THE ANNEALING FEATURES OF Ta/Si MULTILAYER FILMS

The Ta/Si multilayers on (100) Si substrate have been studied over the annealing temper-ature range from 500 to 900℃ by X-ray diffraction and cross-section transmission electron microscopy. The periodicity of the multilayers becomes worse with increasing annealing tem-perature and disappears at 750℃. At 600℃, two kinds of modulation wavelength coexist because the size of several TaSi₂ grains is larger than the contracted original modulation wavelength. The films are contracted after annealing. The largest contraction, at least 40nm decreasing in thickness, occurs at 600℃. When the annealing temperature is lower than 600℃, h-TaSi₂ grains grow randomly and the growth is not affected by the substrate. At temperatures higher than 750℃, h-TaSi₂ grows preferentially in [001] direction parallel to [100] axis of Si substrate. The appearance of texture depends on whether the atomic diffusion is short range or long range at the corresponding annealing temperature.     

BEPCⅡ高频发射机和环流器的调整和测试

北京正负电子对撞机升级改造工程(BEPCⅡ)将采用的频率500MHz、输出功率250kW的高频发射机和环流器已安装、调整、测试和验收完毕,这是国内建立的第一套500MHz/250kW发射机系统.本文将详细介绍机器的调测试的原理和各项测量内容及结果, 并比较设计指标和要求,来阐述此发射机的实际技术指标和测试性能.     

Gd3+对Ca0.8Zn0.2TiO3:Pr3+红色发光材料的敏化作用

采用溶胶-凝胶法在较低温度下合成了红色发光材料Ca0.8Zn0.2TiO3:0.002Pr3 ,xGd3 .金属离子预先溶解含有柠檬酸的乙二醇溶液中.XRD表明在800℃灼烧2h形成了钛酸盐的晶体.荧光检测结果表明所合成样品的特征激发峰为330nm、特征发射峰为614nm,分别对应于O(2p)→Ti(3d)带间跃迁和Pr3 的1D2→3H4的特征发射.样品的发光强度随x的不同而不同,发光强度增强了29%-69%.当x＝0.0005时,即nPr3 :nGd3 ＝4∶1时样品的红色发光强度最强,发光强度增强了69%.     

高绝缘体中的极化子

应用特殊的锁相放大器,在-20℃至180℃范围内测量了三种高绝缘体的表面和体电导,观察到传导极化子的跳跃导电和能带导电;LiNbO₃,中两种导电态的转变温度为38℃,传导极化子可以被陷阱俘获而成为束缚极化子。后者不是载流子,但在外电场作用下能产生位移运动而提供超低频电极化效应。LiNbO₃和LiTaO₃的表面存在大量铁电屏蔽电荷,但它们的表面传导电流却不比玻璃的大,而是提供了特别大的位移电流。显得这些屏蔽电荷是处于束缚极化子态,在45,75 关键词：     

Particle-number conserving analysis for the 2-quasiparticle and high-K multi-quasiparticle states in doubly-odd 174,176Lu

Two-quasiparticle bands and low-lying excited high-K four-, six-, and eight-quasiparticle bands in the doubly-odd ^{174, 176}Lu are analyzed by using the cranked shell model (CSM) with the pairing correlations treated by a particle-number conserving (PNC) method, in which the blocking effects are taken into account exactly. The proton and neutron Nilsson level schemes for ^{174, 176}Lu are taken from the adjacent odd-A Lu and Hf isotopes, which are adopted to reproduce the experimental bandhead energies of the one-quasiproton and one-quasineutron bands of these odd-A Lu and Hf nuclei, respectively. Once the quasiparticle configurations are determined, the experimental bandhead energies and the moments of inertia of these two- and multi-quasiparticle bands are well reproduced by PNC-CSM calculations. The Coriolis mixing of the low-K (K=|Ω₁-Ω₂|) two-quasiparticle band of the Gallagher-Moszkowski doublet with one nucleon in the Ω = 1/2 orbital is analyzed.     

远程控制在大功率固体激光加工系统中的应用

针对目前大功率固体激光加工系统的特点,结合相关产品使用的网络构架,研制开发了一套基于Internet的远程监控系统。它是一种将网络技术与系统监控相结合,在异地通过Internet实时监控系统的运行状态,并为系统的故障诊断提供依据的技术。该系统具有高效性、准确性和实时性等特点。在设计方面采用了先进的软件构架,可以实时监控激光加工系统的操作情况和参数状态;查询激光加工系统的当前数据和历史数据,并对开放权限的数据进行修改;通过和用户在线沟通完成疑难问题的解答。     

射频离子源束流特性分析

介绍了为HL-2A 装置设计的引出束功率为1MW 的射频离子源研制情况。目前,在测试平台上,该离子源已经成功引出了束能量和束电流分别为35keV 和12.4A、束质子比为79%、脉宽为100ms 的氢离子束,达到了其设计束功率的44%。用红外热成像的方法测量了离子束能量密度分布。结果表明,在距离引出系统地电极 1.3m 处,束密度分布遵循高斯分布。引出束的最佳导流系数为1.689×10^–6A•V^-3/2 左右,随射频功率改变有较小的变化。根据这些实验结果,采取了相关改进措施来改善离子源的引出束性能。     

8 mm回旋行波管和返波管的三折螺旋波纹波导色散分析

 三折螺旋波纹波导使TE11模和TE21模相互耦合,其色散曲线能够在宽频带内与电子回旋共振,因此需要对色散方程进行研究。提出了适合工程实用的行波模式和返波模式的色散方程,并对方程中的耦合系数进行了简化,误差在1%左右。利用CST软件的VBA语言对螺旋波纹波导进行建模和计算,根据模拟得到的传输特性曲线的特点,提出一种模拟方法,将模拟与理论计算得到的色散曲线作对比,误差在5%左右。     

Quantum Effects of a Dissipative Mesoscopic Circuit with Mutual Inductance

We study the quantum fluctuations of the charge and current of two L-C dissipative mesoscopic circuit with the mutual inductance in the vacuum state.Our results show that the system state will evolve to a squeezed coherent state under the effect of external source.We find that the squeezing amplitude parameter is relative to the parameters of circuit and the mutual-inductance coefficient in the existence of dissipation.When the circuit has no dissipation or there is complete coupling between two meshes,the squeezing amplitude parameter only depends on the capacitance‘s ratio.