Synthetic thermally reversible gel systems. V

Differential thermal analysis has been used to study the fusion of aqueous thermally reversible gels of gelatin and polyacrylylglycinamide (PAG). In the case of gelatin gels, endotherms close to the melting point are readily observed and these are sometimes preceeded by a small exothermic heat of gel reorganization. Calculations are presented to show that breaking of the gelatin gel network requires only a small fraction of the observed endothermic heat of fusion and that most of the heat is required for melting larger crystallites within gelatin aggregates and for perhaps a helix → coil transition. Failure to observe endotherms by DTA over the known temperature range of fusion of PAG gels is consistent with prior measurements and conclusions. The noncrystallinity of PAG gels and soluble aggregates together with a heat of crosslinking of only ?5 to ?10 kcal/mole of crosslinks places the heat of fusion of PAG gels outside the lower limits of DTA sensitivity.     

Water-Soluble imide-amide copolymers. II. Preparation and characterization of poly (acrylamide-co-p-maleimidobenzoic acid)

The comonomer required, p-maleimidobenzoic acid (MBA) was first prepared in good yield by refinements of published methods. p-Carboxysuccinanilic acid (CSA), and p-succinimidobenzoic acid (SBA), were also prepared to provide models useful for IR and NMR for spectroscopic assignments of the new copolymers. Polymerization of MBA with acrylamide in glacial acetic acid at 60°C gave copolymers with estimated viscosity average molecular weights of 60,000 to 90,000. Yields and viscosity average molecular weights decreased as the MBA to acrylamide monomer feed ratio was increased. The rate of incorporation of MBA into the copolymer rose from 7 to 23% when the mole ratio in the feed was raised from 5 to 20%. Decreasing the initiator concentration increased molecular weights by less than predicted and reduced the yield of copolymer for any given feed ratio of MBA to acrylamide. In all cases about 30–40% of the MBA units in the purified copolymers were hydrolyzed. A change to dimethyl sulfoxide solvent gave good, and poor yields of copolymer at 5 and 10 mol % MBA, respectively, and no copolymer at 20 mol % MBA. Viscosity average molecular weights of the copolymer products prepared in DMSO were somewhat lower than obtained for the copolymers prepared in acetic acid. Polymerization in a DMSO-water mixture gave a negligible yield of polymeric product. Instead, only hydrolysates of MBA precipitated when the coloured polymerization solutions were added to methanol.     

A Photoelectron-spectroscopic investigation of the Homoconjugative Interaction between π- and Walsh-Orbitals in endo- and exo-Cyclopropano-norbornene

Photoelectron spectra of endo- and exo-cyclopropano-norbornene ( = endo- and exo-tricyclo[3.2.1.0^2.4]octa-6-ene) show that a significant homoconjugation exists between the π-orbital of the double bond and the symmetric Walsh-es-orbital of the cyclopropane ring in the exo-isomer, whereas the interaction is negligeable in the endo-derivative.     

Non planéité de cyclopenténones substituées analyse conformationnelle par résonance magnétique nucléaire

The stereochemistry of substituted cyclopent-2-en-1-ones was studied by NMR. The existence of non-planar rings is indicated and conformational analysis, based principally upon examination of the coupling constants enables the conformational population to be estimated; trans dihalogeno derivatives, for example, occur predominantly in the diaxial form.     

Thermodynamische Untersuchungen zur Chelatbildung zwischen Aminoterephthalsäure-N,N-diessigsäure und 3 d- bzw. Erdalkalimetallionen. Eine Betrachtung zum Einfluß einer koordinativ inaktiven Carboxylgruppe auf die komplexe Bindung von Metallionen durch Aminopolycarbonsäuren

N-(2-Carboxyphenyl)iminodiacetic acid (H₃A) and N-(2,5-dicarboxyphenyl)iminodiacetic acid (H₄B) are tetradentate ligands and form complexes of the composition MA- and MB^2? with M^II ions. These compounds differ by the additional charge of the second carboxylic group only, which is fixed to the benzene nucleus and which is unable for coordination for steric reasons. Using an anisothermal calorimeter ΔH values for the formation of the complexes MA- and MB^2? in aqueous solution have been measured at an ionic strength 0.1 m KNO₃. From these data, and from the stability constants of the complexes, entropy changes ΔS have been calculated. In all cases investigated (M^m+ = H⁺, Mg²⁺, Ca²⁺, Sr²⁺, Co²⁺, Ni²⁺, Cu²⁺, Zn²⁺) the ΔH values are more negative for the complexes MA^m-3 than for complexes MB^m-4, whereas the ΔS values are greater for complexes MB^m-4. Using a simple model for the molecules of the complexes MB^m-4 and empirically determined dielectric constants of the medium between the central ions and the noncoordinated ionized carboxylic group, the electrostatic attraction between these charges was calculated. Basing on these results the influence of the noncoordinated carboxylic group on the central atom by the mesomeric and inductive effect is discussed.     

