Stored energy release behaviour of disordered carbon

The use of graphite as a moderator in a low temperature thermal nuclear reactor is restricted due to accumulation of energy caused by displacement of atoms by neutrons and high energetic particles. Thermal transients may lead to a release of stored energy that may raise the temperature of the fuel clad above the design limit. Disordered carbon is thought to be an alternative choice for this purpose. Two types of disordered carbon composites, namely, CB (made up of 15 wt. % carbon black dispersed in carbonized phenolic resin) and PAN (made up of 20 vol. % chopped polyacrylonitrile carbon fibre dispersed in carbonized phenolic resin matrix) have been irradiated with 145 MeV Ne⁶⁺ ions at three fluence levels of 1.0×10¹³, 5.0×10¹³ and 1.5×10¹⁴ Ne⁶⁺/cm², respectively. The XRD patterns revealed that both the samples remained disordered even after irradiation. The maximum release of stored energy for CB was 212 J/g and that of PAN was 906 J/g. For CB, the release of stored energy was a first order reaction with activation energy of 2.79 eV and a frequency factor of 3.72×10²⁸ per second. 13% of the defects got annealed by heating up to 700 °C. PAN showed a third-order release rate with activation energy of 1.69 eV and a frequency factor of 1.77×10¹⁴ per second. 56% of the total defects got annealed by heating it up to 700 °C. CB seems to be the better choice than PAN as it showed less energy release with a slower rate. PACS 61.80.Jh; 61.80.-x; 61.43Er; 61.43.-j; 68.43.Vx     

Dynamic programming in cricket: optimizing batting order for a sticky wicket

In cricket, a rain-affected pitch can make batting more difficult than normal. Several other conditions such as poor light or an initially lively pitch, may also result in difficulties for the batsmen. In this note, we refer to all of them as ‘sticky wickets’. On sticky wickets, lower order batsmen are often sent into ‘hold the fort’ until conditions improve. In this paper, a stochastic dynamic programming model is used to examine the appropriateness of this policy. The model suggests that the tactic is often optimal when the sticky wicket persists until the end of the day's play, but not often when the sticky wicket is transitory. In some circumstances, it is worthwhile, on a normal wicket near the end of the day, to send in a lower order batsman to hold the fort (a night watchman): when the wicket is sticky, this tactic is even more worthwhile.     

On the excitation of a closely spaced array by a line source

An infinite row of periodically spaced, identical rigid circularcylinders is excited by an acoustic line source which is parallelto the generators of the cylinders. A method for calculatingthe scattered field accurately and efficiently is presented.When the cylinders are sufficiently close together, Rayleigh–Blochsurface waves that propagate energy to infinity along the arrayare excited. An expression is derived which enables the amplitudesof these surface waves to be computed without requiring thesolution to the full scattering problem.     

A few points on omnidirectional band gaps in one-dimensional photonic crystals

The universal condition for the formation of omnidirectional band gaps (OBG) in photonic crystal (PC) was derived with consideration of permeability of the materials. And it was found that there are four kinds of PCs: one of them has no OBG, and one always possesses OBG. For the other two kinds of PCs, there are OBG for only TM or TE waves respectively. Moreover, in all PCs, the OBG can be broadened by decreasing the refractive index of the ambient medium or/and increasing the contrast between the wave impedances of the component materials of the PC. PACS 42.70.Qs; 71.20.Tx     

Self-broadening in the millimeter-wave spectrum of ozone

Self broadened widths of seven lines of ozone between 75 and 120 GHz have been measured at room temperature. The variation with temperature of the self-broadening parameter for three of these lines has been studied in the range 245–292°K.     

Dynamic response of permalloy/Cu/Co magnetoresistive sandwiches

The dynamic response of trilayer magnetoresistive permalloy/Cu/Co films was studied by high-frequency permeability spectra measurements. The resonance frequency is shown to depend on the interlayer copper thickness. This dependence is related to exchange coupling between permalloy and cobalt and the interaction field is estimated using the Landau–Lifschitz–Gilbert model.     

Mode beating in spot-size converter lasers

An anomalous modulation in the wavelength spectrum has been observed in lasers with spot-size converters. This intensity modulation is shown to be caused by beating between the fundamental lasing mode and radiation modes in the taper. This results in a periodic modulation in the net gain spectrum, which causes wavelength jumps between adjacent net gain maxima, and a drive current dependent spectral width that is expected to affect system performance. The amplitude of this spectral modulation is reduced significantly by either using an angled rear-facet which reflects the beating radiation modes away from the laser axis, or by using a nonlinear, adiabatic taper.     

