Comparison of quantitative methods for analysis of polyphasic pharmaceuticals

Adequate very sensitive quantification methods are needed for the development and are also now required for the monitoring of undesirable solid form(s) as routine tests. The pre-requisite for quantitation are selectivity, sensitivity and most important the purity of standards and their proper storage, what is a challenge for metastable forms. Several analytical techniques are available such as X-ray diffraction, spectroscopy, thermal analysis and microcalorimetry. The different steps of the validation of the analytical methods and problems to be solved are discussed. Examples illustrate the different techniques and compare their possible advantages and limits. The relative standard deviation of measurements should allow for checking the homogenization procedure of mixtures for calibration. The validation should be carried out following ICH guidelines for validation of analytical methods. Comparison of different techniques in adequate concentration range add confidence in the analytical results.     

Temperature influence on hydrogen sorption in palladium limited-volume electrodes (Pd-LVE)

The effect of temperature on hydrogen and deuterium electrosorption into a palladium LVE (limited-volume electrode) has been investigated. A decrease in hydrogen capacity (H/Pd ratio) with increasing temperature has been observed. Temperature strongly influences the plots of measured H(D)/Pd values vs. potential scan rate. In addition, hydrogen absorption was found to be dependent on the composition of the surrounding electrolyte solution. These results have confirmed the hypothesis that two different mechanisms of hydrogen desorption from the palladium electrode take place, namely electrochemical oxidation and non-electrochemical recombination. Further, the ratio between the rate constants for these two processes has been found to change with temperature. Electronic Publication     

Kinetics of thermal decomposition of alkaline phosphates

Summary The thermal behavior of KH₂PO₄, NaH₂PO₄ and Na₂HPO₄ under non-isothermal conditions using TG method with different heating rates was studied. The values of the reaction rate were processed by means of Friedmans differential-isoconversional method. A dependence of the activation energy vs. conversion was observed. Therefore a procedure based on the compensation effect (suggested by Budrugeac and Segal) was applied. A less speculative data processing protocol was offered by the non-parametric kinetics method suggested by Serra, Nomen and Sempere. Three steps were observed by non-isothermal heating: a dehydration, a dimerization and a polycondensation. The differences in the intimate reaction mechanism are determined by the initial number of water molecules.     

New butenolides in plantlets of Virola surinamensis (Myristicaceae)

A phytochemical investigation in plantlets of the Brazilian medicinal tree Virola surinamensis resulted in the isolation and structural determination of four new compounds: 3-hydroxy-4-methyl-2-(11'-piperonyl-n-undecyl)-butenolide; 3-hydroxy-4-methyl-2-(7'-piperonyl-n-heptyl)-butanolide; 9'-(3,4-methylenedioxy-phenyl)-nonanoic acid and 13'-(3,4-methylene-dioxyphenyl)-tridecanoic acid. Thirteen compounds previously isolated from seeds and adult plants were also reported.     

Interaction of gas phase atomic hydrogen with Pt(111):Direct evidence for the formation of bulk hydrogen species

Employing hot tungsten filament to thermal dissociate molecular hydrogen,we generated gas phase atomic hydrogen under ultra-high vacuum(UHV)conditions and investigated its interaction with Pt(111) surface.Thermal desorption spectroscopy(TDS)results demonstrate that adsorption of molecular hy- drogen on Pt(111)forms surface Had species whereas adsorption of atomic hydrogen forms not only surface Had species but also bulk Had species.Bulk Had species is more thermal-unstable than surface Had species on Pt(111),suggesting that bulk Had species is more energetic.This kind of weakly- adsorbed bulk Had species might be the active hydrogen species in the Pt-catalyzed hydrogenation reactions.     

PM3 semi-empirical study of stereoelectronic effects in the Baeyer-Villiger reaction

The Baeyer-Villiger reaction of polymethoxybenzaldehydes with peroxysuccinic acid (PSA) is studied theoretically. The semi-empirical SCF-MO/PM3 method has been used to study the reaction and to calculate the energy profiles. In addition, heat of formation computations and bond order analyses of the transition species along the reaction coordinates have been performed and are interpreted qualitatively in terms of electron flow through the system during aryl migration. Our results support the hypothesis that the second step is a concerted reaction. Our data support a definite effect of the substituent on the aryl migration. The theoretical predictions are in good agreement with experimental results.     

