（PdCl2—PVP）／Al2O3催化剂中Pd状态的探讨

氯化钯先锚定在聚乙烯吡咯烷酮上后进一步负载到Al_2O_3上所制的催化剂[简称(PdCl_2-PVP)/Al_2O_3]是一种活性、选择性高,稳定性好的烯烃、二烯烃和多烯烃加氢催化剂。本文结合加氢反应,使用XPS、FT-IR、电镜及用CO为探针的FT-IR,对这种催化剂进行了考察。实验说明,在这种催化剂中,钯的价态是在0—2之间。红外光谱在486cm~(-1)处有一微弱的小峰,说明存在Pd—N的配位键。催化剂中钯含量低时(0.2wt％)稳定性好,不吸附CO,活性中心是络合钯原子;当钯含量较高时(0.7wt％),催化剂的初活性虽不低,稳定性却较差,这种催化剂能吸附CO,IR谱图上仅在1919cm~(-1)处有CO桥式吸附态的伸缩振动。表明除络合钯原子外,还有聚集的钯金属存在。FT-IR尚表明,PVP在Al_2O_3上可能并非单纯的物理吸附。电镜结果表明,PVP在Al_2O_3上呈30—70(?)的微球状,(PdCl_2-PVP)/Al)_2O_3上的(PdCl_2-PVP)亦呈微球状,与前者无明显区别,这种催化剂中其活性中心是络合钯原子。     

The Effects of M2O3 on Stabilizing Monocopper over the Surface of Cu-ZnO-M2O3 Catalysts for Mathanol Synthesis

The effects of M₃O₃ (M = Al, Sc etc.) in Cu-ZnO-M₂O₃ catalysts on methanol synthesis at low pressure were studied with ESR, XPS and TPR spectroscopy. The results of ESR showed that the generation of monovalent cationic defects was because the valence state and electronic charge on the ZnO lattice lost their balance as M³⁺ doped into ZnO. The induced effect by Sc³⁺ is stronger than that by Al³⁺. The results of XPS and TPR indicated that the amount and stabilization of Cu⁺ on the surface of reduced copper-based catalyst and its catalytic activity were affected by the monovalent cationic defects on the surface of ZnO.     

铝原子簇上化学吸附的尺度效应及其理论模型

对铝原子簇Al_n(n=1～10,12,13)已报导过的理论预测几何构型进行合理选择, 用量子化学CNDO/2法研究了单分子一氧化碳在这些簇上取不同吸附位形时的吸附作用。结果表明吸附强度随簇尺度的变化呈“幻数”特性: Al_2、Al_6、Al_(12)簇具有特别高的吸附能, 与实验观测结果相符。采用作者建议的推广电子壳模型可合理解释这一尺度效应。对Al_(12)和Al_(13)簇电子结构的分析进一步支持了壳模型的观点。随着簇的增大, 尺度效应逐步减弱并趋向于体相铝的性质。     

微相分离及链结构对聚酯-聚醚嵌段共聚物分子运动的影响

本文首先研究了成型方法和热处理对聚对苯二甲酸乙二酯与聚氧四亚甲基嵌段共聚物动态力学温度谱的影响,结合应力-应变曲线讨论了微相分离与力学性能的关系。其次,比较了三种不同链结构的聚酯-聚醚嵌段共聚物在不同温控程序下的动态力学温度谱,讨论了链结构对软链段结晶的影响。最后观察了聚氨酯-聚醚嵌段共聚物双重玻璃化转变现象并作了解释。     

电极条件对硫酸介质中电解还原提纯镱过程的影响

研究了以钌铱钛合金网和汞分别为阳、阴电极, 在无气氛保护条件下, 采用电解还原方法从铥、镱、镥硫酸盐溶液中分离提纯镱的过程. 讨论了在8 V恒电压时的电极间距、位置, 以及阴、阳极表面积对电解过程中的电流、还原率影响. 优化了电解还原过程, YbSO4产品的纯度稳定达到99.5%以上, 一次收率可达80%;提镱后母液中的铥和镥被富集4倍以上, 其中Lu含量高于50%, 十分有利于后续铥/镥分离.     

Agonist–PPARγ interactions: Molecular modeling study with docking approach

Docking simulation of 18 agonists with the ligand binding pocket (LBP) of PPARγ has been performed. The binding conformations and binding affinities of these agonists were obtained by use of the flexible docking protocol FlexX. Test compound calculations indicated that FlexX can reproduce the binding conformation of the crystal structure (root mean square deviation = 1.43 Å); moreover, the predicted binding affinities correlate well with the activities of these agonists. The interaction model and pharmacophore of PPARγ agonists were derived and the difference in biologic activities of these agonists can be well explained. The PPARγ agonists must have both polar head and the hydrophobic tail, which form hydrogen bonds and hydrophobic contacts with hydrophilic and hydrophobic regions of the LBP of PPARγ, respectively. In addition, a suitable linker is also necessary. © 2003 Wiley Periodicals, Inc. Int J Quantum Chem 93: 405–410, 2003     

煤微孔表面的分形维数及其变化规律的研究

本文利用气体吸附数据确定了各种煤阶煤（从褐煤到无烟煤）和煤焦气化反应过程中微孔表面的分形维数及其变化规律。这有助于进一步认识煤的孔结构特征。     

LBL分子沉积法制备葡萄糖氧化酶电极

采用以静电力为主的逐层分子交替沉积技术制备葡萄糖氧化酶（GOD）电极.通过带有正电荷的聚二甲基二烯丙基铵盐酸盐（PDDA）和带有负电荷的GOD交替沉积在修饰有3-巯基-1-丙基磺酸钠（MPS）的金电极表面.以甲酸二茂铁为电子媒介体,用循环伏安法检测GOD电极对葡萄糖的响应.结果表明,当GOD电极组装层数小于4时,电流响应随着层数的增加而增大,超过4层时电流响应减小.其中4层GOD修饰电极的线性范围为0.55～6.63 mmol•L－1,当pH为7.0时,响应最大.同时电极的检测重现性能良好,相对标准偏差为2.4％.     

Polystyrene-supported Benzyl Selenide: An Efficient Reagent for Highly Stereocontrolled Synthesis of Substituted Olefins

Solid-phase methodology has been rapidly and extensively applied to the preparation of small organic molecules recently1. It might be argued that selenoxide syn-elimination provided the principal impetus for the development of organoselenium chemistry. In addition, the required selenoxides are readily available from the oxidation of the corresponding selenides, which in turn can be prepared by the reaction of selenium-stabilized carbanions with various electrophilic substrates2. However, or…     

The first mu3-oxalato-bridged copper complex with tridentate Schiff base ligand N-ethyl-N'-salicylidene-1,2-diaminoethane: synthesis,structure, and magnetic properties

The first mu(3)-oxalato-bridged copper(II) complex, [[Cu(3)(L)(3)(mu(3)-C(2)O(4))][Cu(L)(H(2)O)](ClO(4))(2)] x 0.5(H(2)O) x 0.5(CH(3)OH), where HL = N-ethyl-N'-salicylidene-1,2-diaminoethane, has been synthesized and characterized by variable-temperature magnetic susceptibility measurement. The complex exhibits ferromagnetic coupling between the oxalato-bridged copper atoms and antiferromagnetic coupling between the oxygen-bridged copper atoms.