Low-threshold, high-efficiency, high-repetition-rate optical parametric generator based on periodically poled LiNbO3

We report a high-repetition-rate optical parametric generator (OPG) with a periodically poled lithium niobate (PPLN) crystal pumped by an acousto-optically Q-switched CW-diode-end-pumped Nd:YVO_4 laser. For the maximum 1064nm pump power of 970mW, the maximum conversion efficiency is 32.9% under the conditions of 250℃, 1064nm pulse repetition rate of 22.6kHz and pulse width of 12ns, and the PPLN OPG threshold in the collinear case is less than 23.7μJ. The output power increases with the increase of the crystal temperature. The 1485－1553nm signal wave and 3383－3754nm idler wave are obtained by changing the temperature and the angle of the PPLN crystal.     

白光干涉条纹变密的原因探讨

讨论了在测定透明介质折射率的过程中彩色条纹变密的现象，并在其基础上分析其成因：一是由于媒质折射率加大；二是由于平形板介质平行度不好造成楔形的倾角变大，最后在实验中验证了理论结果。     

强激光远场焦斑重构算法研究

 通过CCD图像采集单元结合传统的列阵相机测量高功率固体激光器的远场焦斑分布，采用图像处理技术的边缘算子提取焦斑的几何中心，提出通过几何中心对心的焦斑嵌套重构算法，解决了光斑饱和时的对心难题，实现了快捷准确测量激光焦斑，为激光器的实时控制提供参考数据。     

Preparation,thermal properties,and flame retardance of epoxy–silica hybrid resins

A novel epoxy system was developed through the in situ curing of bisphenol A type epoxy and 4,4′‐diaminodiphenylmethane with the sol–gel reaction of a phosphorus‐containing trimethoxysilane (DOPO–GPTMS), which was prepared from the reaction of 9,10‐dihydro‐9‐oxa‐10‐phosphaphenanthrene‐10‐oxide (DOPO) with 3‐glycidoxypropyltrimethoxysilane (GPTMS). The preparation of DOPO–GPTMS was confirmed with Fourier transform infrared, ¹H and ³¹P NMR, and elemental analysis. The resulting organic–inorganic hybrid epoxy resins exhibited a high glass‐transition temperature (167 °C), good thermal stability over 320 °C, and a high limited oxygen index of 28.5. The synergism of phosphorus and silicon on flame retardance was observed. Moreover, the kinetics of the thermal oxidative degradation of the hybrid epoxy resins were studied. © 2003 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 2354–2367, 2003     

三层干扰下的最优无线电信道问题的研究

研究了 2 0 0 0年 MCM— B题 ,将问题推广到有三层干扰的复杂情况 ,给出并严格证明了 ( k,1,1)问题的最优解     

CreditRisk+模型下商业银行经济资本配置研究

对金融资产风险的度量与经济资本的分配应该体现分散化效应,传统的V aR方式不能保证分散化效应的次可加性.本文讨论了基于T a ilV aR这一新的风险度量与经济资本分配标准,并在违约率均值不变情况下,对C red itR isk+模型下的商业银行经济资本分配进行了实证分析.     

Reduction of dislocation density and improvement of optical quality in ZnO layers by MgO-buffer annealing

Optical properties of ZnO thin films with/without MgO-buffer annealing were investigated by low and room temperature photoluminescence measurements. The ZnO films were grown on c-sapphire substrates by plasma-assisted molecular-beam epitaxy employing a thin MgO-buffer layer. Dislocation density of ZnO layer was reduced from 5.3 × 10⁹ to 1.9 × 10⁹ cm⁻² by annealing MgO-buffer prior to the growth of ZnO. The intensity of free exciton emission from the sample with MgO-buffer annealing was almost twice of that from the sample without annealing, while the deep level emission from the sample with MgO-buffer annealing was about 1/3 of that without annealing. The MgO-buffer annealing improves optical quality of overgrown ZnO films.     

Time-Resolved Femtosecond Degenerate Four-Wave Mixing in LiNbO3：Fe,Mg Crystal

Forward degenerate four-wave mixing （DFWM） processes are investigated with a femtosecond pulsed laser in lithium niobate crystal doubly-doped with magnesium and iron （LiNbO3：Fe, Mg）. The pulse energy dependence reveals a pure third-order nonlinear response, and the third-order nonlinear susceptibility x^（3） in the material is evaluated to be 4.96 × 10^-13 esu. The time-resolved DFWM process shows a response time of x^（3） shorter than 100fs, which is due to the nonresonant electronic nonlinearities. Our results indicate that LiNbO3 crystals have potentials for ultrafast real-time optical processing systems, which require a large and fast x^（3） optical nonlinearity.     

Experimental 511 W Composite Nd：YAG Ceramic Laser

We demonstrate a 511 W laser diode pumped composite Nd：YAG ceramic laser. The optical pumping system is consisted of five laser diode stacked arrays arranged in a pentagonal shape around the ceramic rod whose size is φ6.35×144mm. When the pumping power is 1600 W, the cw laser output up to 511 W at 1064nm can be obtained with a linear piano-piano cavity, and the optical-to-optical efficiency is 31.9%. To our knowledge, this is the highest value of laser output by using a newly invented composite Nd：YAG ceramic rod as the gain medium.