Mechanical, thermal and surface properties of polyacrylamide/dextran semi-interpenetrating network hydrogels tuned by the synthesis temperature

The mechanical, rheological, thermal, and surface behaviors of three polyacrylamide/dextran (PAAm/Dx) semi-interpenetrating polymer network (semi-IPN) hydrogels, prepared at 22°C, 5°C and ?18°C, were investigated. The results were compared with those obtained on cross-linked PAAm without Dx synthesized under the same conditions. Hydrogels prepared at the lowest temperature were the most mechanically stable. The thermal stability of the semi-IPN hydrogels is slightly lower than the corresponding PAAm gels, irrespective of preparation temperature. The water vapor sorption capacity depended on the presence of Dx as well as preparation temperature, which determines the network morphology.      

Strategy of Cr detoxification by Callitriche cophocarpa

The present work focused on the qualitative and quantitative analysis of Cr detoxification strategy of aquatic cosmopolitan plant Callitriche cophocarpa. This plant species has just been described in the context of its unusual accumulation potential of Cr. The emphasis of the work was placed on the redox reaction Cr(VI)→Cr(III) which is considered to be remediation mechanism of highly reactive and mobile Cr(VI) ions. Plants were immersed for 5 days in 1 mM of Cr(VI) (potassium dichromate) or 1 mM of Cr(III) (chromium sulphate) solutions in semi-natural conditions. Cr was effectively removed from the solution up to the extent of ca.58% or 35% of the starting amount, in the case of Cr(III) and Cr(VI), respectively. No plant-induced Cr(VI) reduction accompanying Cr accumulation was observed in Cr(VI) solutions except from the apparent one, noticed at the fourth day of incubation. On the contrary to these results, according to the method of electron paramagnetic resonance spectroscopy (L-band EPR), biphasic signal of Cr(V) attending Cr(VI) to Cr(III) reduction was detected inside the plant tissue every day of investigations. Our results show that phytoextraction but not phytostabilization is the main strategy of Cr detoxification by C. cophocarpa in aquatic systems.      

Use of direct immersion solid-phase microextraction on polyacrylate and polydimethylsiloxane stationary phases for simultaneous determination of the neutral and basic pharmaceuticals in wastewater

Direct immersion solid-phase microextraction has been optimized and applied to the simultaneous determination of the neutral and basic pharmaceuticals: caffeine, carbamazepine, clomipramine, chlorprothixene and clotrimazole at low concentrations in municipal wastewater. Two absorption type stationary phases: polydimethylsiloxane (PDMS) and polyacrylate (PA) have been found to be most effective for extraction of target analytes. The separation and detection were carried out by gas chromatograph coupled with mass spectrometer working in the selected ion monitoring mode. The method was validated for linearity, detection and quantitation limits, selectivity and precision. The average correlation coefficient of the calibration curves was 0.9933. The LOD values in influent and effluent wastewater were in the range of 10–145 ng L^?1 and 4–111 ng L^?1, respectively, which were a bit higher than those in the deionized water due to matrix effect. The high values of distribution coefficient (K _fs ) in PDMS/water and PA/water systems (log K _fs between 3.05 and 4.23) indicates the very high applicability of these stationary phases for determination of carbamazepine, clomipramine, chlorprothixene and clotrimazole in water samples.

Open image in new window

     

Nano composite system based on coumarin derivative–titanium dioxide nanoparticles and ionic liquid: Determination of levodopa and carbidopa in human serum and pharmaceutical formulations

The combination of coumarin derivative (7-(1,3-dithiolan-2-yl)-9,10-dihydroxy-6H-benzofuro[3,2-c]chromen-6-on), (DC)–titanium dioxide nanoparticles (TiO₂) and ionic liquid (IL) yields nanostructured electrochemical sensor, formed a novel kind of structurally uniform and electrocatalytic activity material. This new ionic liquid–TiO₂ nanoparticles modified carbon paste electrode (IL–CTP) due to its enhanced conductivity presented very large current response from electroactive substrates. The modified electrode was characterized by different methods including a scanning electron microscope (SEM), electrochemical impedance spectroscopy (EIS) and voltammetry. A pair of well-defined quasi reversible redox peaks of coumarin derivative was obtained at the modified carbon paste electrode (DC/IL–CTP) by direct electron transfer between the coumarin derivative and the CP electrode. Dramatically enhanced electrocatalytic activity was exemplified at the DC/IL–CTP electrode, as an electrochemical sensor to study the electro oxidation of levodopa (LD) and carbidopa (CD). Based on differential pulse voltammetry (DPV), the oxidation of LD and CD exhibited the dynamic range between 0.10– 900.0 μM and 20.0–900.0 μM respectively, and the detection limit (3σ) for LD and CD were 41 nM and 0.38 μM, respectively. DPV was used for simultaneous determination of LD and CD at the DC/IL–CTP electrode, and quantitation of LD and CD in some real samples (such as tablets of Parkin-C Fort and Madopar, Sinemet, water, urine, and human blood serum) by the standard addition method.     

