Bager第五图的完善

１９８９年发表的Ｂａｇｅｒ第五图，包含关于三角形元素的３５个二次规范画数之间的５１个不等式通过细致的分析，本文给出了其中遗漏的１２个基本不等式     

Separation of screw-sensed particles in a homogeneous shear field

The Stokes motions of three-dimensional screw-sensed slender particles in a homogeneous shear field are investigated, including the effects of buoyancy. Conclusions are drawn about the possibility of achieving a separation of mixtures of right- and left-handed particles. The linearity of the Stokes equations allows complex flows to be solved by adding the effects of the several terms which describe the flow in which the particle is immersed. The homogeneous shear flow considered here consists of three such terms; solutions for a series of 12 unit motions are sufficient to determine the hydrodynamic resistance tensors. The forces and torques experienced by screw-sensed particles are calculated from these 51 resistance tensors, using slender-filament theory. The results allow an estimate of the range of buoyancy parameters for which gravitational sedimentation can be neglected. The fundamental component of the particle motion is a rotation, at approximately the same angular velocity as that of the fluid. Superimposed on this are variations, of large period, in the particle orientation. A phase plane analysis is used to find the terminal orientations. Very long calculation times are required for the phase portrait. An approximate method based on azimuthally-averaged equations is developed to avoid the requirements for long time integration.     

The inclusion of electrostatic and dispersion interactions into potentials of mean torque for solutes dissolved in uniaxial liquid crystal solvents

A potential of mean torque is derived for a solute at infinite dilution in a uniaxial liquid crystal solvent, which contains terms originating from the dispersion interaction, and the electrostatic interaction between quadrupole moments on both molecules. It is shown that the electrostatic term is non-zero only if the solute-solvent vectors are distributed with lower than spherical symmetry. If this distribution has cylindrical symmetry then both the electrostatic and dispersion terms in the potential of mean torque are shown to depend on order parameters for the orientational distribution of the solute-solvent vectors, as well as on the order parameters of the solvent molecules.     

Spontaneous photorefractive effect in Sr1−x CaxTiO3 (x=0.014)

The temperature dependence of the principal values of the refractive index in Sr_1−x Ca_xTiO₃ (x=0.014) has been measured in the 17–275 K range under various conditions of sample illumination with 1.96 eV photons. The spontaneous photorefractive contribution δn ^ph to the temperature-induced variation of the refractive index of Sr_1−x Ca_xTiO₃, which appears after illumination of the sample in the ferrophase (transition temperature T _c=32 K) and persists in the paraphase under heating up to 150 K, has been separated. The photoinduced polarization has been estimated. Fiz. Tverd. Tela (St. Petersburg) 39, 711–713 (April 1997)     

Interface analysis of the system Si/YBa2Cu3O7?x

Summary The influence of different preparation conditions and substrate surface orientations on the superconducting properties of thin YBa₂Cu₃O_7–x (YBCO) films on silicon was studied. Comparative electrical and surface spectroscopic measurements were performed. SAM and SIMS depth profile analysis show an enrichment of barium at the interface between the superconductor and silicon for samples with T_c<76 K. Comparison with XPS data obtained for thin silicon films on YBCO indicates the formation of barium and yttrium silicates at the interface under these conditions.     

III-V compound semiconductor (001) surfaces

There has been renewed interest in the structure of III-V compound semiconductor (001) surfaces caused by recent experimental and theoretical findings, which indicate that geometries different from the seemingly well-established dimer models describe the surface ground state for specific preparation conditions. I review briefly the structure information available on the (001) surfaces of GaP, InP, GaAs and InAs. These data are complemented with first-principles total-energy calculations. The calculated surface phase diagrams are used to explain the experimental data and reveal that the stability of specific surface structures depends largely on the relative size of the surface constituents. Several structural models for the Ga-rich GaAs (001)(4×6) surface are discussed, but dismissed on energetic grounds. I discuss in some detail the electronic properties of the recently proposed cation-rich GaAs (001)ζ(4×2) geometry. Received: 18 May 2001 / Revised version: 23 July 2001 / Published online: 3 April 2002     

Numerical analysis of time-dependent Boussinesq models

In this paper we analyse numerical models for time-dependent Boussinesq equations. These equations arise when so-called Boussinesq terms are introduced into the shallow water equations. We use the Boussinesq terms proposed by Katapodes and Dingemans. These terms generalize the constant depth terms given by Broer. The shallow water equations are discretized by using fourth-order finite difference formulae for the space derivatives and a fourth-order explicit time integrator. The effect on the stability and accuracy of various discrete Boussinesq terms is investigated. Numerical experiments are presented in the case of a fourth-order Runge-Kutta time integrator.