温梯法Al2O3晶体位错形貌分析

用温度梯度法(Temperature Gradient Technique,简称温梯法或TGT法),定向籽晶[0001]方向,生长出φ110mm×80mm Al2O3单晶,晶体完整、透明.采用硼酸钠玻璃液作为Al2O3晶体的化学抛光和化学腐蚀剂,观察了晶体不同部位处(0001)、(112-0)晶片的化学腐蚀形貌相,(0001)切片的位错腐蚀坑呈三角形,位错密度为2×103～3×103/cm2;(112-0)切片位错腐蚀坑呈菱形,位错密度为7×103～8×103/cm2;而且等径生长部位的完整性比放肩处高.利用同步辐射X射线白光衍射实验分析了(0001)晶片的(2-021),(11-01)和(112-0)衍射面内的位错组态.确定了两组位错线的Burgers矢量,温梯法生长的Al2O3晶体中的位错主要是刃型位错.     

Direct observation of director fields of disclinations in the nematic mesophase of a main chain thermotropic aromatic polyester by surface microcrack decoration

For a main chain thermotropic aromatic polyester with a flexible spacer, Cr 194 N 245 I (°C), the director fields around disclinations in the nematic mesophase can be decorated by both the solidification-induced band texture and surface microcracks. Director fields of various types of disclinations, including inversion walls, in the nematic mesophase of this semi-rigid polyester have been observed directly by polarizing optical microscopy. It was found that when the polymer was pre-sheared in the nematic state and then quenched to room temperature, a shear-induced band texture was observed, which relaxed slowly during annealing at 200°C, and then on quenching the solidification-induced band texture and surface microcracks appeared, displaying the pattern of the disclination fields. Pre-shearing is a necessary condition for the appearance of microcracks. On annealing, disclinations of various types were generated, quite often connected by inversion walls in the direction of pre-shearing. In some areas of the specimen where the shear-induced bands had not been completely relaxed during annealing, the shear-induced band texture was shown by the birefringence and surface microcracks to have a supermolecular structure of sinusoidal chain fibrils.     

哒嗪—碘电荷转移复合物的导电性

本文制备了哒嗪-碘电荷转移复合物,导电率达1—10~2S/cm。使之与碘混合在碘含量达98％时,仍具有1S/cm的导电率。用电压端短路法测量导电率的温度依赖性,发现在室温—-30℃导电率升高20％,在-30—100℃间导电率下降为室温时的-10％或更小。还报道了元素分析、x射线光电子能谱及激光拉曼光谱的数据。     

A COMPARISON OF POLYACETYLENES PREPARED WITH VARIOUS CATALYST SYSTEMS

A comparison of polyacetylenes (PA) prepared with rare earth(Ln) and titanium(Ti) basedcatalyst systems in regard to the isomerization rate, conductivity and doping behaviour is presented.It is found that PA synthesized with Ln-catalyst showed the lower isomerization rate than Ti-PA.Room temperature conductivity of I_2-doped Ln-PA is higher than that of Ti-PA under the sameconditions, this might related to the uniform conjugation length of Ln-PA. The difference in thedoping behaviors was observed for cis and trans PA films. and the complicated doping behavioursof cis-PA could be attributed to the simultaneously occurring isomerization reaction during doping.     

ACOUSTIC EMISSION DURING STRETCHING OF POLYMERS

Acoustic emission has been studied for a wide range of polymers including amorphous glasses, semi-crystalline polymers, copolymers, polymer blends and a crosslinked rubber during the course of uni-axial stretching at room temperature. For non-crystalline polymers acoustic emission occurred in rather small number of events accompanied by crazing and micro-crack formation. Strong acoustic activity appeared during yielding and necking of crystalline polymers. Rather small number or none of acoustic bursts occurred during the initial stage of neck drawing but numerous strong bursts appeared when drawing proceeded approaching specimen break. Specimens of the same polymer but of different fabrication history may be reflected in their acoustic emission behavior. Acoustic emission during stretching crosslinked polybutadiene rubber was very weak but observable when the force-elongation curve started to deviate from the linear region. No Kaiser effect was observed for the rubber. Very strong and numerous acoustic emission was observed during stretching specimens of polymer blends. High impact resistant polymer modifications showed no sharp increase of acoustic activity before specimen break. So long as the polymer and conditions of specimen fabrication are the same quite reproducible acoustic emission behavior could be observed.     

