incorporation of BE-Mg₂B₂O₅w into PC matrix resulted in higher tensile properties of PC/BE-Mg₂B₂O₅w than that of PC/Mg₂B₂O₅w composites and lower maximum weight loss rate than that of PC. The storage modulus of the PC/Mg₂B₂O₅w composites increased obviously as a function of whisker content, especially for the composites with BE-Mg₂B₂O₅w, but the T_g value changed little.     

Adsorption and manipulation of carbon onions on highly oriented pyrolytic graphite studied with atomic force microscopy

Carbon onions produced by DC arc discharge method were deposited on highly oriented pyrolytic graphite (HOPG) surface and their adsorption and manipulation was studied using an atomic force microscopy (AFM). Well-dispersed adsorption of carbon onions on HOPG surface was obtained and aggregations of onions were not observed. The van der Waals interaction between the onion and HOPG surface and that between two onions, were calculated and discussed using Hamaker's theory. The manipulation of adsorbed onions on HOPG surface was realized using the AFM in both the raster mode and the vector mode. The controllability and precision of two manipulation modes were compared and the vector mode manipulation was found superior, and is a useful technique for the construction of nano-scale devices based on carbon onions.     

The stability of Bose--Einstein condensates in a two-dimensional shallow trap

The stability of Bose--Einstein condensates (BECs) loaded into a two-dimensional shallow harmonic potential well is studied. By using the variational method, the ground state properties for interacting BECs in the shallow trap are discussed. It is shown that the possible stable bound state can exist. The depth of the shallow well plays an important role in stabilizing the BECs. The stability of BECs in the shallow trap with the periodic modulating of atom interaction by using the Feshbach resonance is also discussed. The results show that the collapse and diffusion of BECs in a shallow trap can be controlled by the temporal modulation of the scattering length.     

CoPt(FePt)-C纳米复合膜的结构与磁性

用磁过滤脉冲真空电弧沉积方法制备了CoPt(FePt) C纳米复合薄膜，并在不同温度下进行了退火处理，研究了薄膜中碳的含量以及退火温度对薄膜结构与磁性能的影响.制备态薄膜经过足够高的温度退火后，x射线衍射和磁力显微镜分析发现，在碳基质中生成了面心四方相的CoPt(FePt)纳米颗粒.对于特定组分为Co24Pt31C45和Fe43Pt35C22的薄膜，矫顽力以及颗粒尺寸都随退火温度的升高而增大，当退火温度为700℃时，Co24Pt31C45薄膜的矫顽力为21×105A/m，晶粒尺寸为17nm;当退火温度为650℃时，Fe43Pt35C22相应值分别为28×105A/m和105nm. 关键词： 磁记录材料 磁性薄膜 CoPt FePt纳米复合薄膜     

X-ray observations of tungsten wire array Z-pinch implosions on QiangGuang-1 facility

Z-pinch experiments with two arrays consisting, respectively, of 32 4-μm- and 6-μm-diameter tungsten wires have been carried out on QiangGuang-1 facility with a current rising up to 1.5MA in 80ns. At early time of implosion, x-ray framing images show that the initial emission comes from the central part of arrays, and double clear emission rings, drifting to the anode and the cathode at 5×10⁶cm/s and 2.4×10⁷cm/s respectively, are often produced near the electrodes. Later, in a 4-μm-diameter tungsten wire array, filamentation caused by ohmic heating is prominent, and more than ten filaments have been observed. A radial inward shift of arrays starts at about 30\,ns earlier than the occurrence of the x-ray peak power for both kinds of arrays, and the shrinkage rate of emission region is as high as 1.7×10⁷cm/s in a 4-μm-diameter tungsten wire array, which is two times higher than that in a 6-μm one. Emission from precursor plasmas is observed in implosion of 6-μm-diameter tungsten wire arrays, but not in implosion of a 4-μm-diameter tungsten wire array. Whereas, in a 4-μm-diameter tungsten wire array, the soft x-ray emission shows the growth of m=1 instability in the plasma column, which is caused by current. The reasons for the discrepancy between implosions of 4-μm- and 6-μm-diameter tungsten wire arrays are explained.