Optical spectroscopy of intermetallic compounds TbNi<Subscript>2</Subscript>Mn<Subscript> <Emphasis Type="Italic">x</Emphasis> </Subscript> (<Emphasis Type="Italic">x</Emphasis> = 0, 0.5, 1)

The optical properties of intermetallic compounds TbNi₂Mn_x (x = 0, 0.5, 1) have been investigated using the ellipsometric method in the spectral range from 0.22 to 16 μm. The specific features of the modification of the dispersions of spectral characteristics with a variation in the manganese concentration have been determined. The behavior of the frequency dependences of the optical conductivity in the interband absorption region has been discussed in terms of the available data on the electronic structure of these compounds. The concentration dependences of a number of electronic parameters have been calculated.     

Influence of “ytterbium nanofilm–silicon Si(111)” interfaces on the valence of ytterbium

The work function of ytterbium films of nanometer thickness (from 1 to 16 monolayers) has been measured. The films have been prepared by sputtering of ytterbium in an ultrahigh vacuum on n- and p-type Si(111)7 × 7 silicon substrates with an electrical resistivity from 1 to 20 Ω cm. It has been shown that, in the films with a thickness of less than 8 monolayers, the work function depends nonmonotonically on the amount of ytterbium deposited on the surface (Friedel oscillations), whereas in the films with a thickness of more than 8 monolayers, the work function takes on a constant value (3.3 eV) that exceeds the work function for macroscopic samples (2.6 eV). This difference is associated with the fact that, during the formation of an Yb–Si interface, the large difference in the work functions of ytterbium and silicon (4.63 eV) leads to the transfer of a significant fraction of electrons from the metal to the semiconductor. This transfer of electrons from the film to silicon is accompanied by the lowering of the Yb 5d level below the Fermi level. As a result, the valence of the metal and, accordingly, the work function increase.     

煤矿顶板离层回归分析与稳定性评价

以光纤Bragg光栅位移传感器对淮北朱仙庄煤矿顶板离层监测为实际数据依据,选择最佳的典型函数模型对顶板离层进行非线性回归分析,得出能够反映位移发展趋势的回归曲线。监测结果与回归拟合数据表明:非线性回归分析预测方法不仅可以反映煤矿顶板离层实时变化过程,还能根据其变化趋势进行巷道稳定性判断。     

Methane Pyrolysis for Hydrogen Production: Specific Features of Using Molten Metals

Russian Journal of Applied Chemistry - Published data on noncatalytic pyrolysis of natural gas in molten metals are analyzed. The most illustrative results obtained in the past two decades are...     

驻波型热声制冷机熵产分析

声制冷机是一种新型制冷机,具有无机械运动部件,可靠性高寿命长,采用惰性气体为工质无污染等优点．驻波型热声制冷机的声功泵热效应是不可逆过程,内部不可逆损失导致热声制冷机效率偏低,制约了热声制冷机的发展和应用．本文研究了线性范围内驻波型制冷机换热器和回热器内的可压缩振荡流动与传热过程的熵产,分析了板间距,振荡频率和温度梯度对熵产的影响。     

数字散斑相关方法及其在碳纤维复合材料压力容器变形测量中的应用

提出了一种新的基于图像灰度梯度迭代的数字散斑相关方法(DSCM,digital speckle correlation method)。通过使用DSCM测量碳纤维复合材料压力容器在水压下的局部区域的位移场和应变场,分析了复合材料压力容器的轴向和环向的变形特征,为碳纤维复合材料压力容器的优化设计提供了理论和实验依据。     

基于斜向背散射偏振拉曼光谱的{100}c-Si面内应力分析

复杂应力状态下应力分量的解耦分析对半导体的设计和制造具有重要意义。本文开展了方法学研究,首先建立了{100}晶面族单晶硅面内应力分量解耦分析模型,基于该模型,通过改变入射光和散射光的几何构型和偏振构型,可得到单晶硅拉曼频移与应力分量的解析关系。在此基础上,提出了一种利用斜向背散射偏振拉曼光谱在不同倾角、偏振方向和样品旋转角度下开展原位拉曼探测实现应力分量解耦分析的实用技术。本文通过实验验证了该方法的可靠性和适用性。     

交变电场作用下骨表面温升的实验研究

骨具有力电性质,这一性质可促进骨组织生长。骨既是生理器官又是介电材料,在交变电场作用下,其表现行为可能有生理作用。为此,本文测量了骨悬臂梁试样在交变电场下的表面温升与顶端挠度。发现在电压70V,频率为10~70kHz的交流电场下,最大表面温升达到2~4℃,最大挠度变化为9.0~78.7μm;在频率10kHz,电压为70~175V的交流电场下,最大表面温升达到4~6℃,最大挠度变化为13.0~114.3μm。同时测量了两种经典介电材料有机玻璃和聚乙烯在交变电场下的温升与顶端挠度,最大温升低于0.5℃,但是挠度与骨试样相当,所以相对高温升是骨特有的性质。将交流电压有效值替换成相同幅值的直流电压时,最大温升也低于0.5℃,基本没有挠度变化,所以相对的高温升反映了骨的交流性质。分析后认为,骨在交变电场作用下的温升由胶原的介电损耗引起。实验数据显示,骨在交变电场下,表面温度变化与加载电压的平方成正比,且在实验加载的10~70kHz频段内,骨的介电常数随频率的变化明显。     

基于粒子滤波的运动目标光电定位仿真研究

运动目标的光电定位不能像静止目标那样简单做均值滤波,鉴于此,引入粒子滤波算法,它不仅可以应用于线性系统,而且还适用于非线性系统。结合光电定位需求,详细推导了计算公式及初值和参数选取公式,对只含测量噪声以及含有测量和运动噪声等的海面运动目标光电无源定位算法进行了仿真计算,验证了算法的有效性,讨论了噪声强度对滤波效果的影响,滤波参数选择对滤波效果的影响,目标运动方式对滤波跟随性的影响,重采样算法对滤波效果的影响等。所得结论为:粒子滤波可用于运动目标光电定位过程,可有效降低定位误差;粒子滤波算法具有较强鲁棒性,适用于噪声较大、目标运动形态变化大等情况。