热声斯特林发电系统的实验研究

本文介绍了一台由热声斯特林发动机及其驱动的直线发电机组成的热声斯特林发电系统原理样机.一方面为满足发电机与发动机间体积流率和相位的匹配要求,另一方面为了能在直线发电机活塞处获得较好的压力波与体积流率间相位关系、提高直线发电机的电功输出能力,装置保留了发动机原有的锥形谐振管.初步实验以氦气为工质,在2.5MPa平均压力、64Hz工作频率下,获得了97W的电功.本文还分析了该热声发电系统的效率,得出直线发电机声电转换效率超过了0.8.然而由于谐振管耗散了大量的声功,目前整机的热电转换效率还较低.     

Traveling wave solutions for two nonlinear evolution equations with nonlinear terms of any order

In this paper, based on the known first integral method and the Riccati sub-ordinary differential equation (ODE) method, we try to seek the exact solutions of the general Gardner equation and the general Benjamin-Bona-Mahoney equation. As a result, some traveling wave solutions for the two nonlinear equations are established successfully. Also we make a comparison between the two methods. It turns out that the Riccati sub-ODE method is more effective than the first integral method in handling the proposed problems, and more general solutions are constructed by the Riccati sub-ODE method.     

光纤分布式扰动传感器中瑞利和受激布里渊散射光谱特性及其影响研究

针对光纤分布式扰动传感器长距离应用定位误差增大的问题,研究了传感器长距离光纤中的瑞利散射和受激布里渊散射的光谱特性及其对系统定位精度的影响.建立了长距离光纤中瑞利和受激布里渊散射的数学模型,通过仿真研究发现散射光波的杂波干涉和强度噪声会严重降低干涉仪的光学信噪比,从而导致定位误差.通过实验验证了仿真结果的正确性.研究结...     

基于ARM的核磁共振波谱仪气动温控系统设计

提出了一种基于ARM（Advanced RISC Machine,先进精简指令计算机）的核磁共振波谱仪气动温控系统设计方案. 该控制系统以ARM为控制器,利用其内嵌的CAN控制器实现CAN总线通信,通过PID控制算法控制气流和温度,实现控制NMR实验样品的更换和旋转,检测并控制样品的温度等功能. 该设计方案具有系统控制灵活、控制精度高以及成本低的优点.      

一种测试小分子迁移的新方法

针对高聚物材料中小分子的迁移现象,结合数字图像处理技术,提出了一种基于钠光和斐索等厚原理的光学干涉法.介绍了系统测试原理,针对光学系统的设计作了详细的分析与计算;通过实验测试,设计的光学系统能够采集到清晰的干涉条纹,且满足测试精度要求,由条纹间距随时间的变化测出了丙酮和乙醇小分子迁移时高聚物折射率的变化规律为:丙酮小分...     

Characterizing the properties of ultrasonics propagating on the surface of materials with defect by Laser-ultrasonics method

A laser ultrasonics method is used to characterize the propagation properties of surface wave traveling on the surface of materials with sub-surface defect in 2D.Linear and nonlinear propagation properties of ultrasonics caused by the defects have been detected in experiment. A theoretical model is proposed and used to study the linear and nonlinear properties of ultrasonics caused by the defect.The numerical results indicate that the nonlinear ultrasonic wave will be excited when a finite amplitude ultrasonics propagates on the surface of materials with sub-surface defect.The theoretical analysis confirms that the nonlinear wave is caused by the "clapping"of the interface of defect instead of the mode conversions of ultrasonics.     

Preparation and properties of SnS film grown by two-stage process

SnS films have been prepared by a novel two-stage process. It involved sputtering of Sn film on glass substrate and sulfurization of the thin metallic tin precursor layers in a vacuum furnace. The X-ray diffraction results showed that the SnS layers had orthorhombic structure and (0 4 0) preferential growth is more and more obvious with the increase of sulfurization time. The SnS film obtained by this work shows high optical absorption efficiency, and the film has a direct optical band gap of about 1.3 eV. The films show p-type conductivity and the resistivity of SnS film decreased obviously under illumination.     

Microstructure, optical and static recording properties of AgOx film, and near-field simulation of sub-wavelength aperture based on the AgOx marks’ formation

Structures, spectra and surface topographies of as-deposited and annealed AgO_x films have been investigated by an X-ray diffractometer, a spectrophotometer and an atomic force microscopy (AFM). X-ray diffraction and spectrum results show that the as-deposited AgO_x films with high oxygen ratios (x≥0.5) are in amorphous states and Ag crystalline particles will separate out after annealed. AFM results show that the film surface will become much rougher and film thickness will increase greatly after annealed due to the decomposition of AgO_x with release of oxygen. Static recording results show that two microstructures of the recording marks can be produced: one is the bubble mark at a low recording power and the other is the rupture bubble with an ablated aperture (hole) in the center at a high recording power. Based on the formation of rupture bubble marks, the near-field optical distribution of a focused Gaussian laser beam through a sub-wavelength aperture (200 nm in diameter) has been simulated using finite-difference-time-domain (FDTD) method. Results show that the spot size can be greatly squeezed with still highly transmitted intensity, which may lead to the super-resolution readout.     

烧结温度、La掺杂对Bi_(1-x)La_xMnO_3结构及磁性能的影响

用溶胶-凝胶(so-lgel)法制备了多铁Bi1-xLaxMnO3(BLMO,0.1≤x≤0.4)系列样品.样品的结构表征(X-射线衍射,扫描电子显微镜)及差热-热重(TG-DTA)分析测量显示,形成稳定的BLMO钙钛矿相的烧结温度位于900~950℃.La掺杂对BLMO样品(950℃烧结)的结构和磁性能的影响也被仔细研究.结果显示,随着La掺杂减少,样品中BLMO钙钛矿相减弱,铁磁转变温度(TC)由53K降至41K,而饱和磁化强度经历了先降低再升高的变化.这可归因于La含量较少的样品中Bi空位浓度的增加诱导了Mn-O-Mn键角的减小和局域Mn4+离子的增多,使得Mn3+和Mn4+离子的铁磁超交换增强和Mn3+离子的dz2轨道有序受到局域破坏.     

地方综合性大学“热学”精品课程建设的探索

精品课程建设是高等学校提高教学质量的重要措施之一,地方综合性大学进行精品课程建设应该依托地方优势、突出地方特点.文章从人才培养目标、教材建设、师资队伍、教学方法和手段等方面对地方综合性大学“热学”精品课程的建设进行了探索和研究.