溶胶-凝胶VO2薄膜转换特性研究

利用溶胶凝胶法在SiO2Si衬底上沉积高取向的V2O5薄膜,在压强低于2Pa,温度高于400℃的条件下,对V2O5薄膜进行真空烘烤,获得了电阻率变化3个数量级以上、弛豫宽度为62℃的VO2多晶薄膜.以X射线衍射(XRD)、扫描电子显微镜(SEM)图和电阻率转换特性等实验结果为依据,详细分析了溶胶凝胶薄膜在真空烘烤时从V2O5向VO2的转化,它经历了从VnO2n+1(n=2,3,4,6)到VO2的过程.实验证明,根据选择合适的成膜热处理条件和真空烘烤条件是实现溶胶凝胶V2O5结构向VO2结构成功转换的关键 关键词： 溶胶-凝胶法 氧化钒薄膜 VO2膜转换特性     

Quantitative and high mass ToF-SIMS studies of siloxane segregation in hydrogel polymers using cryogenic sample handling techniques

This paper examines the capabilities of cryogenic sample handling to examine composition and structure of hydrogel materials where siloxane components are central to the analysis. XPS analysis of multicomponent polymers with cryogenic sample handling following exposure to aqueous environments has revealed the composition and kinetics of near surface reorganization for siloxane and fluorocarbon containing polymers. In this study we report results from a ToF-SIMS protocol for cryogenic sample handling applied to the analysis of surface changes upon hydration/dehydration of hydrogel polymers. Comparison of results from angle dependent XPS and ToF-SIMS are discussed for a range of commercial soft contact lens materials. Both methods detected changes in surface chemistry between the hydrated (frozen) and dehydrated surfaces. Analysis of the hydrated surfaces detected polymer components indicative of the commercial formulation as well as ice clusters. Analysis of the dehydrated materials detected changes in surface chemistry relative to the hydrated surface in addition to loss of water due to sample dehydration. A quantitative standard additions method for ToF-SIMS data was used to determine submonolayer amounts of PDMS impurities at the surface of the hydrogels. ToF-SIMS analysis of a series of seven poly (allyl methacrylate-g-dimethylsiloxane), AMA-g-DMS, graft copolymers in the hydrated state revealed high mass oligomeric ion distributions for systems with bulk PDMS content greater than 25 wt.%. This marks the first time that detection of high mass oligomeric ion distributions from hydrated (frozen) surfaces has been reported. Analysis of the dehydrated surface detected formation of high mass oligomeric ion distributions for systems with PDMS bulk content greater than 15 wt.%, but only detected these ion distributions in wet (frozen) samples when the bulk concentration was greater than 25 wt.%.     

Preparation, characterization and photocatalytic activity of polycrystalline Bi2O3/SrTiO3 composite powders

Bi₂O₃/SrTiO₃ composite powders have been prepared and their photocatalytic activities were investigated by photooxidation of methanol. These powders were characterized by UV-Visible diffuse reflectance spectra, SEM and X-ray diffraction (XRD). The results revealed that all the Bi₂O₃/SrTiO₃ composite powders exhibited higher photocatalytic activity than pure SrTiO₃, Bi₂O₃ and TiO₂ (P25) under visible light irradiation (λ>440 nm). The effects of the Bi₂O₃ contents on the photocatalytic activities of the composite powders were examined, the photocatalytic activities increased with the content of Bi₂O₃ increasing to a maximum of 83% and then decreased under visible light irradiation. The effects of the calcination temperatures on the photocatalytic activities of the composite powders were also investigated.     

Influence of focusing depth on the microfabrication of waveguides inside silica glass by femtosecond laser direct writing

We studied the influence of focusing depth on the index change threshold and damage threshold of silica glass irradiated by a focused 120 fs laser beam. Both thresholds increased with the focusing depth. The aspect ratio of the waveguide cross section can be selected by changing the focusing depth. A 5 mm long waveguide was written at the depth of 2100 μm, which was single mode at 632.8 nm and exhibited propagation loss of 0.56 dB/cm. The refractive index change was calculated to be ∼2.47×10^-3. The influence of the focusing depth should be considered in multi-layer devices as shown in the fabrication of a 3×3 waveguide array. PACS 42.62.-b; 42.82.Et; 81.05.Kf     

一类新的表面活性剂——长链烷基三苯基鏻——Ⅵ.稳态荧光猝灭法测定十二烷基三苯基溴化鏻胶束的平均簇集数

研究了十二烷基三苯基溴化鏻(C_(12)PBr)胶束中N,N-二甲基苯胺(DMA)和二苯甲酮(DPK)对芘的荧光猝灭,发现DMA的猝灭行为不符合Stern-Volmer动态猝灭和Turro静态猝灭模型;DPK的猝灭行为不符合Stern-Volmer猝灭模型,但遵从Turro静态猝灭模型。根据DPK的静态猝灭性质测得C_(12)PBr胶束的平均簇集数为15士2,并相应地得到C_(12)PBr的临界胶束浓度为(1.77±0.09)×10~(-3)mol/L,后者与文献值一致。     

~（23）Na~（39）K分子D~1∏→X~1∑~＋激光感生荧光光谱及强度研究

实验获得了Ａｒ＋激光５１４．５ｎｍ线诱导２３Ｎａ３９Ｋ分子产生的Ｄ１∏→Ｘ１∑＋跃迁荧光谱．通过测量激光感生荧光光谱强度随泵浦功率、热管炉温度及缓冲气压变化规律，详细研究了其跃迁机制．用最小二乘法拟合获得２３Ｎａ３９Ｋ分于Ｘ１∑＋态振动常数．理论计算了各跃迁谱支波长值及Ｆｒａｎｃｋ－Ｃｏｎｄｏｎ因子和光谱强度值，与实验观测值符合得相当好，充分表明本文对激光感生荧光光谱的归属以及对各支谱线振、转量子数的赋值是合理的．     

脑细胞激活素药物的化学成分分析

采用日本岛津LC-60A型高压液相色谱仪和美国P-E3030型原子吸收分光光度计，对该药进行了氨基酸、维生素和化学元素的含量测定。结果表明，该药含有18种氨基酸，不少于3种维生素和20几种化学元素，为进一步改进该药物的合理配制方法和临床应用提供了参考数据。     

橙皮素A的NMR研究

橙皮素A是从中药北沙参(Glehnia littoralis Fr. Schmidt ex Miquel)的正丁醇萃 取物中分离得到的一种8-O-4′-型异木脂素苷类化合物. 通过化学方法和波谱分析鉴 定了该 化合物的结构. 采用2D NMR技术对其NMR信号进行了全归属. DMSO-d₆代替CD₃OD作为溶剂，并利用重水交换，能准确读出偶合常数J_7,8值.      

用峰面积判据改善Delsuc法预测的谱

基于Prony算法的Delsuc谱预测是目前NMR LPSVD(Linear Prediction SingularValue Decomposition)法中比较实用的方法。但在高噪声的条件下,时有失峰和假峰出现且要事先知道谱的峰数。本文通过跟踪迭代过程发现Delsuc法的判别因子r_(mis) 很难选定。如果它太小会失峰,而过大又会出现假峰。同时,由于噪声的影响,弱信号的采样点之间的相关性比强信号小,从而在迭代过程中会增加数值不稳定性。文中引入峰面积判据来改善Delsuc法,经模拟与实验均证明结果有效。