DETERMINATION OF PERMEATION PROPERTIES OF GAS THROUGH POLYMER MEMBRANE BY GAS CHROMATOGRAPHY

An apparatus constructed for measuring permeation properties of polymer membranes using a mixture of gases is described. A gas chromatographic system was applied to determine the individual transport characteristics of component gases without a vacuum line. This paper also discusses some experimental factors effecting the precision of measurement. The results show that there is a linear relationship between the permeation time and the volume of the gas permeated through the membrane within certain permeation period, which depends on the permeation rate (from 10~(-4) to 10~(-7) cm~3 (STP)/cm~2. sec. cmHg) of the membrane. The reproducibility has been found to be good with a relative standard deviation of 3.5%. This method is more sensitive, considerably faster and more convenient for determining both the permeability coefficient and the separation factor of a polymer membrane from a chromat ogram using mixed penetrant gases.     

FOURIER TRANSFORM INFRARED STUDIES OF POLY (ETHYLENE TEREPHTHALATE) FILM IN THE GLASS TRANSITION REGION

Three specimens from a solution-cast poly (ethylene terephthalate) (PET) film, one being liquid-N_2 quenched from 92℃(Q), one being slowly cooled from 92℃(SC) and one being quenched and sub-T_g annealed at 67℃(AN), have been studied by specimen difference spectra Q-SC and AN-Q and temperature difference spectra T-70 and T_2-T_1 for every 2℃steps on heating to 90℃at 2℃/min. SC and AN showed more gauche conformers than Q. That means that the PET chain has more trans conformers at higher temperatures and some of these are frozen during quenching through T_g. A band at 1340 cm~(-1) has been found to be complex containing overlapping bands reflecting trans in crystalline regions and trans in amorphous regions. The temperature difference spectra on heating through T_g showed that the spectral changes in Q are gradual while a rather abrupt change occurs in AN at 80—82℃for the bands at 1340, 1042 and 1020 cm~(-1). No new conformational structure or new vibrational mode is involved. A kind of locking mechanism is suggested which hinders the molecular vibrational changes in AN below T_g until a sudden release occurs at T_g. These locking sites can be nothing else than sites of tighter local packing of chain segments. Consequently it is believed that inter-chain van der Waals attraction energy plays a dominating role in the volume relaxation and sub-T_g annealing of quenched amorphous polymers.     

主链型高分子液晶向列相向错观察的进展

综述了主链型高分子液晶向列相向错在实验观察方面的进展。从纹影织构的观察和展曲、弯曲弹性常数相等条件下的二维曲率弹性理论出发探讨了向错结构的几何特征。简要涉及了弹性常数不相等对向错的影响、向错核心的本质和反转墙的观察;给出了拓扑强度s高达4的高阶向错的实验观察结果;归纳出描绘向错周围指向矢场的主要实验方法:1)片晶装饰;2)条带织构装饰;3)表面微裂纹装饰。本文对上述方法进行了讨论和比较,列举了一些电子显微镜和光学显微镜照像的图例。     

Aryl C-H amination by diruthenium nitrides in the solid state and in solution at room temperature: experimental and computational study of the reaction mechanism

Diruthenium azido complexes Ru(2)(DPhF)(4)N(3) (1a, DPhF = N,N'-diphenylformamidinate) and Ru(2)(D(3,5-Cl(2))PhF)(4)N(3) (1b, D(3,5-Cl(2))PhF = N,N'-bis(3,5-dichlorophenyl)formamidinate) have been investigated by thermolytic and photolytic experiments to investigate the chemical reactivity of the corresponding diruthenium nitride species. Thermolysis of 1b at ~100 °C leads to the expulsion of N(2) and isolation of Ru(2)(D(3,5-Cl(2))PhF)(3)NH(C(13)H(6)N(2)Cl(4)) (3b), in which a nitrogen atom has been inserted into one of the proximal aryl C-H bonds of a D(3,5-Cl(2))PhF ligand. A similar C-H insertion product is obtained upon thawing a frozen CH(2)Cl(2) solution of the nitride complex Ru(2)(DPhF)(4)N (2a), formed via photolysis at -196 °C of 1a to yield Ru(2)(DPhF)(3)NH(C(13)H(10)N(2)) (3a). Evidence is provided here that both reactions proceed via direct intramolecular attack of an electrophilic terminal nitrido nitrogen atom on a proximal aryl ring. Thermodynamic and kinetic data for this reaction are obtained from differential scanning calorimetric measurements and thermal gravimetric analysis of the thermolysis of Ru(2)(D(3,5-Cl(2))PhF)(4)N(3), and by Arrhenius/Eyring analysis of the conversion of Ru(2)(DPhF)(4)N to its C-H insertion product, respectively. These data are used to develop a detailed, experimentally validated DFT reaction pathway for N(2) extrusion and C-H functionalization from Ru(2)(D(3,5-Cl(2))PhF)(4)N(3). The diruthenium nitrido complex is an intermediate in the calculated reaction pathway, and the C-H functionalization event shares a close resemblance to a classical electrophilic aromatic substitution mechanism.