Dual Intramolecular Electron Transfer for In Situ Coreactant‐Embedded Electrochemiluminescence Microimaging of Membrane Protein

The demand for transporting coreactant to emitter and short lifetime of the radicals in electrochemiluminescence (ECL) emission inhibit greatly its application in cytosensing and microscopic imaging. Herein we designed a dual intramolecular electron transfer strategy and tertiary amine conjugated polymer dots (TEA‐Pdots) to develop a coreactant‐embedded ECL mechanism and microimaging system. The TEA‐Pdots could produce ECL emission at +1.2 V without need of coreactant in test solution. The superstructure and intramolecular electron transfer led to unprecedented ECL strength, which was 132 and 45 times stronger than those from the mixture of Pdots with TEA at equivalent and 62.5 times higher amounts, respectively. The ECL efficiency was even higher than that of typical [Ru(bpy)₃]²⁺ system. Therefore, this strategy and coreactant‐embedded ECL system could be used for in situ ECL microimaging of membrane protein on single living cells without additional permeable treatment for transporting coreactant. The feasibility and validity were demonstrated by evaluating the specific protein expression on cell surface. This work opens new avenues for ECL applications in single cell analysis and dynamic study of biological events.     

氮中丙烯腈气体标准物质的研制

以高纯丙烯腈和高纯氮气为原料,采用称量法配制氮中丙烯腈气体标准物质。对配制的气体标准物质分别进行机械混匀试验、压力均匀性和时间稳定性试验。经F检验,2.00μmol/mol及5.00μmol/mol两种浓度的样品在0.5~10 MPa范围内标准值无显著变化,具有较好的压力均匀性;在–20℃和40℃条件下保存7 d,其量值无显著变化,可满足运输环节量值稳定;在常温下贮存9个月量值无显著变化,表明其稳定性良好,满足国家二级标准物质对有效期的要求。对定值结果的不确定度进行评定。配制的氮中丙烯腈气体标准物质标准值为(2~5)×10~(–6)mol/mol,相对扩展不确定度为9%(k=2)。该标准物质达到国家二级标准物质的相关技术要求,可用于对丙烯腈气体报警器的校准。     

蒙特卡洛法评定在线pH计示值误差的不确定度

以在线p H计为例,考察了在线酸度计示值误差不确定度的分布规律,利用蒙特卡洛法评定示值误差不确定度。对于0.01级的在线p H计,蒙特卡洛法与GUM法评定结果的差值为9.1%,小于不可靠性(20%);对于0.1级的在线p H计,蒙特卡洛法与GUM法评定结果的差值为3.8%,小于不可靠性(10%)。通过比较得出结论,采用GUM法验证了蒙特卡洛法(MCM)根据JJF 1547–2015评定在线p H计示值误差不确定度的方法是有效且适用的。尤其在测量模型非线性以及输出量的概率密度函数(PDF)较大程度地偏离正态分布或t分布等GUM法不适用的场合,蒙特卡洛法是评定在线分析监测仪器仪表示值误差不确定度的重要手段。     

Facile fabrication of a superhydrophobic surface from natural Eucommia rubber

In this study, we introduce a fabrication method for a superhydrophobic surface made from natural Eucommia rubber. Based on the Eucommia rubber extract solution, we prepared a type of superhydrophobic material using the simple phase separation method and the addition of a low‐surface‐energy substance method, thus developing a new approach for the application of natural Eucommia rubber. The experimental results showed that a superhydrophobic film could be obtained by both the addition of acetone and induction by water vapor. Additionally, the film exhibited properties closely related to the crystalline Eucommia rubber spherical particles with a hierarchical structure. The addition of hydrophobic silica also increased the hydrophobic property of the Eucommia rubber film. When the content of the silica was 4% (wt%), the contact angle of the composite film reached 160.7°, which could be attributed to the properties of the nano‐silica and the micro‐nano structure of the composites. Copyright © 2017 John Wiley & Sons, Ltd.     

Synthesis of Terphenyl Derivatives by Pd‐Catalyzed Suzuki‐Miyaura Reaction of Dibromobenzene Using 2N2O‐Salen as a Ligand in Aqueous Solution

A simple and efficient catalytic system for Na₂PdCl₄ catalyzing the Suzuki‐Miyaura reaction of dibromobenzene and arylboronic acid has been developed by using 2N2O‐salen as a ligand in H₂O/EtOH (V:V=4:1) at 100°C. Using this method, the reactions of substrates containing sterically demanding ortho substituents (e.g. dibromobenzene and/or arylboronic acids) proceeded efficiently, with the corresponding terphenyl derivatives being produced in moderate to excellent yields. Furthermore, this method offers interesting features for the multi‐gram scale synthesis of terphenyl compound.     