Potential for micromachined actuation of ultra-wide continuously tunable optoelectronic devices

Tailored scaling represents a principle of success that, both in nature and in technology, allows the effectiveness of physical effects to be enhanced. Mutation and selection in nature are imitated in technology, e.g. by model calculation and design. Proper scaling of dimensions in natural photonic crystals and our fabricated artificial 1D photonic crystals (DBRs, distributed Bragg reflectors) enable efficient diffractive interaction in a specific spectral range. For our optical microsystems we illustrate that tailored miniaturization may also increase the mechanical stability and the effectiveness of spectral tuning by thermal and electrostatic actuation, since the relative significance of the fundamental physical forces involved considerably changes with scaling. These basic physical principles are rigorously applied in micromachined 1.55-μm vertical-resonator-based devices. We modeled, implemented and characterized 1.55-μm micromachined optical filters and vertical-cavity surface-emitting laser devices capable of wide, monotonic and kink-free tuning by a single control parameter. Tuning is achieved by mechanical actuation of one or several air-gaps that are part of the vertical resonator including two ultra-highly reflective DBR mirrors of strong refractive index contrast: (i) Δn=2.17 for InP/air-gap DBRs (3.5 periods) using GaInAs sacrificial layers and (ii) Δn=0.5 for Si₃N₄/SiO₂ DBRs (12 periods) with a polymer sacrificial layer to implement the air-cavity. In semiconductor multiple air-gap filters, a continuous tuning of >8% of the absolute wavelength is obtained. Varying the reverse voltage (U=0–5 V) between the membranes (electrostatic actuation), a tuning range of >110 nm was obtained for a large number of devices. The correlation of the wavelength and the applied voltage is accurately reproducible without any hysteresis. In two filters, tuning of 127 and 130 nm was observed for about ΔU=7 V. The extremely wide tuning range and the very small voltage required are record values to the best of our knowledge. For thermally actuated dielectric filters based on polymer sacrificial layers, Δλ/ΔU=-7 nm/V is found. Received: 10 May 2002 / Published online: 8 August 2002     

Vibrational Dynamics Studies by Nuclear Resonant Inelastic X-Ray Scattering

Nuclear resonant inelastic X-ray scattering of synchrotron radiation is being applied to ever widening areas ranging from geophysics to biophysics and materials science. Since its first demonstration in 1995 using the ⁵⁷Fe resonance, the technique has now been applied to materials containing ⁸³Kr, ¹⁵¹Eu, ¹¹⁹Sn, and ¹⁶¹Dy isotopes. The energy resolution has been reduced to under a millielectronvolt. This, in turn, has enabled new types of measurements like Debye velocity of sound, as well as the study of origins of non-Debye behavior in presence of other low-energy excitations. The effect of atomic disorder on phonon density of states has been studied in detail. The flux increase due to the improved X-ray sources, crystal monochromators, and time-resolved detectors has been exploited for reducing sample sizes to nano-gram levels, or using samples with dilute resonant nuclei like myoglobin, or even monolayers. Incorporation of micro-focusing optics to the existing experimental setup enables experiments under high pressure using diamond-anvil cells. In this article, we will review these developments. This revised version was published online in August 2006 with corrections to the Cover Date.     

Material tensor parameters of LiNbO3 relevant for electro- and elasto-optics

The complete set of self-consistent parameters of nominally undoped LiNbO₃ crystals of congruent composition that describe the electro-optic, piezoelectric, elasto-optic, elastic, and dielectric response has been determined by numerically evaluating available measurements. The parameters were determined at room temperature and consist of the low-frequency clamped dielectric constants ε^S _ij, elastic stiffness constants at constant electric field C^E _ijkl, piezoelectric stress coefficients e_ijk, elasto-optic constants at constant electric field p^E _ijkl, and clamped electro-optic coefficients r^S _ijk. It is shown that the complete set is required for calculating the effective electro-optic coefficients and dielectric constants in photorefractive applications of LiNbO₃. Received: 4 January 2002 / Revised version: 1 February 2002 / Published online: 14 March 2002