合成香料β-大马酮的高效液相色谱分析

本文提出了用分析型HPLC仪器制备β-大马酮标准品的方法及用HPLC测定β-大马酮含量的方法。制备色谱柱为Zorbax SIL 9.4 mmφ×25cm,流动相为石油醚(30～60℃)/乙醚98.5/1.5。分析用色谱柱为Shim CLC SIL 6 mmφ×15cm(岛津全多孔硅胶柱),流动相为石油醚(60—90℃)/无水乙醇99.88/0.12,检测器为紫外可见分光光度检测器。波长253nm或302nm,标准曲线的线性范围0～1.4mg/ml。峰高或峰面积均可用于测定,回收率100.7%。     

Study of transition metal oxide doped LaGaO3 as electrode materials for LSGM-based solid oxide fuel cells

Transition metal oxide doped lanthanum gallates, La_0.9Sr_0.1Ga_0.8M_0.2O₃ (where M=Co, Mn, Cr, Fe, or V), are studied as mixed ionic-electronic conductors (MIECs) for electrode applications. The electrochemical properties of these materials in air and in H₂ are characterized using impedance spectroscopy, open cell voltage measurement, and gas permeation measurement. Three single cells based on La_0.9Sr_0.1Ga_0.8 Mg_0.2O₃ (LSGM) electrolyte (1.13 to 1.65 mm thick) but with different electrode materials are studied under identical conditions to characterize the effectiveness of the lanthanum gallate-based MIECs for electrode applications. At 800 °C, a single cell using La_0.9Sr_0.1- Ga_0.8Co_0.2O₃ as the cathode and La_0.9Sr_0.1Ga_0.8Mn_0.2O₃ as the anode shows a maximum power density of 88 mW/cm², which is better than that of a cell using Pt as both electrodes (20 mW/cm²) and that of a cell using La_0.6Sr_0.4CoO₃ (LSC) as the cathode and CeO₂-Ni as the anode (61 mW/cm²) under identical conditions. The performance of LSGM-based fuel cells with MIEC electrodes may be further improved by reducing the electrolyte thickness and by optimizing the microstructures of the electrodes through processing. Received: 9 January 1998 / Accepted: 1 May 1998     

双核金属酞菁类化合物催化脱硫机理研究Ⅳ──中心金属离子对MPc－PcM催化活性的影响

实验研究结果表明双核金属酞菁类化合物ＭＰｃ－ＰｃＭ（Ｍ＝Ｖ、Ｃｒ、Ｍｎ、Ｆｅ、Ｃｏ、Ｎｉ、Ｃｕ）是催化Ｈ＿２Ｓ液相氧化反应的良好催化剂，且其催化活性顺序为Ｃｏ＞Ｎｉ＞Ｖ＞Ｆｅ＞Ｃｕ＞Ｃｒ＞Ｍｎ．采用量子化学理论计算方法（ＩＮＤＯ／Ｓ）分析了其前线分子轨道的构成特征，结果表明这几种ＭＰｃ－ＰｃＭ的ＬＵＭＯ轨道皆为有金属离子参与形成的π轨道，但ＨＯＭＯ轨道间的差异却很大．Ｍ＝Ｃｏ、Ｎｉ、Ｃｕ、Ｃｒ时，其ＨＯＭＯ为π轨道；而Ｍ＝Ｆｅ、Ｍｎ时，其ＨＯＭＯ却为σ轨道．正是在前线分子轨道的轨道类型、共轭程度及金属轨道贡献三方面因素的协同作用下，才导致ＭＰｃ－ＰｃＭ的催化活性顺序并非按中心金属离子价电子层ｄ电子数的递变而呈现出规律性的变化．     

Detection of metalloproteins in human liver cytosol by synchrotron radiation X-ray fluorescence combined with gel filtration chromatography and isoelectric focusing separation

Synchrotron radiation X-ray fluorescence (SRXRF) spectroscopy is an advanced method of quantitative multielemental analysis with space resolution of several microm and sensitivities in the microg g(-1) range. It can be used for keeping track of trace elements after an electrophoretic separation of biological samples. In this paper, proteins in human liver cytosol were separated with gel filtration chromatography and thin layer isoelectric focusing (IEF). The contents of metal ions in protein bands were determined by SRXRF. The results showed that in the molecular weight (MW) range of 10 approximately 25 kDa, there were at least 2 Zn-containing bands with isoelectric point (pI) of 5 approximately 6 and 6.2 approximately 7, respectively and about 11 Fe-containing proteins with pI of 4.4, 4.6, 4.8, 5.0, 5.2, 5.3, 5.5, 5.6, 6.6, 6.8, and 7.2, respectively, present in human liver cytosol. The Zn-containing band with pI of 5-6 is the dominant species of zinc in this MW range. In addition, the Cu-containing bands with pI of 5.0 and below 4.8 were also detected. It is demonstrated that the procedure could be widely used in further investigations of the chemical species of trace elements in biological samples.     

