THE CONTROL BY PHYTOCHROME OF NITRATE REDUCTASE IN THE CURD OF LIGHT-GROWN CAULIFLOWER

Abstract— The activity of nitrate reductase from the curd of light-grown cauliflower ( Brassica oleracea (L) var botrytis (DC) 'St. Hilary') is modulated by nitrate and by light. Using broad-band sources of equal photosynthetically active radiation but with different proportions of red and far-red light, a linear relationship between nitrate reductase activity and ψ(Estimated phytochrome photoequilibrium) was obtained. This relationship, apparent after 8 h incubation, was maintained and little altered after 48 h incubation. The linearity was apparent between ψE 0.26 and ψE 0.69; ψE 0.26 being no more effective than a dark control. Far-red reversibility confirmed the involvement of phytochrome. Brief pulses of red light were also used to establish a range of phytochrome photoequilibria within the tissue. Again a linear relationship between ψ and nitrate reductase activity was obtained with a threshold for the response at ψ 0.3. With both monochromatic and broad-band sources it was seen that neither photon fluence rate nor duration of exposure affected the final activity of the enzyme and that phytochrome was acting solely through ψ (or [Pfr] since phytochrome is stable in this tissue) to bring about these responses.     

Products of the reaction of H2Os3(CO)10 with cyclonona-1,2diene

Treatment of H₂Os₃(CO)₁₀ with cyclonona-l,2-diene produced HOs₃(CO)₉C₉H₁₃ and Os₂(CO)₆(C₉H₄)₂. Single crystal X ray analysis has shown that the latter is not isostructural with Fe₂(CO)₆(C₉H₁₄)₂.     

Vacancy contents and phase equilibria of Ti-substituted MnZn ferrite

Measurement of the divalent iron content in acid dissolved MnZn ferrites, fired in controlled atmospheres at various temperatures and quenched, allows calculation of cation vacancy contents. Addition of Ti⁴⁺ to these ferrites resulted in the introduction of vacancies at the rate of about 0 to 0.3 per Ti⁴⁺ depending on heat treatment conditions. Data are presented whereby the vacancy content with Ti⁴⁺ can be calculated based on the oxygen content of the undoped ferrite as available in the literature. Ti⁴⁺ stabilizes the hexagonal hematite-like structure and the phase boundary is presented as a function of Ti⁴⁺ and temperature. The vacancy contents at the phase boundary in Ti⁴⁺-doped ferrite as a function of temperature are in agreement with those calculated from the literature for undoped MnZn ferrites. Finally, the total oxygen content of coexisting spinel and hexagonal phases is presented.     

Adsorption of CF4 on the internal and external surfaces of opened single-walled carbon nanotubes: a vibrational spectroscopy study

Infrared spectroscopy has been used to make the first experimental discrimination between molecules bound by physisorption on the exterior surface of carbon single-walled nanotubes (SWNTs) and molecules bound in the interior. In addition, the selective displacement of the internally bound molecules has been observed as a second adsorbate is added. SWNTs were opened by oxidative treatment with O(3) at room temperature, followed by heating in a vacuum to 873 K. It was found that, at 133 K and 0.033 Torr, CF(4) adsorbs on closed SWNTs, exhibiting its nu(3) asymmetric stretching mode at 1267 cm(-1) (red shift relative to the gas phase, 15 cm(-1)). Adsorption on the nanotube exterior is accompanied by adsorption in the interior in the case of opened SWNTs. Internally bound CF(4) exhibits its nu(3) mode at 1247 cm(-1) (red shift relative to the gas phase, 35 cm(-1)). It was shown that, at 133 K, Xe preferentially displaces internally bound CF(4) species, and this counterintuitive observation was confirmed by molecular simulations. The confinement of CF(4) inside (10,10) single-walled carbon nanotubes does not result in the production of lattice modes that are observed in large 3D ensembles of CF(4).     

