重金属Pb2+对玉米苗生长的影响

以水栽培的玉米幼苗为材料，用不同浓度的醋酸铅溶液处理后，分别在第10天、第20天、第30天对玉米苗的根、茎、叶分别进行Pb^2＋含量测定。分析结果：Pb^2＋在玉米体内的分布表现为根〉叶〉茎；玉米中的叶绿素含量均降低；随着Pb^2＋浓度的增大，玉米细胞的膜透性表现根〉叶〉茎依次升高；Pb^2＋对玉米的伤害率的大小表现为根〉叶〉茎。该实验为进一步研究农作物对重金属Pb^2＋的耐性和重金属Pb^2＋在农作物体内的分布提供了可参考的数据。     

端面泵浦掺Yb3+双包层光纤激光器

从双包层光纤激光器的速率方程出发，得到了光纤中泵浦光与激光的功率分布、输出功率与泵浦功率的关系、腔镜反射率及光纤长度对输出功率的影响。研究结果表明：输出激光功率与光纤长度及后腔镜反射率有很强的依赖关系，存在一个输出功率最大的最佳光纤长度。后腔镜反射率越大，输出激光功率越小；当光纤长度较短时，在输出端放置反射镜使泵浦光高反射，可以提高输出功率和效率。通过对端面泵浦掺Yb3+双包层光纤激光器进行理论分析和实验研究，得到输出激光的中心波长为1088.3nm，斜率效率为33.7%，最大输出功率为1.75W。     

黄芪成分F3新制剂的工艺监测

对黄芪成分F3新制剂中多糖、蛋白质进行了工艺监测，多糖提取达99．2％，蛋白质≤0．2％，符合黄芪成分F3的质量标准要求，达到了选择最佳提取工艺的目的，结果令人满意。     

�۱��ƫ��������ˮ��������ǿ�����������о�

By using Fluent software with the Eulerian multiphase model and Non-equilibrium boiling model, the subcooled flow boiling heat transfers was numerically simulated in the plain upward vertical tubes under the condition of one-side heating. The influences of the different mass flux, inlet temperatures and heat flux on the heat transfer coefficient, the void fraction and heat transfer deterioration were investigated.     

Synthesis of poly(ethylene oxide) with pending 2,2,6,6‐tetramethylpiperidine‐1‐oxyl groups and its further initiation of the grafting polymerization of styrene

A new stratagem for the synthesis of amphiphilic graft copolymers of hydrophilic poly(ethylene oxide) as the main chain and hydrophobic polystyrene as the side chains is suggested. A poly(ethylene oxide) with pending 2,2,6,6‐tetramethylpiperidine‐1‐oxyls [poly(4‐glycidyloxy‐2,2,6,6‐tetramethylpiperidine‐1‐oxyl‐co‐ethylene oxide)] was first prepared by the anionic ring‐opening copolymerization of ethylene oxide and 4‐glycidyloxy‐2,2,6,6‐tetramethylpiperidine‐1‐oxyl, and then the graft copolymerization of styrene was completed with benzoyl peroxide as the initiator in the presence of poly(4‐glycidyloxy‐2,2,6,6‐tetramethylpiperidine‐1‐oxyl‐co‐ethylene oxide). The polymerization of styrene was under control, and comblike, amphiphilic poly(ethylene oxide)‐g‐polystyrene was obtained. The copolymer and its intermediates were characterized with size exclusion chromatography, ¹H NMR, and electron spin resonance in detail. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 3836–3842, 2006     

SD对壳模型: 偶偶Pt核低激发态性质

利用SD对壳模型讨论了偶偶Pt核低激发态的集体性质. 结果发现在该模型下, 利用一个仅含有3个参数的哈密顿量, 可以很好地再现偶偶Pt核低激发谱的集体性质.     

NiTi合金相变过程中界面动力学的内耗研究

本文采用同时测量内耗、模量及电阻的方法,对NiTi合金变温过程中所发生的正、反马氏体相变及可逆I/C相变进行了系统的研究。结果表明,变温马氏体相变及I/C相变过程中内耗均为粘弹性型内耗,是相界面在克服粘滞性阻力而运动时引起的。从界面动力学出发,研究了相变过程中界面的运动动力学行为。由实验数据求得了马氏体相变过程中界面动力学关系的具体表达式为:V=V^*exp(—△G^*/△G—△G_R);相变过程内耗表达式为:Q^-1=(n²)/2·(μ△G^*)/((△G—△G_R)²)·(dF)/(dT)·T/ω;相变阻力△G_R约为10cal/mol的数量级。讨论了相变过程中的“软模”效应。马氏体相变过程中的模量“软化”来自声子模的软化和界面运动引起的附加模量亏损两个方面。 关键词：     

一步法合成苯乙烯催化剂表面积炭对活性的影响

应用ＥＳＲ，空气气氛下ＤＴＡ，氢气氛下ＴＰＳＲ，ＩＲ等技术手段，对反应后催化剂的积炭行为进行了研究。结果表明，反应后的催化剂表面不同程度地存在着不同类型和积炭，积炭是催化剂失活的主要原因。     

苯部分加氢制环己烯的非晶态Ru-M-B/ZrO2催化剂的表征

采用化学还原法，制备了高活性，高选择性非晶态RU-M-B/ZRO2催化剂，并将其用于催化苯部分加氢制环己烯，在140℃、5.0Mpa氢压下，苯转化40%时，环己烯选择性达到85%左右。环己烯最高收率达到52.1%，用XRD、SEM、BET比表面积测定等手段对摧化剂进行表征，XRD和SEM测试表明，RU-U-B/ZRO2属于非晶态，活性组分高度分散，XRD结果证实，在加氢过程中，非晶分解，RU晶化；温度愈高，RU晶化愈快，催化剂的活性、选择性与RU微晶的粒径有关，RU微晶粒径应控制在5nm左右，BET比表面积测定表明，ZRO2的负载提高了催化剂的比表面积，从而有利于活性组分的高度分散，并可阻止RU微晶的长大，讨论了B和ZRO2对提高选择性的作用。     

A Novel Organic—Inorganic Complex：Synthesis and Crystal Structure of [Ca（DMSO）5（H2O）]2 SiMo12O40

It is becoming a focus to synthesize and assemble organic-inorganic materials, especially, to synthesize charge-transfer complexes formed by polyoxometalate and organic donors. They have attracted much attention because such complexes are active in their electric, magnetic and optic properties1-4, many investigations about them have been done and some crystal structures of them were reported5-6. But, the disadvantage of these crystals is instability at room temperature. According to the view…