Chemische Vitamin D<Subscript>3</Subscript>-Bestimmung in Lebertran

The different aspects of Vitamin D₃ determination and the data reported in the literature are discussed. The spectrophotometric determination of Vitamin D₃ in cod-liver oil is carried out after the alkaline saponification, extraction of unsaponified parts, precipitation of accompanying sterols and the column- and thin-layer chromatographic purification and separation of vitamin D₃ on 40 cm plates from other vitamins. The dyestuff α-naphtholbenzein is suited well as standard substance for the better location and identification of vitamin D₃ zone on the thin-layer plate. The results obtained from the chemical method were checked through the simultaneous biological determination.     

Theoretical investigations of Fe porphyrins. V. Low-lying electronic states of bisammineporphinatoiron(III)

Ab initio CI calculations are reported on the lowest doublet, quartet, and sextet states of [Fe^III(P)(NH₃)₂]⁺. The low-spin ground state is calculated as (d_xy² (d_π)³ with d_xy(d_π)⁴ higher by 0.15 eV. The near-ir bands at ～1 eV observed in low-spin ferriheme proteins are attributed to (π → d_π) transitions. The lowest high-spin state is ⁶A_1g, and the near-ir transitions of the high-spin ferriheme proteins observed at ～1.2 eV are attributed to higher ⁶[tripsextet] excited states [i.e., ring triplet, metal sextet]. The 30-ps “triplet” transient populated with low quantum yield observed in laser-flash studies on Fe^III(TPP)CI [TPP = tetrapbenylporphyrin] may be an ¹[tripsextet] state.     

Protein biosensors based on biofunctionalized conical gold nanotubes

There is increasing interest in the concept of using nanopores as the sensing elements in biosensors. The nanopore most often used is the alpha-hemolysin protein channel, and the sensor consists of a single channel embedded within a lipid bilayer membrane. An ionic current is passed through the channel, and analyte species are detected as transient blocks in this current associated with translocation of the analyte through the channel-stochastic sensing. While this is an extremely promising sensing paradigm, it would be advantageous to eliminate the very fragile lipid bilayer membrane and perhaps to replace the biological nanopore with an abiotic equivalent. We describe here a new family of protein biosensors that are based on conically shaped gold nanotubes embedded within a mechanical and chemically robust polymeric membrane. While these sensors also function by passing an ion current through the nanotube, the sensing paradigm is different from the previous devices in that a transient change in the current is not observed. Instead, the protein analyte binds to a biochemical molecular-recognition agent at the mouth of the conical nanotube, resulting in complete blockage of the ion current. Three different molecular-recognition agents, and correspondingly three different protein analytes, were investigated: (i) biotin/streptavidin, (ii) protein-G/immunoglobulin, and (iii) an antibody to the protein ricin with ricin as the analyte.     

Photon-induced dissociation with a four-sector tandem mass spectrometer

The feasibility of using photodissociation of protonated peptide molecules to sequence specific fragment ions with a 193-nm pulsed laser beam in a magnetic deflection tandem mass spectrometer of EBEB configuration was demonstrated. Although the short pulse (15 ns) and low repetition rate (100 Hz) of the excimer laser permitted the irradiation of only ～ 0.02% of the (M + H)⁺ ions exiting MS-1, a photon-induced decomposition spectrum of the heptapeptide angiotensio III (M _r 930.5) was produced that was practically the same (but with better signal-to-noise ratio) as that generated by collision-activated dissociation at the same low duty cycle. Because of the low and pulsed fragment ion currents, an array detector was used to record the spectra. A dependence between laser power and abundance of fragment ions was observed (increased power increases the relative abundance of ions of low mass). Laser power was varied from 6 to 80 mJ. Formation of fragment ions from a large peptide (melittin, M, 2844.75) was also observed. The results permit the design of modifications that may increase the fragment ion yield to 10% or higher, which would make photon-induced decomposition a useful method for magnetic deflection mass spectrometers.     

Sequentially photocleavable protecting groups in solid-phase synthesis

[reaction: see text] A sequential solid-phase peptide synthesis was developed using both photolabile linker and protecting groups. The chromatic sequential lability between a tert-butyl ketone-derived linker (sensitive to irradiation at 305 nm) and a nitroveratryloxycarbonyl (NVOC) group (sensitive at 360 nm) was exploited to prepare Leu-Enkephalin in a 55% overall yield. This new strategy allows the preparation of peptides in essentially neutral medium, by avoiding the use of common deprotection reagents such as trifluoroacetic acid or piperidine.