Generic serial and parallel on-line direct-injection using turbulent flow liquid chromatography/tandem mass spectrometry

The development of turbulent flow chromatography (TFC) has enabled considerable growth in the utility of on-line direct-injection technologies. TFC has now become established in a large number of varied analytical environments, particularly drug discovery/pharmacokinetics, metabolite profiling, combinatorial library purification, pre-clinical and clinical GLP applications. The utility of turbulent flow technology for in-house pre-clinical and clinical quantitative applications has necessitated extensive valve-cleaning procedures, and consequently lengthy cycle-times, to effectively remove the system carry-over. In-house requirements for assay validation require carry-over less than 20% of the lowest level of quantification (LLOQ), corresponding to 0.02% carry-over for a linear calibration range incorporating 3 orders. A generic turbulent flow chromatography protocol has been developed for drug discovery that incorporates polymeric turbulent flow extraction (cyclone) with C18-based reverse-phase chromatography. Further, multiple wash steps are incorporated within the methodology to meet in-house requirements for carry-over. Selection of novel switching-valve materials based on polyarylethyl ketone (PAEK) and Hastelloy/Valcon E autosampler injection hardware has enabled us to significantly impact the cycle-time required to reduce carry-over. Consequently, optimal usage of switching valves has enabled parallel operation for a generic on-line direct-injection methodology to successfully reduce the total cycle-time. Overall reductions from 4 min per sample to 90 s per sample are shown with comparable data quality using a proprietary target molecule from 0.1-100 ng/mL. This paper describes the hardware configuration and methodologies utilized to perform generic serial and parallel on-line direct-injection using a Turboflow HTLC 2300 system.     

Ligand field transitions in PtCl2−4 calculated by the SCF Xα scattered-wave method

The SCF Xα SW method can be used to obtain uniquely all the multiplets arising from the d → d transitions in the square planar metal complex PtCl^2?₄. The agreement with the experimental absorption spectrum and the singlet transition assignments in the region ≈ 3.0–4.5 eV is excellent.     

Synthesis of monofluorinated 1-(naphthalen-1-yl)piperazines

A series of regioisomerically monofluorinated 1-(naphthalen-1-yl)piperazines is described.     

N-Heterocyclic carbene–carbodiimide (NHC–CDI) betaine adducts: synthesis,characterization, properties,and applications

N-Heterocyclic carbenes (NHCs) are an important class of reactive organic molecules used as ligands, organocatalysts, and σ-donors in a variety of electroneutral ylide or betaine adducts with main-group compounds. An emerging class of betaine adducts made from the reaction of NHCs with carbodiimides (CDIs) form zwitterionic amidinate-like structures with tunable properties based on the highly modular NHC and CDI scaffolds. The adduct stability is controlled by the substituents on the CDI nitrogens, while the NHC substituents greatly affect the configuration of the adduct in the solid state. This Perspective is intended as a primer to these adducts, touching on their history, synthesis, characterization, and general properties. Despite the infancy of the field, NHC–CDI adducts have been applied as amidinate-type ligands for transition metals and nanoparticles, as junctions in zwitterionic polymers, and to stabilize distonic radical cations. These applications and potential future directions are discussed.

N-heterocyclic carbene-carbodiimide betaine adducts are zwitterionic amidinate-like structures with tunable properties that have applications as ligands, junctions in supramolecular polymers, and stabilizers for radical cations.     

Evaluation of VIDAs Immuno-concentration Salmonella assay Plus selective plate method (Hektoen enteric,bismuth sulfite,Salmonella identification) for detection of Salmonella in selected foods: collaborative study

The VIDAS Immuno-concentration Salmonella (ICS) plus selective plate method (Hektoen enteric, bismuth sulfite, Salmonella identification) method for the detection of Salmonella was compared to the Bacteriological Analytical Manual (BAM)/AOAC culture method in a collaborative study. Thirty-two laboratories participated in the evaluation. Each laboratory tested one or more of the 6 test products: milk chocolate, nonfat dry milk, dried whole egg, soy flour, ground black pepper, and ground raw turkey. The 2 methods were in agreement for 1,283 of the 1,440 test samples. Of the 157 test samples not in agreement, 82 were VIDAS ICS plus selective plate-positive and BAM/AOAC-negative, and 75 were VIDAS ICS plus selective plate-negative and BAM/AOAC-positive.