Identification and quantification of major species of arsenic in rice

A study was undertaken to develop a method for the chemical speciation of As in rice on the basis of current knowledge in this field for use in preparing a certified reference material (CRM). Samples of the Arborio rice variety were ground to a fine powder, which was extracted under sonication with a water-methanol mixture (1 + 1, v/v). The resulting solutions were injected into a high-performance liquid chromatograph combined on-line with a quadrupole inductively coupled plasma-mass spectrometer. This hyphenated system allowed for the quantification of As species in one analytical step. Four forms of As were detected: inorganic As (III), dimethylarsinic acid (DMA), monomethylarsonic acid (MMA), and inorganic As (V) at concentrations of 88.2 +/- 7.1, 50.8 +/- 5.0, 15.2 +/- 1.7, and 51.2 +/- 3.5 ng/g, respectively. The concentration of total As was 211 +/- 7 ng/g. The limits of detection (3sigma criterion) and the quantitation (10sigma criterion) were, respectively, as follows (in ng/g): As (III), 0.095 and 0.320; As (V), 0.082 and 0.273; MMA, 0.110 and 0.367; and DMA, 0.145 and 0.480. Ten hours were needed for the extraction procedure, 6 h for the evaporation, and 30 min for quantification of the analytes. This investigation was performed in the frame of a European Commission Project on the feasibility of CRMs for As and Se species.     

Potential energy surface and rovibrational states of the ground Ar-HI complex

A potential energy surface for the ground electronic state of the Ar-HI van der Waals complex is calculated at the coupled-cluster with single and double excitations and a noniterative perturbation treatment of triple excitations [CCSD(T)] level of theory. Calculations are performed using for the iodine atom a correlation consistent triple-zeta valence basis set in conjunction with large-core Stuttgart-Dresden-Bonn relativistic pseudopotential, whereas specific augmented correlation consistent basis sets are employed for the H and Ar atoms supplemented with an additional set of bond functions. In agreement with previous studies, the equilibrium structure is found to be linear Ar-I-H, with a well depth of 205.38 cm(-1). Another two secondary minima are also predicted at a linear and bent Ar-H-I configurations with well depths of 153.57 and 151.57 cm(-1), respectively. The parametrized CCSD(T) potential is used to calculate rovibrational bound states of Ar-HI/Ar-DI complexes, and the vibrationally averaged structures of the different isomers are determined. Spectroscopic constants are also computed from the CCSD(T) surface and their comparison with available experimental data demonstrates the quality of the present surface in the corresponding configuration regions.     

Vibrational Stark Effects on Carbonyl, Nitrile, and Nitrosyl Compounds Including Heme Ligands, CO, CN, and NO, Studied with Density Functional Theory

Changes in the matrix electric field in a protein, due for example to mutations or structural fluctuations, can be correlated with changes in the vibrational transition frequencies of suitable chromophores measured by IR spectroscopy through the Stark tuning rate. To make this correlation, the Stark tuning rate must be known from experiment or theory. In this paper, density functional theory at the B3LYP/TZV level of theory is used to compute the Stark tuning rate of adducts of heme porphyrin, namely, -CO, -CN, and -NO+ compounds. The results are compared with the corresponding vibrational frequencies-field dependencies from vibrational Stark spectroscopy of heme-proteins. The zero-field computed Stark tuning rate of 1.3 cm-1/MV/cm for heme-CO is in agreement with experiment, where typically the rate is 2.4/f cm-1/MV/cm for myoglobin, where f is a local field correction between 1.1 and 1.4. Several small nitrile, carbonyl, and dinitrile molecules were studied to rationalize the findings for the heme-adducted models. Here, the higher B3LYP/6-311++G(2d,2p) level of theory could be used so the agreement with recent experimental results is even better than for heme-adducted groups.     

Assigning the C-15 configuration of 15-hydroxy-, 15-methoxy-, 15-ethoxy-hexahydrofurofuran neoclerodane diterpenoids

Examination of ¹H and ¹³C NMR spectra allows the establishment of rules for assigning the correct configuration at C-15 of 15-hydroxy-, 15-methoxy-, 15-ethoxy-hexahydrofurofuran neoclerodane diterpenoids. The structure of several diterpenoids has been assigned or ammended.     