旋涂法制备PEO-PAN-PMMA三组分共混凝胶聚合物电解质

随着新能源产业和储能产业的快速发展,二次电池的安全性和能量密度要求越来越高.而传统的液态锂电池使用易燃的电解液,所以存在较大的安全隐患.因此固态锂电池由于其较高的安全性和能量密度受到越来越多人的关注.目前困扰固态电池应用的主要问题是其离子电导率和电极电解质界面问题.固态电解质是固态电池的关键材料.因此开发高离子电导率的固态电解质是开发固态电池的关键.在本工作中,作者成功通过旋涂法制备聚乙二醇-聚丙烯腈-聚甲基丙烯酸甲酯（PEO-PAN-PMMA）凝胶电解质.PEO-PAN-PMMA聚合物薄膜为均匀透明的,具有较高的吸附率,且热稳定性较好,在380℃下保持稳定.通过浸泡电解液可以得到性能优异的凝胶电解质.该凝胶电解质具有较高的离子电导率,室温离子电导率为0.4 mS/cm,而且电化学窗口较宽,在0～4.2 V之间化学性能较为稳定,界面稳定性较好.组装成Li//PEO-PAN-PMMA凝胶电解质//LiCoO₂电池之后,正极首圈放电容量为129.8 mAh/g,循环100周,正极放电容量剩余119.51 mAh/g,在0.1 C、0.2 C、0.5 C和1 C倍率下循环,正极放电容量分别为129.8 mAh/g,99.5 mAh/g,86.1 mAh/g和64 mAh/g.     

Synthesis and anticancer activity of benzotriazole derivatives

A series of benzotriazole (BTA) derivatives were synthesized as tyrosine protein kinase inhibitors using fragment-based design strategy. All desired compounds were synthesized with the reaction of benzotriazole, chloroacetonitrile and aromatic aldehyde using Ultrasonic-Microwave method and characterized by IR, ¹H and ¹³C-NMR, mass spectrometry (MS) and elemental analysis. The anticancer activity of these compounds was evaluated by CCK-8 method against carcinoma VX2, lung cancer A549, stomach cancer cell lines MKN45 and MGC in vitro. The results showed that all compounds showed good antiproliferative activity. In particular, compound 2.1 showed the most prominent inhibition of VX2 cell lines with IC₅₀ of 3.80 ± 0.75 μM. Compound 2.2 exhibited highly potent anticancer activity of stomach MGC cell lines with IC₅₀ of 3.72 ± 0.11 μM. A549 and MKN45 cell lines were sensitive to compound 2.5 with IC₅₀ of 5.47 ± 1.11 and 3.04 ± 0.02 μM, respectively.     

Perylene anhydride fused porphyrins as near-infrared sensitizers for dye-sensitized solar cells

Two perylene anhydride fused porphyrins 1 and 2 have been synthesized and employed successfully in dye-sensitized solar cells (DSCs). Both compounds showed broad incident monochromatic photon-to-current conversion efficiency spectra covering the entire visible spectral region and even extending into the near-infrared (NIR) region up to 1000 nm, which is impressive for ruthenium-free dyes in DSCs.     

A density-wave-like transition in the polycrystalline V3Sb2 sample with bilayer kagome lattice

Recently,transition-metal-based kagome metals have aroused much research interest as a novel platform to explore exotic topological quantum phenomena.Here we report on the synthesis,structure,and physical properties of a bilayer kagome lattice compound V₃Sb₂.The polycrystalline V₃Sb₂ samples were synthesized by conventional solid-state-reaction method in a sealed quartz tube at temperatures below 850℃.Measurements of magnetic susceptibility and resistivity revealed consistently a density-wave-like transition at Tdw≈160 K with a large thermal hysteresis,even though some sample-dependent behaviors were observed presumably due to the different preparation conditions.Upon cooling through Tdw,no strong anomaly in lattice parameters and no indication of symmetry lowering were detected in powder x-ray diffraction measurements.This transition can be suppressed completely by applying hydrostatic pressures of about 1.8 GPa,around which no sign of superconductivity was observed down to 1.5 K.Specific-heat measurements revealed a relatively large Sommerfeld coefficientγ=18.5 mJ·mol^-1·K^-2,confirming the metallic ground state with moderate electronic correlations.Density functional theory calculations indicate that V₃Sb₂ shows a non-trivial topological crystalline property.Thus,our study makes V₃Sb₂ a new candidate of metallic kagome compound to study the interplay between density-wave-order,nontrivial band topology,and possible superconductivity.