复层籽晶制备单晶畴YBCO超导块材

本文介绍了沿c轴方向排布复层籽晶制备YBCO超导单畴的方法.该方法能够使123晶畴在不同深度进行生长.通过c轴方向籽晶的排布,研究了YBCO单畴中的(001)/(001)晶界.虽然由于压模中籽晶ab面的倾斜,造成部分(001)/(001)晶界出现大角晶界,使晶界上残余有液相,但仍有晶界连接良好、晶界上不存在残余液相和211粒子、错配角小于5°的(001)/(001)晶界的形成.对于制备有深度要求的单畴块材,复层籽晶法是一种有效的生长方法.在定向控制好籽晶方向的条件下,该方法可以提高超导单畴的生长深度.在77K,0.5T下,测试该样品磁悬浮力达到37N.     

La_(0.7-x)Gd_xSr_(0.3)MnO_3(x=0.20,0.30,0.40,0.50)的TCR研究(英文)

研究了La位Gd掺杂对La0.7-xGdxSr0.3MnO3(x=0.20,0.30,0.40,0.50)体系的电阻温度系数(TCR)的影响.实验结果表明:Gd掺杂将引起电阻率曲线的急剧变化,导致出现大的TCR;而且随Gd掺杂的增加,TCR在x=0.30出现峰值,然后随掺杂量增加逐步降低.体系出现大的TCR,来源于Gd掺杂引起的额外磁性耦合.     

A Base-Emitter Self-Aligned Multi-Finger Sil-xGex/Si Power Heterojunction Bipolar Transistor

With a crystal orientation dependent on the etch rate of Si in KOH-based solution, a base-emitter self-Migned large-area multi-finger configuration power SiGe heterojunction bipolar transistor （HBT） device （with an emitter area of about 880μm^2） is fabricated with 2μm double-mesa technology. The maximum dc current gain is 226.1. The collector-emitter junction breakdown voltage BVcEo is 10 V and the collector-base junction breakdown voltage BVcBo is 16 V with collector doping concentration of 1 × 10^17 cm^-3 and thickness of 400nm. The device exhibited a maximum oscillation frequency fmax of 35.5 GHz and a cut-off frequency fT of 24.9 GHz at a dc bias point of Ic = 70 mA and the voltage between collector and emitter is VCE = 3 V. Load pull measurements in class-A operation of the SiGe HBT are performed at 1.9 GHz with input power ranging from OdBm to 21 dBm. A maximum output power of 29.9dBm （about 977mW） is obtained at an input power of 18.SdBm with a gain of 11.47dB. Compared to a non-self-aligned SiGe HBT with the same heterostructure and process, fmax and fT are improved by about 83.9% and 38.3%, respectively.     

利用红外光谱分析乙酸锌催化合成2,4-甲苯二氨基甲酸甲酯的反应机理

利用红外光谱技术研究了无水乙酸锌催化2,4-二氨基甲苯与碳酸二甲酯反应生成2,4-甲苯二氨基甲酸甲酯的甲氧基羰基化反应机理.结果表明,碳酸二甲酯羰基碳上的氧与无水乙酸锌中的Zn2+配位形成配合物,无水乙酸锌的结构由双齿型转变为单齿型,同时使DMC的羰基碳被活化.然后2,4-二氨基甲苯作为亲核试剂,其氨基进攻配合物中碳酸二甲酯上被活化的羰基碳原子,发生甲氧基羰基化反应,配合物中的Zn-O配位键断裂,生成2,4-甲苯二氨基甲酸甲酯和甲醇,并使无水乙酸锌的结构重新回到双齿型.     

ARGO-YBJ detector simulation using GEANT4

‘G4argo＇, a GEANT4-based simulation package for the ARGO-YBJ detector, is described in this paper. C4argo incorporates in the simulation the true RPC time resolution and another 0.5 ns time uncertainty which is introduced from the offline calibration of TDC. In addition, the correct RPC geometry and the true materials for the ARGO-YBJ experimental hall are implemented. As a result, G4argo simulation shows a very good agreement with real data.     

原子力显微镜微探针与光束偏转法在纳米振动检测中的应用

本文探讨了表面弹性波传播的机制,提出了一种利用原子力显微镜微探针与光束偏转法检测纳米振动的新方法,并利用这种方法对表面波质点的纳米振动进行了实时检测.当LiNbO₃晶片被施以13MHz的超高频激振电压时,在原子力显微镜示波器监视端观察到了质点的纳米振动,幅值为6.7nm,频率和驱动电压的频率一致.     

10Gb/s单信道光纤传输系统性能仿真研究

光纤传输系统的优化设计是光纤通信质量的重要保证.本文基于光子传输设计套件(PTDS)软件平台,对光纤传输系统的传输特性作了大量仿真研究,并得出分析了一些重要参量如光纤长度,光纤的损耗和衰减,光功率大小等对光传输系统的影响规律,给出了相应的补偿措施.本文研究结果对优化光纤传输系统有一定的参考价值.     

具有鲁棒性的矩形窄带滤光片的自动设计

分析了用于WDM光纤通信系统的全介质多腔窄带滤光片的膜系结构特点及其所必须具备的光学特性,提出了一种利用最优化方法的原理,通过计算机寻优来自动完成其膜系设计的方法;构造了合理的评价函数,编制了可自动搜索既满足设计目标、又具有鲁棒性的最优化膜系的计算机程序;使用本程序所设计出的多腔窄带滤光片具有较小的纹波系数和较好的矩形度,可满足WDM光纤通信系统对其分波/复波器的要求.     

Reverse reconciliation for continuous variable quantum key distribution

An efficient and practical post-processing technique based on reverse reconciliation for continuous variable quantum key distribution is proposed and simulated with low-density parity check (LDPC) codes. MultiLevel Coding/ MultiStage Decoding, which fully utilizes optimization technique such as vector quantization and iterative decoding and the optimal channel coding most close to the Shannon limit, was used to realize efficient reverse reconciliation algorithm. Simulation results showed that the proposed m...     

Fracture characteristics of concrete subjected to impact loading

This paper takes concrete as a four-phase composite made of the intact matrix and three mutually perpendicular groups of penny-shaped micro-cracks. The intact matrix is assumed to be elastic,homogeneous and isotropic,and the micro-cracks are penny-shaped. Combined with the failure mechanism of concrete subjected to impact loading,a dynamic constitutive model for concrete is developed based on Mori-Tanaka's average stress concept and Eshelby's equivalent inclusion theory. Experimental results show that concr...