Discovery of a new long-lived isomeric state in 125Ce

A new long-lived isomeric state in the near proton dripline nucleus ¹²⁵Ce has been identified with Schottky mass spectrometry at GSI. The excitation energy E ^* = 103(12)keV and the decay time of 193(1)s have been obtained from a single stored fully ionized ^125m Ce⁵⁸⁺ ion. The data implies an E3 transition and a 1/2⁺ assignment for the spin of the isomer.     

高精度CCD尺寸自动检测系统的光学系统设计

介绍测量精度为±０．００３ｍｍ的ＣＣＤ尺寸检测系统的光学系统设计特点及远心物镜设计原理，并给出了测试结果。     

Cr^4＋：YAG,Cr^4＋：Mg2SiO4近红外荧光辐射温度特性研究

测量了Ｃｒ＾４＋，ＹＡＧ、Ｃｒ＾４＋，Ｍｇ２ＳｉＯ４晶体在室温和液氮温度下的荧光光谱，吸收光谱和激发态寿命，讨论了温度变化时，两种晶体中Ｃｒ＾４＋近红外辐射积分强度变化与激光发态寿命变化的关系，得出结论：在７７Ｋ￣３００Ｋ范围内，Ｃｒ＾４＋的＾３Ｔ２能级荧光辐射截面本身受温度影响不大，Ｃｒ＾４＋辐射荧光的变化，主要是由无辐射弛豫速率随温度变化而引起的。     

Simplified analytic solutions and a novel fast algorithm for Yb-doped double-clad fiber lasers

In this paper, continuous wave Yb³⁺-doped double-clad fiber lasers (DCFLs) with linear-cavity are investigated theoretically and numerically using the rate equations. Under the steady state conditions, the simplified analytic solutions of Yb³⁺-doped DCFLs under considering the scattering loss are deduced in the strongly pump condition. Compared with the known analytic solutions in published literatures, our analytic solutions are more accurate, especially, at higher reflectivity of output mirror. In addition, a fast and stable algorithm based on the Newton-Raphson method is proposed to simulate numerically Yb³⁺-doped DCFLs. The results by simplified analytic solutions are in good agreement with those by the numerical simulation. Moreover, we have performed the optimization of an Yb³⁺-doped DCFL using the simplified analytic solutions and the numerical simulations, respectively.     

由大学多媒体教学实践所引发的深入思考

多媒体技术是物理教学良好的辅助工具，多媒体技术的应用为大学物理教学开辟了一片广阔天地。它能大大增加物理教学的信息量，图形形象直观、生动活泼，有着传统教学无法比拟的优势，但是，多媒体技术使用不当也会给物理教学带来一些负面影响。     

水雾化制备Fe74Al4Sn2P10C2B4Si4非晶合金粉末及其磁粉芯性能研究

采用水雾化方法制备Fe7Al4Sn2P10C2B4Si4合金粉末,研究发现该合金具有强的非晶形成能力和高热稳定性,在粉末粒度小于400目时可以形成非晶态合金.采用该非晶粉末制备的磁粉芯在高频下品质因数显著高于MPP粉芯,说明该磁粉芯高频损耗较低.分析表明,非晶合金磁粉芯高频下损耗低的主要原因是电阻率较高.     

Surface free energy of CrNx films deposited using closed field unbalanced magnetron sputtering

CrN_x thin films have attracted much attention for semiconductor IC packaging molding dies and forming tools due to their excellent hardness, thermal stability and non-sticking properties (low surface free energy). However, few data has been published on the surface free energy (SFE) of CrN_x films at temperatures in the range 20-170 °C. In this study CrN_x thin films with CrN, Cr(N), Cr₂N (and mixture of these phases) were prepared using closed field unbalanced magnetron sputtering at a wide range of Cr⁺² emission intensity. The contact angles of water, di-iodomethane and ethylene glycol on the coated surfaces were measured at temperatures in the range 20-170 °C using a Dataphysics OCA-20 contact angle analyzer. The surface free energy of the CrN_x films and their components (e.g., dispersion, polar) were calculated using the Owens-Wendt geometric mean approach. The influences of CrN_x film surface roughness and microstructure on the surface free energy were investigated by atomic force microscopy (AFM) and X-ray diffraction (XRD), respectively. The experimental results showed that the lowest total SFE was obtained corresponding to CrN at temperature in 20 °C. This is lower than that of Cr(N), Cr₂N (and mixture of these phases). The total SFE, dispersive SFE and polar SFE of CrN_x films decreased with increasing surface temperature. The film roughness has an obvious effect on the SFE and there is tendency for the SFE to increase with increasing film surface roughness.