亚临界CO2冷库制冷系统性能实验研究

为研究亚临界CO₂冷库制冷系统性能,建立制冷系统压缩机数学模型,分析压缩机吸气温度对输气量、容积效率等性能参数的影响。搭建亚临界CO₂冷库制冷系统试验台,分析储液器出口气、液质量比对系统性能的影响。结果表明,当吸气压力恒定时,吸气温度升高,压缩机实际输气量及容积效率均有小幅度提升。随着储液器出口气、液质量比增大,系统制冷量及压缩机功耗均升高,而系统COP呈先增大后减小的趋势。在气、液质量比为0.16时,COP达到最大值为1.95。     

Optimal partial regularity for sub-elliptic systems with sub-quadratic growth in Carnot groups

This paper is devoted to partial regularity for weak solutions to nonlinear sub-elliptic systems for the case 1<m<2 under natural growth conditions in Carnot groups. The method of A-harmonic approximation introduced by Simon and developed by Duzaar, Grotowski and Kronz is adapted to our context, and then partial regularity with the optimal local Hölder exponent for horizontal gradients of weak solutions to the systems is established.     

Ca2Li2BiV3O12∶Eu3+荧光粉的制备和发光性能

采用高温固相法成功合成了一种可用于白光LED的Ca₂Li₂BiV₃O₁₂∶Eu³⁺新型红色荧光粉,使用X射线衍射仪和荧光分光光度计对合成样品进行了表征,研究了合成温度和Eu³⁺含量对合成样品相组成和发光性能的影响。结果表明,采用高温固相法在650~700 ℃能合成纯度较高、结晶度好的Ca₂Li₂BiV₃O₁₂∶Eu³⁺荧光粉,合成样品激发带覆盖200~400 nm,发射光谱的线状发射峰可归属于Eu³⁺的⁵D₀→⁷F_J(J= 1, 2, 3,4)特征锐线发射,Eu³⁺摩尔分数为14%时荧光粉的发光强度最大。     

忽地笑鳞茎中总生物碱含量的月动态变化

采用紫外分光光度法测定了不同月份忽地笑鳞茎中总生物碱含量,为确定适宜的采收时间提供实验依据。结果表明,忽地笑鳞茎中总生物碱含量随生长发育时期或月份不同存在一定差异,其中11月的最高,12月次之,1月的最低,最高值与最低值相比,约为2.6倍,差异达极显著水平(P<0.01)。精密度、稳定性实验及回收率等方法学考察表明,紫外分光光度法测定忽地笑鳞茎中总生物碱含量效果好,稳定性强,方法可靠。综合忽地笑鳞茎中总生物碱含量、中药材产量和土地利用率等因素考虑,以11月底前后采收比较适宜。     

High-power ultraviolet 278 nm laser from fourth-harmonic generation of a Nd:YAG laser in CsB3O5

We demonstrate a high-power UV 278 nm laser by fourth-harmonic generation (FHG) of a 1112 nm Nd:YAG laser in a nonlinear optical (NLO) crystal CsB3O5 (CBO) for the first time, to our best knowledge. A 30 W level diode-pumped Q-switched Nd:YAG laser at 1112 nm with beam quality factor M2=1.2 was used as the fundamental light source at a pulse width of 500 ns. With an LiB3O5 crystal, the 1112 nm laser was first frequency-doubled to 556 nm with an average output power of 13.5 W. It was then frequency doubled again in a CBO crystal to obtain the FHG output at 278 nm. The maximum average output power of the 278 nm laser is up to 1.5 W. The results demonstrated that CBO crystal is a promising NLO material for UV high-power lasers below 300 nm.     

An emittance measurement device for a space-charge dominated electron beam

Beam emittance is one of the most important parameters for electron sources. To investigate the beam emittance of the 3.5-cell DC-SC photocathode injector developed at Peking University, a multi-slit emittance measurement device has been designed and manufactured. The designed slit width, mask thickness and beamlet drift length are 100 μ m, 3 mm and 430 mm respectively. It is suitable for the electron beam with energy of about 5 MeV and the average current less than 0.1 mA. The preliminary measurement result of the rms emittance of the electron beam produced by the DC-SC injector is about 5-7 mm·mrad.     

CEV下考虑突发事件影响的有交易费用的交换期权定价

在股票价格满足CEV且受布朗运动和泊松过程共同驱动的模型下,对支付交易费用的交换期权定价进行研究,给出了期权价格满足的偏微分方程,并发现定价模型中股票价格的幂指数与波动率弹性α的选取有关,同时交易费用受泊松强度参数λ的影响,且随着λ的变大而变小.     

敏感器正常和故障模式下微小卫星的姿态确定方法

围绕某日-地空间环境组网探测系统中微小卫星定姿系统的设计需求,基于MEMS陀螺、小型CMOS太阳敏感器、微磁强计,研究了该微小卫星各敏感器正常工作模式以及敏感器故障模式下的系统建模和姿态确定方法。各敏感器正常工作模式下,用陀螺、太阳敏感器和磁强计进行组合定姿;陀螺故障时,用太阳敏感器和磁强计进行组合定姿;太阳敏感器故障时,用陀螺和磁强计进行组合定姿;陀螺/太阳敏感器同时故障时,用磁强计进行定姿。仿真结果表明,本文定姿方法的姿态确定精度满足该系统中微小卫星在轨运行时的定姿精度要求,为该微小卫星的半物理仿真系统的研究及其在轨运行时的姿态确定提供了依据。     

基于遗传算法的片上网络低功耗映射

随着片上网络(Network-on-Chip)集成度的提高,功耗逐渐成为设计的焦点.本文提出了一种在延时约束条件下,基于遗传算法的片上网络通信链路的低功耗映射算法.该算法使用数组方式编码染色体,并采用非常规码的交叉和变异运算因子.它充分利用遗传算法的群体优势,能快速有效地对通信功耗作优化.实验表明,该算法能平均减少50%左右的通信功耗.     

A kind of carbon whiskers in new structure and morphology

Carbon whiskers with new structure and morphology were observed when heating the milled graphite. Transmission electron microscopy (TEM) and high resolution electron microscopy (HREM) show that carbon layers are almost perpendicular to the growth axes of carbon whiskers. Field emission scanning electron microscopy (FESEM) indicates that there are spirals appearing on the surface of the whiskers. The structure analysis shows that the growth mechanism of carbon whiskers is related to the trace amount of ZrC in the heated samples.