Pervaporative transport modelling in a ternary system: ethyltertiarybutylether/ethanol/polyurethaneimide

The study deals with the analysis of diffusion and mass transfer modelling during pervaporation in a true ternary system involving a polar liquid mixture (ETBE/EtOH) and a polar block copolymer (polyurethaneimide or PUI). A survey of methods of pervaporative transfer modelling in ternary systems is first developed. From differential permeation experiments carried out with both pure liquids, it appears that both permeants obey a Fickian law. Moreover, the diffusional behaviour is consistent with Long's model, which has thus been assumed for the related ternary system. An extension of the Brun's model is then derived, which takes into account the diffusion coupling as well the significant deviation from sorption ideality. From a practical point of view, the calculated values of fluxes show generally good agreement with the experimental results, although a small deviation occurs for mixtures of low ethanol content. Diffusion coefficients of both pure solvents corresponding to transient or steady state are compared. A very good agreement is found for the aprotic permeant (ETBE). whereas the diffusion coefficient of ethanol in transient state is only the quarter of the value corresponding to steady state. The results are discussed in comparison with related investigations in the literature, involving specific liquid-polymer interactions.     

An Easy One-Pot Procedure for the Synthesis of <Emphasis Type="Italic">N</Emphasis>-Sulfonyl Phosphorous Ylides and Sulfonyl Iminophosphoranes

Summary. Reaction of triphenylphosphine and an electron deficient acetylenic ester in the presence of strong N–H acid such as alkyl and aryl sulfamides or acetamide produces phosphorous ylides at room temperature in CH₂Cl₂. The aryl sulfamide phosphoranes undergo a smooth transformation reaction in boiling toluene and produce iminophosphoranes.     

Efficient combination of task-specific ionic liquid and microwave dielectric heating applied to one-pot three component synthesis of a small library of 4-thiazolidinones

The first report of the use of task-specific ionic liquid as synthetic equivalent of ionic liquid-phase matrice for the preparation of a small library of 4-thiazolidinones is reported in this paper. The starting (ethyleneglycol)ionic liquid-phase is functionalized in good yields with 4-(formylphenoxy)butyric acid by using usual esterification reaction conditions (DCC/DMAP as catalyst). The synthesis of the ionic liquid-phase bound 4-thiazolidinones was performed by a one-pot three-component condensation under microwave dielectric heating. The final cleavage under microwave/catalysis strategy provides the expected 4-thiazolidinones in high purity after flash-chromatography purification. According to the ionic liquid-phase organic synthesis (IoLiPOS) methodology, it was found that optimized reaction conditions were performed by standard analytical methods (NMR, TLC). The ¹H, ¹³C NMR spectrum of some representative 4-thiazolidinones and ionic liquid-phase bound benzaldehyde are also reported.     

Autoxidation of cyclohexane: conventional views challenged by theory and experiment.

In spite of its industrial importance, the detailed reaction mechanism of cyclohexane autoxidation by O2 is still insufficiently known. Based on quantum chemical potential energy surfaces, rate coefficients of the primary and secondary chain propagation steps involving the cyclohexylperoxyl (CyOO) radical were evaluated using multiconformer transition-state theory. Including tunneling and hindered-internal-rotation effects, the rate coefficient for hydrogen-atom abstraction from cyclohexane (CyH) by CyOO was calculated to be k(T)= 1.46 x 10(-11) x exp(-17.8 kcal mol(-1)/ RT) cm3s(-1) (300-600K), close to the experimental data. A "Franck-Rabinowitch cage" reaction between the nascent cyclohexylhydroperoxide (CyOOH) and cyclohexyl radical, products from CyOO + CyH, is put forward as an initially important cyclohexanol (CyOH) formation channel. alphaH abstraction by CyOO. from cyclohexanone was calculated to be only about five times faster than that from CyH, too slow to explain all the observed side products. The a-hydrogen (alphaH) abstractions from CyOH and CyOOH by CyOO. are predicted to be about 10 and 40 times faster, respectively, than the CyOO. +CyH reaction. The very fast CyOO.+CyOOH reaction proceeds through the unstable Cy-alphaH .OOH radical that decomposes spontaneously into the ketone (Q=O) plus the OH radical; the "hot" .OH is found to produce the bulk of the alcohol via a second, "activated cage" reaction analogous to that above. It is thus shown how the very reactive CyOOH intermediate is the predominant source of ketone and alcohol, while it also leads to some side products. The alpha-hydroxycyclohexylperoxyl radical formed during the moderately fast oxidation of CyOH is shown to decompose fast into HO2 + cyclohexanone in a rapidly equilibrated reaction, which constitutes a smaller, second ketone source. These two fast cyclohexanone forming routes avoid the need for unfavorable molecular routes hitherto invoked as ketone sources. The theoretical predictions are supported and complemented by experimental findings. The newly proposed scheme is also largely applicable to the oxidation of other hydrocarbons, such as toluene, xylene, and ethylbenzene.