Electrochemical Behavior and Determination of Uric Acid at Single-Walled Carbon Nanotube Modified Gold Electrodes

The voltammetric behavior of uric acid was studied at a single-walled carbon nanotube (SWNT) modified gold electrode. Uric acid can effectively accumulate at this electrode and produce an anodic peak at about 0.45 V (vs. SCE) in pH 5.0 sodium acetate buffer solutions (HAc-NaAc). The experimental parameters, such as solution pH, accumulation time, and amount of SWNT, were optimized for determination. Under the optimum conditions, the anodic peak current is linear to the uric acid concentration over the range of 1.0×10⁻⁷ M to 2.5×10⁻⁵ M with a correlation coefficient of 0.998. The detection limit was 5.0×10⁻⁸ M for 60 s accumulation. The electrode could be easily regenerated and exhibited good stability. A 5.0×10⁻⁶ M uric acid solution was measured ten times using the same electrode, and the relative standard deviation of the peak current was 1.3%. This method was successfully applied to the determination of uric acid in human urine samples, and the recovery was 97–99%. The feasibility for simultaneous determination of xanthine, ascorbic acid and uric acid was discussed. These species did not interfere with each other in a certain concentration range. The influence of some surfactants on the anodic peak was also examined.     

Two New Steroidal Glycosides from Fermented Leaves of Agave americana

Two new spirostanol glycosides named agamenoside A and B, ere isolated from the fermented leaves of Agave americana. Their structures were elucidated as (23S,25R)-5α-spirostan-3β,6α，23－triol 3-O-α-L-rhamnopyranosyl-(1→3)-β-D-glucopyranosyl-(1→2)-[β-D-xylopyranosyl-(1→3)]-β-D-glucopyranosyl-(1→4)-β-D-galactopyranoside(1) and (25R)-5α-spiro-stan-3β,6α-diol 3-O-β-D-glucopyranosyl-(1→2)-[β-D-xylopyranosyl-(1→3)]-β-D-glucopyra-nosyl-(1→4)-β-D-galactopyranoside(2) by a combination of chemical and spectral methods.     

室温离子液体EMIES的标准生成焓

在(298.15 ±0.01) K下用转动弹热量计测定了离子液体硫酸乙酯-1-甲基-3-乙基咪唑(EMIES)及合成它的原料1-甲基咪唑的恒容燃烧热,通过计算得到它们的标准燃烧焓 分别为(－2671±2) 和(－286.3±0.5) kJ·mol－1;标准生成焓 分别为(－3060±3) kJ·mol－1和(－2145±4) kJ·mol－1.结合文献上硫酸二乙酯的标准生成焓数据,得到了合成离子液体EMIES的反应热(－102.3±1.0) kJ·mol－1,与合成实验中观察到的强烈放热现象是一致的.根据离子液体EMIES的热容数据,计算了不同温度下EMIES的标准生成焓.     

Two new megastigmane O-glucopyranosides from the leaves of Broussonetia papyrifera

Two new megastigmane O-glucopyranosides,named (2R,3R,5R,6S,9R)-3-hydroxy-5,6-epoxy-β-ionol-2-O-β-D-glucopyrano- side(1) and (2R,3R,5R,6S,9R)-3-hydroxyl-5,6-epoxy-acety-β-ionol-2-O-β-D-glucopyranoside(2) together with six known mega- stigmanes,were isolated from the leaves of Broussonetia papyrifera (Linn.) Vent.Their structures were established by chemical methods and spectroscopic techniques including 2D NMR.     

Low‐Temperature Facile Template Synthesis of Crystalline Inorganic Composite Hollow Spheres

This report presents a facile approach for the low‐temperature synthesis of crystalline inorganic‐oxide composite hollow spheres by employing the bulk controlled synthesis of inorganic‐oxide nanocrystals with polymer spheres as templates. The sulfonated polystyrene gel layer can adsorb the target precursor and induce inorganic nanocrystals to grow on the template in situ. The crystalline phase and morphology of the composite shell is tunable. By simply adjusting the acidity of the titania sol, crystalline titania composite hollow spheres with tunable crystalline phases of anatase, rutile, or a mixture of both were achieved. The approach is general and has been extended to synthesize the representative perovskite oxide (barium and strontium titanate) composite hollow spheres. The traditional thermal treatment for crystallite transformation is not required, thus intact shells can be guaranteed. The combination of oxide properties such as high refractive index, high dielectric constant, and catalytic ability with the cavity of the hollow spheres is promising for applications such as opacifiers, photonic crystals, high‐κ‐gate dielectrics, and photocatalysis.     

