Residual Symmetry Reduction and Consistent Riccati Expansion of the Generalized Kaup-Kupershmidt Equation

The residual symmetry of the generalized Kaup-Kupershmidt(gKK) equation is obtained from the truncated Painlevé expansion and localized to a Lie point symmetry in a prolonged system. New symmetry reduction solutions of the prolonged system are given by using the standard Lie symmetry method. Furthermore, the g KK equation is proved to integrable in the sense of owning consistent Riccati expansion and some new B¨acklund transformations are given based on this property, from which interaction solutions between soliton and periodic waves are given.     

强磁场条件下金属凝固过程中第二相的迁移行为

理论分析表明,第二相的迁移行为可以通过迁移速度进行表征.影响迁移速度的因素包括第二相和熔体的物理性质、磁场强度和梯度大小、第二相的形状和体积等因素.强磁场下洛伦兹力的效果为促进第二相在基体中的均匀分布,其效率在磁场强度大于某一定值时逐渐降低.在梯度强磁场条件下,第二相迁移行为和分布状态的主要控制参数是梯度磁场下的磁化力.在磁场梯度较小时,因洛伦兹力的制约磁化力控制第二相迁移的效果不明显,随着磁场梯度的增加,磁化力的作用效果逐渐增强.通过研究强磁场下Al-Si合金、Al-Ni合金中原位自生第二相的迁移行为实 关键词： 强磁场 迁移 第二相 凝固     

光子晶体光纤拉制中工艺参数的控制

分析了光子晶体光纤拉制中各工艺参数之间的相互影响,建立了工艺参数与最终光纤结构之间的对应关系.在温度和送料速度的协调控制下,通过调节气压参数可有效控制气孔结构.实验拉制出孔径孔距比分别为0.45和0.8的单模以及高占空比光子晶体光纤.在制备非均匀孔径光子晶体光纤时,仅靠调控工艺参数往往难以拉制出理想结构,本文以一种单偏振单模PCF结构为例,对预制棒结构进行了优化设计.计算表明可由此拉制出满足要求的光子晶体光纤. 关键词： 光子晶体光纤 工艺参数 气压控制 气孔结构     

单光子LIF方法研究亚硝基苯266 nm光解动力学

用266nm激光解离亚硝基苯（C6H5NO）产生光解碎片NO,并利用单光子激光诱导荧光（LIF）技术（X^2Ⅱv″=0→A^2∑^+v′=0）测得初生态光解产物NO的振转光谱。根据计算所得的模拟光谱对光解碎片NO（X,v^″＝0）的转动量子数J″进行了归属,得到了量子数最大到J″＝50．5的转动能级的相对布居,这表面光解碎片NO具有较高的转动激发。提出了C6H5NO在266nm下可能的光解机理。     

Guided transmission of oxygen ions through Al2O3 nanocapillaries

The transmissions of oxygen ions through Al2O3 nanocapillaries each 50 nm in diameter and 10 μm in length at a series of different tilt angles are measured,where the ions with energies ranging from 10 to 60 keV and charge states from 1 up to 6 are involved.The angular distribution and the transmission yields of transported ions are investigated.Our results indicate both the existence of a guiding effect when ions pass through the capillary and a significant dependence of the ion transmission on the energy and the charge state of the ions.The guiding effects are observed to be enhanced at lower projectile energies and higher charge states.Meanwhile,the results also exhibit that the transmission yields increase as the tilt angle decreases at a given energy and charge state.     

基于偏置纳米线的石墨烯表面等离激元调制器

开发高性能的电光调制器对于构建片上光子回路非常重要.鉴于纳米线结构具备独特的电场横向束缚特点,设计一种基于纳米线的混合表面等离激元波导电光调制器,该调制器由偏置双硅纳米线、双石墨烯层以及置于双石墨烯层之间的银纳米线构成.利用二维时域有限差分算法计算分析结构参数对器件调制性能的影响.模拟结果表明,所设计的调制器在1550...     

含周期性空腔结构吸声机理的研究

为了研究水下含周期性空腔结构的吸声机理,建立并验证了含轴对称空腔周期性结构吸声特性计算的简化有限元仿真方法,用简化的有限元模型结合遗传算法对水下环境含周期性圆柱空腔结构的吸声性能进行了优化设计.从能量耗散、变形和模态的角度分析了含周期性空腔结构的吸声机理.空腔结构谐振包括表层的弯曲振动和空腔附近的径向变形,且径向运动也...     

Classify the Higgs decays with the PFN and ParticleNet at electron–positron colliders

Various Higgs factories are proposed to study the Higgs boson precisely and systematically in a model- independent way. In this study, the Particle Flow Network and ParticleNet techniques are used to classify the Higgs decays into multicategories, and the ultimate goal is to realize an "end-to-end" analysis. A Monte Carlo simulation study is performed to demonstrate the feasibility, and the performance looks rather promising. This result could be the basis of a "one-stop" analysis to measure all the branching fractions of the Higgs decays simultaneously.     

Feasibility of an experiment to determine the branching ratio for the emission of a heavy neutrino after muon capture in3He

The triton energy of the muon capture reaction ³He t+v, where ³ He is the ground state of muonic³He, has been measured in order to investigate a possible heavy v admixture into the flavour with high sensitivity. ³ He has been formed via the pd fusion reaction by stopping ^– in an ionization chamber (IC) filled with an H/D gas mixture of 3% D concentration at a pressure of 161 bar. In a first short experiment 650 triton events were observed yielding an upper limit for the -heavy v mixing strength of 2.3×10^–3 atE _0v=60 MeV.