A selective electromembrane extraction of uranium (VI) prior to its fluorometric determination in water

A novel method for the selective electromembrane extraction (EME) of U⁶⁺ prior to fluorometric determination has been proposed. The effect of extraction conditions including supported liquid membrane (SLM) composition, extraction time and extraction voltage were investigated. An SLM composition of 1% di-2-ethyl hexyl phosphonic acid in nitrophenyl octyl ether (NPOE) showed good selectivity, recovery and enrichment factor. The best performance was achieved at an extraction potential of 80 volts and an extraction time of 14 minutes Under the optimized conditions, a linear range from 1 to 1000 ng mL⁻¹ and LOD of 0.1 ng mL⁻¹ were obtained for the determination of U⁶⁺. The EME method showed good performance in sample cleanup and the reduction of the interfering effects of Mn²⁺, Zn²⁺, Cd²⁺, Ni²⁺, Fe³⁺, Co²⁺, Cu²⁺, Cl⁻ and PO₄³⁻ ions during fluorometric determination of uranium in real water samples. The recoveries above 54% and enrichment factors above 64.7 were obtained by the proposed method for real sample analysis.     

Homogeneous Liquid–Liquid Microextraction Via Flotation Assistance (HLLME-FA) Method for the Pretreatment of Organochlorine Pesticides in Aqueous Samples and Determination by GC–MS

This work proposes a new, rapid and simple homogeneous liquid–liquid microextraction via flotation assistance technique for the analysis of six organochlorine pesticides in water samples. A special extraction cell was used to facilitate collection of the low-density solvent extract. No centrifugation was required in this procedure. Determination was carried using gas chromatography–mass spectrometry. The water sample solution was then added into the extraction cell containing appropriate mixture of extract and homogeneous solvents. In the first step, a homogeneous solution and then with the continuation of water sample injection, a cloudy solution was formed. Using air flotation, the organic solution was collected at the conical part of the designed cell. The optimized levels of effective parameters were found based on response surface methodology approach. Applying the optimized conditions to the system understudy, the limits of detection of all target analytes were obtained in the range of 1.4–7 ng mL^?1, while the precisions were found to be in the range of 11.08–14.87 (RSD, n = 3). The linearity of the method lay in the range of 10–150 ng mL^?1 with the coefficients of correlation (r ² ) ranging from 0.998 to 0.999.     

Doped Nano‐Sized Copper(I) Oxide (Cu2O) on Melamine?Formaldehyde Resin: a Highly Efficient Heterogeneous Nano Catalyst for ‘Click’ Synthesis of Some Novel 1H‐1,2,3‐Triazole Derivatives Having Antibacterial Activity

A facile and simple protocol for the 1,3‐dipolar cycloaddition of organic azides with terminal alkynes catalyzed by doped nano‐sized Cu₂O on melamine? formaldehyde resin (nano‐Cu₂O? MFR) as a new and convenient heterogeneous catalyst is described. In this method, ‘click’ cycloaddition of various structurally diverse β‐azido alcohols and alkynes in the presence of nano‐Cu₂O? MFR in H₂O/THF 1 : 2 furnished the corresponding 1,4‐disubstituted 1H‐1,2,3‐triazole adducts 1a – 1o in good to excellent yields at room temperature (Scheme and Table 3). The nano‐Cu₂O? MFR was characterized by scanning electron microscopy (SEM), X‐ray diffraction (XRD), inductively coupled plasma (ICP) analysis, and FT‐IR. The nano‐Cu₂O? MFR could be easily recovered and recycled from the reaction mixture and reused for many consecutive trials without significant decrease in activity (Table 4). The in vitro antibacterial activities of all synthesized compounds were tested on several Gram‐positive and/or Gram‐negative bacteria (Table 5). The results demonstrate the promising antibacterial activity for some of the synthesized compounds.     

Simple and Highly Efficient Procedure for Conversion of Aldoximes to Nitriles Using N-(p-Toluenesulfonyl) Imidazole

A facile and efficient method for dehydration of aldoximes into nitriles using N-(p-toluenesulfonyl) imidazole (TsIm) is described. In this method, aldoximes were refluxed with TsIm in the presence of 1,8-diazabicyclo-[5.4.0]undec-7-ene (DBU) in dimethylformamide (DMF) to afford the corresponding nitriles in good yields. This methodology is highly efficient for various structurally diverse aldoximes including aromatic, heteroaromatic, and aliphatic oximes. A plausible mechanism for the conversion of aldoxime into nitriles using TsIm/DBU is explained.     

Highly Efficient Solvent-Free Synthesis of Dihydropyrimidinones Catalyzed by Zinc Oxide

A simple, efficient and practical procedure for the Biginelli reaction using zinc oxid (ZnO) as a novel and reusable catalyst is described under solvent-free conditions in high yields. The use of this agent is characterized by remarkable reactivity, moderate costs, low toxicity and simple work up procedures.     

An Efficient Method for Production and Storage of Unstable S-Nitrosothiols Under Mild and Heterogeneous Condition with Sodium Nitrite and Oxalic Acid Dihydrate

Thiols can be readily converted to their corresponding nitrosothiols with a combination of oxalic acid and sodium nitrite in t-butanol at room temperature (26-30°C). The reaction mixture could be solidified with decreasing its temperature to, 15°C and was stored for several days without any destruction of the nitrosothiols.