De novo sequencing of tryptic peptides sulfonated by 4-sulfophenyl isothiocyanate for unambiguous protein identification using post-source decay matrix-assisted laser desorption/ionization mass spectrometry

A simple method of solid-phase derivatization and sequencing of tryptic peptides has been developed for rapid and unambiguous identification of spots on two-dimensional gels using post-source decay (PSD) matrix-assisted laser desorption/ionization (MALDI) mass spectrometry. The proteolytic digests of proteins are chemically modified by 4-sulfophenyl isothiocyanate. The derivatization reaction introduces a negative sulfonic acid group at the N-terminus of a peptide, which can increase the efficiency of PSD fragmentation and enable the selective detection of only a single series of fragment ions (y-ions). This chemically assisted method avoids the limitation of high background normally observed in MALDI-PSD spectra, and makes the spectra easier to interpret and facilitates de novo sequencing of internal fragment. The modification reaction is conducted in C(18) microZipTips to decrease the background and to enhance the signal/noise. Derivatization procedures were optimized for MALDI-PSD to increase the structural information and to obtain a complete peptide sequence even in critical cases. The MALDI-PSD mass spectra of two model peptides and their sulfonated derivatives are compared. For some proteins unambiguous identification could be achieved by MALDI-PSD sequencing of derivatized peptides obtained from in-gel digests of phosphorylase B and proteins of hepatic satellite cells (HSC).     

Fingerprint quality control of Tianjihuang by high-performance liquid chromatography-photodiode array detection

A novel, simple and accurate fingerprint method was developed using high-performance liquid chromatography-photodiode array detection (HPLC-DAD) for the quality control of Hypericum japonicum thunb (Tianjihuang), a Chinese herbal medicine used for the treatment of several bacterial diseases, infectious hepatitis, gastrointestinal disorder, internal hemorrhage and tumors. For the first time, the feasibility and advantages of employing chromatographic fingerprint were investigated and demonstrated for the evaluation of Tianjihuang by systematically comparing chromatograms with a professional analytical software recommended by State Food and Drug Administration (SFDA). Our results revealed that the chromatographic fingerprint combining similarity evaluation could efficiently identify and distinguish raw herbs of Tianjihuang from different sources. The effects resulted from collecting locations, harvesting time and storage time on herbal chromatographic fingerprints were also examined.     

CBS法合成光学活性二茂铁基醇

以非天然氨基酸合成的手性β-氨基醇(4a～4c)为催化剂，用于不对称硼烷还原反应来合成光学活性的二茂铁基醇(1a～1e)，对映体过量值高达96%。     

Effects of organic solvents on the structure stability of TS-1 for the ammoximation of cyclohexanone

The effects of organic solvents on the ammoximation of cyclohexanone to cyclohexanone oxime with H₂O₂and NH₃ over TS-1 were studied. To investigate the effects of ammonia and organic solvents on the structure stability of the catalyst, TS-1 samples were pretreated under severe conditions in ammonia solution or ammonia solution plus methanol, toluene or t-butanol, respectively, and then characterized bySEM, XRD, FTIR, etc. The results revealed that t-butanol is the best solvent for the ammoximation reaction; ammonia tends to destroy the active sites, -Ti-O-Si- structure in TS-1, but the presence of organic solvents remarkably limits this damaging effect of ammonia.     

Extraction and detection of arsenicals in seaweed via accelerated solvent extraction with ion chromatographic separation and ICP-MS detection

An accelerated solvent extraction (ASE) device was evaluated as a semi-automated means of extracting arsenicals from ribbon kelp. The effect of the experimentally controllable ASE parameters (pressure, temperature, static time, and solvent composition) on the extraction efficiencies of arsenicals from seaweed was investigated. The extraction efficiencies for ribbon kelp (approximately 72.6%) using the ASE were fairly independent (< 7%) of pressure, static time and particle size after 3 ASE extraction cycles. The optimum extraction conditions for the ribbon kelp were obtained by using a 3 mL ASE cell, 30/70 (w/w) MeOH/H2O, 500 psi (1 psi = 7 KPa), ambient temperature, 1 min heat step, 1 min static step, 90% vol. flush, and a 120 s purge. Using these conditions, two other seaweed products produced extraction efficiencies of 25.6% and 50.5%. The inorganic species present in the extract represented 62.5% and 27.8% of the extracted arsenic. The speciation results indicated that both seaweed products contained 4 different arsenosugars, DMA (dimethylarsinic acid), and As(V). One seaweed product also contained As(III). Both of these seaweed products contained an arsenosugar whose molecular weight was determined to be 408 and its structure was tentatively identified using ion chromatography-electrospray ionization-mass spectrometry/mass spectrometry (IC-ESI-MS/MS).