A high sensitivity spectrometer with tunable diode laser for ambient methane monitoring

Tunable diode laser absorption spectroscopy (TDLAS) has been widely employed in atmospheric trace gases detection. In the measurement of these trace gases, harmonic detection combined with a multi-pass white cell could remarkably enhance the detection sensitivity. In this paper, a portable TDLAS system built specifically for long time monitoring methane in the atmosphere is introduced. The detection limit is below 100 ppb that is enough for the monitoring of ambient methane, and the long time monitoring results obtained in Beijing are given, which is well coincident with that of the Fourier transform infrared (FTIR) spectroscopy.     

煤粉再燃对600 MW锅炉NOx排放的影响

在国内某台燃用褐煤的600 MW机组锅炉上进行了煤粉再燃技术示范并进行了工业试验.机组在600 MW负荷下运行时,NOx排放可控制在274 mg/m3(烟气中氧量折算到6%,下同)的水平,比改造前下降了65.36%,同时燃烧效率没有降低.进行了常规通风、空气分级和煤粉再燃三个工况下的试验,结果表明,煤粉再燃对NOx的控制效果最好,其次为空气分级.再燃煤粉比例对NOx排放也有明显的影响,在试验条件下,随着再燃燃料比例的增加,NOx排放呈降低趋势.     

ICP-MS法测定不同采收时间宽叶荨麻中微量元素含量

采用微波消解,ICP-MS法分析不同采收时间宽叶荨麻中18种微量元素Al,Ba,Ca,Co,Cr,Cu,Fe,K,Li,Mg,Mn,Mo,Na,Ni,P,Pb,S和Zn的含量。该方法的相对标准偏差在1.2%～5.3%之间,加标回收率在95.4%～101.2%之间。结果表明宽叶荨麻中K,P,S,Ca,Na含量较高;Fe,Mg,Mn,Zn含量次之;有潜在生理毒性的元素Al,Cr,Pb的含量较低,并且在宽叶荨麻中微量元素呈现明显的季节性动态变化,此结果为进一步研究宽叶荨麻药理药效与微量元素的关系以及更好的开发这一资源提供理论数据。     

吸附制冷中化学吸附的滞后圈研究

文中通过对活性炭-氨以及氯化钙-氨的对比试验,对氯化钙-氨化学吸附的滞后圈进行了研究,结果表明, 化学吸附的滞后现象非常严重,已经超出了气-固吸附的Zigmondy、McBain以及Cohan模型所能解释的范围。对化学吸附的Claperon图进行研究,发现吸附床冷却及加热过程中存在着一段等压冷却以及加热过程,这两个过程与吸附滞后圈相对应。对此现象进行分析,结果表明化学吸附的滞后圈形成原因主要与络合物的稳定常数以及吸附特性相关。     

第九讲光速减慢和光缓存技术

高速光信号的存储是光信息科学的重要分支,全光缓存器是当今高速光信号处理的瓶颈.本文介绍了全光缓存器的研究进展,着重介绍了光速减慢的原理、物理基础, 以及在半导体量子点中利用电磁诱导透明效应发展全光缓存器的思路.     

Thermally switchable and discretely tunable comb filter with a linearly chirped fiber Bragg grating

We propose and experimentally demonstrate a novel switchable and discretely tunable comb filter based on a thermally induced linearly chirped fiber Bragg grating. Experimentally we achieved a thermally induced optical bandpass filter that has eight switchable passband peaks with peak separations of 1.6 and 3.2 nm, a very narrow bandwidth (as small as 10 pm) of each peak, a tunable range of 16.5 nm, and a greater than 25 dB rejection ratio. Two spectral peaks separated by only 0.8 nm were also obtained with this comb filter. This filter provides the unique advantages of an all-fiber structure, switchable spectral peaks, independent tuning of the center wavelength and wavelength spacing of the spectral peaks, low polarization sensitivity, simple structure, ease of fabrication, and low cost.     

N = 4 Supersymmetric Morse Oscillator and Its Spectrum-Generating Algebra

In this paper N = 4 supersymmetry of generalized Morse oscillators in one dimension is studied. Both bound states and scattering states of its four superpartner Hamiltonians are analyzed by using unitary irreducible representations of the noncompact Lie algebra su(1,1). The spectrum-generating algebra governing the Hamiltonian of the N = 4 supersymmetric Morse oscillator is shown to be connected with the realization of Lie superalgebra osp(1,2)or B(0,1) in terms of the variables of a supersymmetric two-dimensional harmonic oscillator.     

Effect on Intensity Correlation Time by Input Signal in a Single-Mode Laser with Bias Signal Modulation

The effect on intensity correlation time T by input signal is studied for gain-noise model of a single-mode laser driven by colored pump noise and colored quantum noise with colored cross-correlation with a bias signal modulation in this paper. By using the linear approximation method, we detect that there exists maximum (i.e., resonance) in the curve of the intensity correlation time T upon bias-current i0 when the noise correlation coefficient λ is positive; and there exists minimum (i.e., suppression) in the T-i0 curve when λ is negative. And when λ is zero, T increases monotonously with increasing i0. Furthermore, the curve of T upon the signal frequency Ω is also studied. Our study shows that no matter what the value ofλ is, there exists minimum (i.e., suppression) in the T-Ω curve.     

Spectral emissivity of type E235B low carbon structural steel with different roughnesses

A self-built experimental apparatus was employed to study the spectral emissivity of type E235B low carbon structural steel in the wavelength range 2–15 μm at different temperatures by energy comparison method. The surface roughness and topography of the steel E235B were determined by a roughness tester and a scanning electron microscopy, respectively. And then, the spectral emissivity of steel E235B with six different roughnesses was measured before and after oxidation. The measurement results showed that the spectral emissivity increased with the increasing temperature and surface roughness before oxidation. The effect of roughness on the spectral emissivity is different at different wavelength and temperature ranges. However, the oscillatory behavior of the spectral emissivity was observed after oxidation. To explore the possible reasons for emissivity variation, the changes of surface roughness and optical roughness were investigated after oxidation. It is found that both the surface roughness and optical roughness increased after oxidation. Although the optical roughness can be used as one of the parameters to evaluate the effect of surface roughness on the spectral emissivity, it is insufficient to describe the effect of surface morphology on the spectral emissivity.