流动注射氢化物石墨炉原子吸收法的应用研究 Ⅰ.——实验装置与分析性能

氢化物石墨炉联用技术的原理是先在较低温度下将氢化物蒸气通入石墨炉并分解沉积于石墨管的内表面,然后再在高温下原子化。该法能明显提高灵敏度,消除液相和气相干扰。本文采用自制的半自动氢化物石墨炉进样系统及流动注射氢化物发生器,直接在普通石墨炉上进行氢化物石墨炉分析,研究了部分元素的测定条件,建立的方法操作方便,灵敏度高,耗样少,线性范围宽,是一种值得推广的新方法。     

大环烷构象

综述了40多年来大环烷构象的研究进展，将大环烷分为偶数和奇灵敏环分别对其构象研究进行讨论，得出大环烷构象的一般规律，并介绍了有关大环化合物构象的命名法则。     

The influence of the brewing process on the formation of biogenic amines in beers

Biogenic amines, as dabsyl derivatives, were determined in beer samples, intermediate products, and raw materials (malt and maize) by HPLC. A procedure for the extraction of the amines from malt and maize with diluted hydrochloric acid was optimised by combining a Response Surface Methodology with a Simultaneous Decision Making Approach. The results of the analysis indicate that, in brewing, technology and hygiene are the decisive factors that determine the amine concentrations in the final product.     

一阶导数光谱K系数法同时测定硝基酚钠三组分

研究和建立了同时测定硝基酚钠混合三组份的新方法——一阶导数光谱K系数法。确定了最佳实验条件和测定波长,方法简便、快速、准确。通过对动植物细胞赋活增进剂中邻硝基酚钠、对硝基酚钠、5-硝基愈创木酚钠三组份的直接测定,其相对误差小于2%,相对标准偏差小于3%,回收率为99～103%。     

ICP—AES法测定玩具材料中痕量砷,硒,锑

用电感耦合等离子体原子发射光谱法（ＩＣＰ－ＡＥＳ０测定了玩具材料中的痕量砷，硒和锑。方法简便快速，回收率为９７．５％－１０２．７％，相对标准偏差小于３％。     

Synthesis and biological evaluation of spongistatin/altohyrtin analogues: E-ring dehydration and C46 side-chain truncation

Simplified analogues of the potent antimitotic marine macrolide spongistatin 1/altohyrtin A were synthesised and evaluated as growth inhibitory agents against a range of human tumour cell lines, including Taxol-resistant strains, revealing that E-ring dehydration leads to enhanced cytotoxicity at the low picomolar level while truncation of the side-chain at C46 results in a drastic decrease in activity.     

Control of the Properties of Carbon Nanotubes Synthesized by CVD for Application in Electrochemical Biosensors

Interest in carbon nanotubes (CNT) has grown at a very rapid rate in the last decade. Their interesting physical and chemical properties open attractive possibilities in many application areas. These properties depend on the process conditions during synthesis and on subsequent purification steps. Recent studies have demonstrated that CNT can promote the electron transfer of biomolecules. These exceptional properties make them attractive for use in electrochemical biosensors. Multi walled nanotubes have been synthesized by the Chemical Vapor Deposition (CVD) method using methane as a carbon source and Ni–Al₂O₃–SiO₂ as the catalyst. The influence of the variation of certain reaction parameters such as feed gas composition, catalyst mass, temperature and reaction time in the yield of the CVD process has been established. In addition, the structural and chemical characteristics of the CNTs have been studied and a purification process to eliminate the catalyst and amorphous carbon has been developed that involves a gaseous oxidative process and acid treatment. The efficiency of the purification step has been determined by analytical techniques. Atomic force microscopy, Raman scattering, thermogravimetric analysis, inductively coupled plasma atomic spectroscopy are the characterization techniques employed in this work.     

热处理对Nylon—11结构的影响

对不同温度热处理过的Nylon－11样品，采用广角X射线衍射（WAXD），根据X射线衍射强度理论，用多重峰图解分峰方法研究了Nylon－11结构的变化，并导出了计算Nylon－11结晶度的公式．所得结果与密度法、DSC法进行了比较．同时也给出了Nylon－11的有关热力学参数，     

Thermal behavior of selected ferroelectric liquid crystals

Thermal properties of three ferroelectric liquid crystals, namely: 3-octyloxy-6-[2-fluor-4-(fluoroctyloxy)phenyl]-pyridine (FFP), 3-(3-fluor-nonyl)-6[4-heptyloxyphenyl]-pyridine (FNHPh-P), 4-[(S,S)-2,3-epoxyhexyloxy]phenyl 4-(decyloxy)benzoate (EHPhDB) were studied using heat flux differential scanning calorimetry method. All the transitions expected in this compounds, except the SmC^*-SmA^* and SmC^*-S₃ transitions, were detected in the DSC curves. The temperatures of the phase transitions and the enthalpy changes associated with them were determined. The transition from the liquid crystalline to the crystalline state showed significant hysteresis for all three compounds studied. The following transitions: SmA^*-Is, SmG^*-SmC^* for FNHPh-P, N^*-Is for EHPhDB, N^*-Is and SmC^*-N^* for FFP also showed a small hysteresis basing on which first-order character of all the above transitions was implied. All three substances studied in this work are characterized by a complex polymorphism in the solid state.The author is grateful to Dr. Stanislaw Wróbel for his stimulating interest, valuable discussions and supplying the samples. This work has been done in the framework of the KBN grant 2 P302 139 07.     

Coated-wire organic ion-selective electrodes in titrations based on ion-pair formation : Determination of arenediazonium salts with sodium tetraphenylborate

Titrimetric determinations of arenediazonium salts can be based on ion-pair formation between the diazonium cation and tetraphenylborate. Titrations are done under cooling with ice and are followed potentiometrically with organic ion-selective electrodes comprising PVC membranes plasticized with polar solvents and coated on aluminium wires. The method was tested in determinations of arenediazonium salts derived from 20 aromatic amines, including aniline, toluidines, naphthylamines and their derivatives. Except for compounds containing hydrophylic groups such as —COOH and —OH, the potentiometric titration curves have well defined end-points. The results are reproducible, with relative standard deviations in the range 0.4–1.4% at the millimolar level. The method can be used for reliable determinations of arenediazonium salts in analytical control of azo dyestuff production.