High-lying excited states in <Superscript>10</Superscript>Be from the <Superscript>9</Superscript>Be(<Superscript>9</Superscript>Be,<Superscript>10</Superscript>Be)<Superscript>8</Superscript>Be reaction

A transfer-reaction experiment of ⁹Be(⁹Be, ¹⁰Be)⁸Be was performed at a beam energy of 45 MeV. Excited states in ¹⁰Be up to 18.80 MeV are produced using missing mass and invariant mass methods. Most of the observed high-lying resonant states, reconstructed from the α + ⁶He and t + ⁷Li decay channels, agree with the previously reported results. In addition, two new resonances at 15.6 and 18.8 MeV are identified from the present measurement. The 18.55 MeV state is found to decay into both the t + ⁷Li_g.s. and t + ⁷Li* (0.478 MeV) channels, with a relative branching ratio of 0.93 ± 0.33. Further theoretical investigations are encouraged to interpret this new information on cluster structure in neutron-rich light nuclei.     

New exact solutions of a （3＋1）-dimensional Jimbo-Miwa system

By using the (G'/G)-expansion method and the variable separation method, a new family of exact solutions of the (3+1)-dimensional Jimbo-Miwa system is obtained. Based on the derived solitary wave solutions, we obtain some special localized excitations and study the interactions between two solitary waves of the system.     

A non-standard auxiliary integrating sphere and correction method for the realization of diffuse reflectance

To realize spectral diffuse reflectance scale in 0/d geometric condition at National Institute of Metrology in China (NIM), a facility based on a non-standard auxiliary integrating sphere method with special structure has been built up and a correction method for the influence on the thickness of PTFE (polytetrafluoroethylene) coating at the port of auxiliary integrating sphere is mainly discussed. The uncertainty of spectral diffuse reflectance in NIM is approximately 0.25% (k = 2) in 380–800 nm. This facility has been used to establish China diffuse reflectance scales in the VIS–NIR part of the spectrum. This system and correction method presented in this paper can be easily implemented on most commercial spectrophotometers with a lower cost.     

线性调频信号激励过阻尼双稳系统的随机共振现象研究

线性调频信号是工程中常见的一种信号, 由于其为非周期信号, 无法以频域信噪比作为衡量其是否产生随机共振的测量手段, 故鲜有文献研究以线性调频信号为激励信号的随机共振现象. 本文利用线性调频信号在最优分数阶Fourier变换域上的能量聚集性, 首次提出以最优分数阶Fourier变换域上定义的信噪比作为测量手段, 研究了线性调频信号叠加高斯白噪声激励过阻尼双稳系统的随机共振现象, 且发现了以线性调频信号为激励信号时产生的新现象, 即随着信号频率的增大, 随机共振将逐渐减弱, 并给出了合理的解释.仿真的结果与理论分析一致, 验证了本文所提出方法的有效性. 关键词： 线性调频信号 分数阶Fourier变换 随机共振     

Preparation of TiO2-carbon surface composites with high photoactivity by supercritical pretreatment and sol-gel processing

TiO₂-carbon surface (TCS) composites were prepared by pretreatment of a sealing substrate in supercritical carbon dioxide using paraffin as a plugging agent, and sol-gel processing using tetrabutyl orthotitanate as a precursor. The samples were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), X-ray photoelectron spectrum (XPS), optical absorption spectroscopy and nitrogen absorption. The photoactivity of TCS was checked by monitoring the decomposition of methylene blue (MB) in aqueous solution under UV irradiation. The results indicated that compared with TC prepared only by the sol-gel method, the small nanosize TiO₂ particles are well dispersed on carbon surface with large amount of micropores and high Eg values, meanwhile TCS have high Ti³⁺ concentration due to supercritical pretreatment providing a amount of carbon on the composite surface with interfacial energy effects, which controls the growth of TiO₂ nanoparticles, baffles the agglomeration of TiO₂ nanoparticles and easily produces Ti³⁺ ions. These are reasons why TCS has a higher efficiency of decomposing MB than TiO₂-carbon (TC) composites and pure TiO₂. Additional, it is also attributed to the fact that TCS produce a high concentration of organic compounds near TiO₂ in comparison with TC and pure TiO₂, because their surface area are greater than that of TC and pure TiO₂.     

高温超导电缆直流测试电源平台的搭建

根据高温超导电缆测试用直流电源平台的要求,建立了硬件平台。该平台为模块化结构,具有输出精度高,便于扩展等特点;为方便操作,建立了基于LabVIEW的软件平台,对直流电源平台进行远程控制,并给出了远程控制的程序流程图,实现了电流的匀速上升和下降以及上升过程中的中断操作;利用该电源平台进行了超导电缆的临界电流测试实验,验证了直流电源平台符合高温超导电缆的测试要求。     

FAIR项目Super-FRS超导二极磁铁测试线圈的三维失超数值模拟

国际反质子与离子研究装置(FAIR)项目中的Super-FRS超导二极磁铁是一个大型温铁结构的超导磁体,由中国负责设计、研制和测试。为了研究超导线圈的性能和其设计的可靠性,前期研制了一个测试线圈。建立了一个基于ANSYS和OPERA 3D的三维失超模型,不仅将模拟结果和实验数据进行对比,更可以获得失超过程的更多细节。模型将环氧浸渍的超导线圈简化为各项异性连续介质。将ANSYS求解器用于瞬态传热过程的分析,OPERA 3D用于磁场计算,并采用ANSYS脚本语言（APDL）进行焦耳热的计算和保护电路方程的求解。模拟得到了温度、电压、电流随时间的变化曲线和失超传播过程。最后将模拟结果和测试线圈的测试结果进行了比较。     

Difference-frequency ultrasound generation from microbubbles under dual-frequency excitation

The difference-frequency (DF) ultrasound generated by using parametric effect promises to improve detection depth owing to its low attenuation, which is beneficial for deep tissue imaging. With ultrasound contrast agents infusion, the harmonic components scattered from the microbubbles, including DF, can be generated due to the nonlinear vibration. A theoretical study on the DF generation from microbubbles under the dual-frequency excitation is proposed in formula based on the solution of the RPNNP equation. The optimisation of the DF generation is discussed associated with the applied acoustic pressure, frequency, and the microbubble size. Experiments are performed to validate the theoretical predictions by using a dual-frequency signal to excite microbubbles. Both the numerical and experimental results demonstrate that the optimised DF ultrasound can be achieved as the difference frequency is close to the resonance frequency of the microbubble and improve the contrast-to-tissue ratio in imaging.