Diazoniapentaphenes. Synthesis from pyridine‐2‐carboxaldehyde and structural verifications

Reactions of pyridine‐2‐carboxaldehyde (9) with α,α′‐dibromo‐o‐ and p‐xylenes led to the corresponding bis‐pyridinium aldehydes 10 and 14. These aldehydes were quite reactive and the respective hydrates 11 and 15 were also formed. Cyclization of 10 or 11 with 48% HBr led to 12 while cyclization with PPA followed by conversion to the bis tribromide and loss of bromine led to 1. Cyclization of 14 or 15 with 48% HBr led to 3. Attempts to react α,α′‐dibromo‐m‐xylene with pyridine‐2‐carboxaldehyde (9) were not successful for the preparation of the bis‐pyridinium aldehyde 13. The bis‐pyridinium acetals 4, 5 and 6 were prepared and cyclized to afford 1, 2 and 3 , respectively, by the previously reported procedures. The structures of 1 and 2 were verified by ¹H‐NMR and ¹³C‐NMR spectroscopy while that of 3 was confirmed by X‐ray analysis.     

A study on the essential oil of Ferulago campestris: How much does extraction method influence the oil composition?

The essential oil of different parts of Ferulago campestris (Bess.) collected in Sicily has been extracted by microwave-assisted hydrodistillation (MAHD) and by classic hydrodistillation (HD). A comparative qualitative-quantitative study on the composition of the oils was carried out. A total of 100 compounds were identified in the oils obtained by MAHD, whereas 88 compounds characterized the HD oils. The most prominent components were, in all different parts of F. campestris and in both extraction methods, 2,4,5-trimethylbenzaldehyde and 2,4,6-trimethylbenzaldehyde isomers; the latter was not previously found. The attempt to evaluate where the oil components are located in all parts of the plant was carried out by means of a kinetic study. Then, electron microscopy observation on the different parts before and after MAHD and HD was performed.     

Hydrocarbons from synthesis gas; effect of Mg addition over Pd impregnated silica-alumina catalysts

The effect of Mg addition to Pd impregnated silica-alumina catalysts and the behavior of these catalysts in synthesis gas to hydrocarbons transformation have been studied. Measurements of H₂ chemisorption and temperature programmed NH₃ desorption allow us to consider that Mg addition to Pd containing catalysts increases the Pd dispersity, the support acidity not being modified. The presence of Mg enhances hydrocarbon production. Meanwhile, the hydrocarbon distribution is not modified. A large amount of light alkanes in the reaction products is obtained.     

Anthemis wiedemanniana essential oil prevents LPS-induced production of NO in RAW 264.7 macrophages and exerts antiproliferative and antibacterial activities in vitro

Anthemis wiedemanniana is known in folk medicine for the treatment of microbial infections, cancer and also urinary and pulmonary problems. In this study, the chemical composition of the essential oil from A. wiedemanniana was evaluated and its antibacterial activity was tested against 10 bacterial strains. The oil was also tested for its potentiality to inhibit nitric oxide production in RAW 264.7 macrophages and for its cytotoxicity against four human cancer cell lines. A. wiedemanniana oil, rich of oxygenated monoterpenes (25.4%), showed a good antibacterial activity against Gram-positive bacteria and a good activity against the two Gram-negative bacteria, Escherichia coli and Proteus vulgaris. Besides that, it exhibited a high inhibitory effect on the LPS-induced nitrite production and a strong cytotoxic activity, especially against amelanotic melanoma (C32) and large lung cell carcinoma (COR-L23) cell lines.     

Surface-initiated synthesis of poly(3-methylthiophene) from indium tin oxide and its electrochemical properties

Poly(3-methylthiophene) (P3MT) was synthesized directly from indium tin oxide (ITO) electrodes modified with a phosphonic acid initiator, using Kumada catalyst transfer polymerization (KCTP). This work represents the first time that polymer thickness has been controlled in a surface initiated KCTP reaction, highlighting the utility of KCTP in achieving controlled polymerizations. Polymer film thicknesses were regulated by the variation of the solution monomer concentration and ranged from 30 to 265 nm. Electrochemical oxidative doping of these films was used to manipulate their near surface composition and effective work function. Doped states of the P3MT film are maintained even after the sample is removed from solution and potential control confirming the robustness of the films. Such materials with controllable thicknesses and electronic properties have the potential to be useful as interlayer materials for organic electronic applications.     

Surfactant (bi)layers on gold nanorods

Gold nanorods in aqueous solution are generally surrounded by surfactants or capping agents. This is crucial for anisotropic growth during synthesis and for their final stability in solution. When CTAB is used, a bilayer has been evidenced from analytical methods even though no direct morphological characterization of the precise thickness and compactness has been reported. The type of surfactant layer is also relevant to understand the marked difference in further self-assembling properties of gold nanorods as experienced using 16-EO(1)-16 gemini surfactant instead of CTAB. To obtain a direct measure of the thickness of the surfactant layer on gold nanorods synthesized by the seeded growth method, we coupled TEM, SAXS, and SANS experiments for the two different cases, CTAB and gemini 16-EO(1)-16. Despite the strong residual signal from micelles in excess, it can be concluded that the thickness is imposed by the chain length of the surfactant and corresponds to a bilayer with partial interdigitation.