Organosoluble and transparent polyimides derived from alicyclic dianhydride and aromatic diamines

Organosoluble polyimides were synthesized with the alicyclic dianhydride 1,8‐dimethylbicyclo[2,2,2]oct‐7‐ene‐2,3,5,6‐tetracarboxylic dianhydride and aromatic diamines. The polyimides possessed good solubility both in strong dipolar solvents and in common solvents; the thermal decomposition temperature of the polyimides exceeded 420 °C. Strong and flexible films of the polyimides, with the cutoff of ultraviolet–visible absorption lower than 310–320 nm, exhibited good features as the alignment layers for nematic liquid crystals with pretilt angles of 1.5–2.9°. © 2001 John Wiley & Sons, Inc. J Polym Sci Part A: Polym Chem 40: 110–119, 2002     

Experimental and modeling study on decomposition kinetics of methane hydrates in different media

The decomposition kinetic behaviors of methane hydrates formed in 5 cm3 porous wet activated carbon were studied experimentally in a closed system in the temperature range of 275.8-264.4 K. The decomposition rates of methane hydrates formed from 5 cm3 of pure free water and an aqueous solution of 650 g x m(-3) sodium dodecyl sulfate (SDS) were also measured for comparison. The decomposition rates of methane hydrates in seven different cases were compared. The results showed that the methane hydrates dissociate more rapidly in porous activated carbon than in free systems. A mathematical model was developed for describing the decomposition kinetic behavior of methane hydrates below ice point based on an ice-shielding mechanism in which a porous ice layer was assumed to be formed during the decomposition of hydrate, and the diffusion of methane molecules through it was assumed to be one of the control steps. The parameters of the model were determined by correlating the decomposition rate data, and the activation energies were further determined with respect to three different media. The model was found to well describe the decomposition kinetic behavior of methane hydrate in different media.     

Fluoro-substituted DPP-bisthiophene conjugated polymer with azides in the side chains as ambipolar semiconductor and photoresist

Photoresists are essential for the fabrication of flexible electronics through all-photolithographic processes. Single component semiconducting photoresist exhibits both semiconducting and photo-patterning properties, and as a result, the device fabrication process can be simplified. However, the design of semiconducting polymeric photoresist with ambipolar semiconducting property remains challenging. In this paper, we report a single component semiconducting photoresist (PFDPPF4T-N₃) by incorporating azide groups and noncovalent conformation locks into the side alkyl chains and conjugated backbones of a diketopyrrolopyrrole-based conjugated polymer, respectively. The results reveal that PFDPP4FT-N₃ exhibits ambipolar semiconducting property with hole and electron mobilities up to 1.12 and 1.17 cm² V^?1 s^?1, respectively. Moreover, field effect transistors with the individual photo-patterned thin films of PFDPPF4T-N₃ also show ambipolar semiconducting behavior with hole and electron mobilities up to 0.66 and 0.80 cm² V^?1 s^?1, respectively. These results offer a simple yet effective design strategy for high-performance single component semiconducting photoresists, which hold great potential for flexible electronics processed by all photolithography.

     

特征线法在求解非线性液相吸附色谱模型中的应用

本文应用特征线法求解非线性液相吸附色谱分离过程模型，论述了特征线法的原理和步骤，讨论了时间步长和空间步长对模型数值解的影响，并用色谱分离甘露醇和山梨醇以及分离蔗糖和还原糖的实验进行验证，用特征线法计算的理论流出曲线与实验流出线吻合较好。本文还分折了模型中各个参数的灵敏度，结果表明：吸附等温方程Q＝Ci*／（ai＋biCi*）中参数ai比参数bi以及总传质系数ki有更高的灵敏度。     

Optical detection of triggered atherosclerotic plaque disruption by fluorescence emission analysis

Fluorescence emission analysis (FEA) has proven to be very sensitive for the detection of elastin, collagen and lipids, which are recognized as the major sources of autofluorescence in vascular tissues. FEA has also been reported to detect venous thromboemboli. In this paper we have tested the hypothesis that FEA can reproducibly detect in vivo and in vitro triggered plaque disruption and thrombosis in a rabbit model. Fluorescence emission (FE) spectra, recorded in vivo, detected Russell's viper venom (RVV)-induced transformation of atherosclerotic plaque. FE intensity at 410-490 nm 4 weeks after angioplasty was significantly lower (P < 0.0033 by analysis of variance) in RVV-treated rabbits when compared to control animals with stable plaque. FE spectral profile analyses also demonstrated a significant change in curve shape as demonstrated by polynomial regression analysis (R2 from 0.980 to 0.997). We have also demonstrated an excellent correlation between changes in FE intensity and the structural characteristics detected at different stages of "unstable atherosclerotic plaque" development using multiple regression analysis (R2 = 0.989). Thus, FEA applied in vivo is a sensitive and highly informative diagnostic technique for detection of triggered atherosclerotic plaque disruption and related structural changes, associated with plaque transformation, in a rabbit model.