Precise measurement of magnetic moment of short-lived β-emitting nuclei12B ( I π=1+, T 1/2=20.18 ms)

The spin polarized β-emitting nuclei¹²B (I ^π=1⁺,T _1/2=20.18 ms) were produced by the nuclear reaction¹¹B(d, p)¹²B and by the selection technique of the incident deuteron energy and the¹²B recoil angle following the nuclear reaction. The nuclear magnetic moment of the short-lived nuclei¹²B was measured by β-NMR with the β-NMR and β-NQR setup established for the first time in China. The nuclear magnetic moment of¹²B was determined to be μ=0.99993±0.00048 nm org=0.99993±0.00048 after the precise correction of the Knight shift.     

Boundary value problems for first order impulsive delay differential equations with a parameter

In this paper, by means of the method of upper and lower solutions and monotone iterative technique, the existence of maximal and minimal solutions of the boundary value problems for first order impulsive delay differential equations is established.     

Photoluminescence characteristics of ZnTiO3: Bi nanocrystals

The photoluminescence properties of the Bi³⁺ in sol-gel derived ZnTiO₃ nanocrystals have been investigated. An ultra-violet emission at 360 nm and a visible emission band at 506 nm have been observed, originating from two kinds of emission centers. The former is ascribed to the ³P₁-¹S₀ transition of Bi³⁺ and the latter to the recombination of the electrons with the photo-generated holes trapped in the zinc vacancies. In all cases the latter contribution is predominant.     

用改进嵌入原子法计算Cu晶体的表面能

用改进嵌入原子法(MEAM)计算了Cu晶体12个晶面的表面能.结果表明，密排面(111)的表面能最小.其他晶面的表面能随其晶面与(111)晶面夹角的增加而增加，据此可以粗略地估计各晶面表面能的相对大小.给出的几何结构因子的确定方法及结果可以直接用于计算其他面心立方晶体的表面能及其他特性.在Cu,Ag等面心立方薄膜中出现(111)择优取向或织构的机理是表面能的最小化. 关键词： 改进嵌入原子法 铜 表面能 计算     

Hierarchical structures in a turbulent pipe flow

A hierarchical structure (HS) analysis (β-test and γ-test) is applied to a fully developed turbulent pipe flow. Velocity signals are measured at two cross sections in the pipe and at a series of radial locations from the pipe wall. Particular attention is paid to the variation of turbulent statistics at wall units 10<y⁺<3000. It is shown that at all locations the velocity fluctuations satisfy the She–Leveque hierarchical symmetry (Phys. Rev. Lett. 72 (1994) 336). The measured HS parameters, β and γ, are interpreted in terms of the variation of fluid structures. Intense anisotropic fluid structures generated near the wall appear to be more singular than the most intermittent structures in isotropic turbulence and appear to be more outstanding compared to the background fluctuations; this yields a more intermittent velocity signal with smaller γ and β. As turbulence migrates into the logarithmic region, small-scale motions are generated by an energy cascade and large-scale organized structures emerge which are also less singular than the most intermittent structures of isotropic turbulence. At the center, turbulence is nearly isotropic, and β and γ are close to the 1994 She–Leveque predictions. A transition is observed from the logarithmic region to the center in which γ drops and the large-scale organized structures break down. We speculate that it is due to the growing eddy viscosity effects of widely spread turbulent fluctuations in a similar way as in the breakdown of the Taylor vortices in a turbulent Couette–Taylor flow at high Reynolds numbers.     

Study of the pulsed laser vapor doping of Si(1 0 0) with KrF excimer laser and BCl3 gas

The properties of pulsed laser vapor doping on p-Si(1 0 0) with a KrF (248 nm) excimer pulsed laser (248 nm) and BCl₃ gas are reported in this paper. The doped samples are characterized by the resistance measured using a four-probe method, since the sheet resistance changes with the carrier concentration of the sample. The doping effects with the variation of laser energy density, pulse number, and the pressure of BCl₃ were investigated in terms of the sheet resistance. In this way, the optimized parameters were obtained and used for the positive heavy doping on p-Si(1 0 0) and p-Si(1 1 1). Then, using a square mesh under the above conditions, an image doping was completed. Finally, the metal–semiconductor Ohmic contacts were realized by plating Ag and Cu films on the doped surface.     

Lower-dimensional linear complementarity problem approaches to the solution of a bi-obstacle problem

A globally convergent Broyden-like method for solving a bi-obstacle problem is proposed based on its equivalent lower-dimensional linear complementarity problem. A suitable line search technique is introduced here. The global and superlinear convergence of the method is verified under appropriate assumptions.     

High performance 1689-nm quantum well diode lasers

1689-nm diode lasers used in medical apparatus have been fabricated and characterized. The lasers had pnpn InP current confinement structure, and the active region consisted of 5 pairs of InGaAs quantum wells and InGaAsP barriers.