A laser Doppler anemometry technique for Reynolds stresses measurement

A technique is described for the measurement of all components of mean velocity and Reynolds stresses, in a complex turbulent flow where achieving coincidence data acquisition is difficult. The method is based on data recorded using four orientations of the laser probe. It is shown that the measurement errors are not the same for all the components of the Reynolds tensor, but they are sufficiently small to give a good accuracy. An application to a turbomachinery flow is given to illustrate the method.     

On the orthogonality of natural modes of vibration

The natural modes of a discrete linear system are orthogonal with respect to the mass and stiffness matrices in a generalized sense. However, these modes are usually not orthogonal to each other in the ordinary sense. The purpose of this paper is to document a number of conditions under which the modes are also orthogonal in an ordinary fashion.     

Nano-tribological study on a super-hydrophobic film formed on rough aluminium substrates

A novel super-hydrophobic stearic acid (STA) film with a water contact angle of 166^o was prepared by chemical adsorption on aluminum wafer coated with polyethyleneimine (PEI) film. The micro-tribological behavior of the super-hydrophobic STA monolayer was compared with that of the polished and PEI-coated Al surfaces. The effect of relative humidity on the adhesion and friction was investigated as well. It was found that the STA monolayer showed decreased friction, while the adhesive force was greatly decreased by increasing the surface roughness of the Al wafer to reduce the contact area between the atomic force microscope (AFM) tip and the sample surface to be tested. Thus the friction and adhesion of the Al wafer was effectively decreased by generating the STA monolayer, which indicated that it could be feasible and rational to prepare a surface with good adhesion resistance and lubricity by properly controlling the surface morphology and the chemical composition. Both the adhesion and friction decreased as the relative humidity was lowered from 65% to 10%, though the decrease extent became insignificant for the STA monolayer. The project supported by the National Natural Science Foundation of China (50375151, 50323007, 10225209) and the Chinese Academy of Sciences (KJCX-SW-L2)     

Photorefractive Four-Wave Mixing Switches Utilizing Pockels Effect -Longitudinal and Lateral Switches-

We carried out detailed calculations for photorefractive wave-mixing switches based on one of three crystals with high electro-optic coefficients, namely, BaTiO₃, Strontium Barium Niobate (SBN (0.75)), and Potasium Sodium Strontium Barium Niobate (KNSBN). A comparison of results for the three crystals shows that a 0_-cut BaTiO³ crystal is suitable for a longitudinal switch and requires a voltage of about 80 for a 2-mm-thick crystal to induce sufficient phase mismatch. The electrodes must be transparent for the incident and diffracted beams. A 45_-cut SBN (0.75) crystal, however, is suitable for a lateral switch and requires a voltage of about 150 for a 1-mm-wide crystal. The electrodes do not need to be transparent.     

Decay kinetics of the green emission in tungstates and molybdates

Luminescence characteristics of a number of undoped and variously doped PbWO₄ crystals were studied at 0.4–400 K by the time-resolved spectroscopy and compared with those of ZnWO₄,CdWO₄ and PbMoO₄ crystals. Two types of green emission centres are detected in PbWO₄ crystals. The centres of the first type are responsible for the low-temperature 2.3–2.4 eV emission observed under excitation around 3.90–3.95 eV. The structure and parameters of their relaxed excited states were determined. It was concluded that the origin of defects responsible for the green emission of the first type could vary for different crystals. The centres of the second type with the emission around 2.5 eV appear in crystals containing oxygen vacancies after the thermal destruction of Pb⁺-WO₃ centres at T>180 K. Decomposition of the exciton and various defect-related states was also studied, and activation energies of this process were calculated.     

Rare earth photoionization study by the resonant microwave cavity technique

Photoconductivity spectra of rare earth-doped insulating materials are measured using the resonant microwave cavity method. This technique is based on the detection of the cavity Q-factor changes induced by irradiation of the sample (inserted in the cavity) by a pulsed tunable laser. Results obtained with Lu₂(SiO₄)O:Ce³⁺ and BaF₂:Eu²⁺ are presented and discussed. Photoionization thresholds at 400 nm (3.1 eV) and 310 nm (4.0 eV) are measured for Lu₂(SiO₄)O:Ce³⁺ and BaF₂:Eu²⁺, respectively.     

Errata: “Universality in Orthogonal and Symplectic Invariant Matrix Models with Quartic Potential”

The errata concern mainly the last computations for the universality of the local statistics of eigenvalues at the edge of the spectrum in parts (iii) of Theorems 2.3 and 2.4.     

Forces along Equidistant Particle Paths

Two particles on the sphere leave the equator moving due south and travel at a constant and equal speed along a geodesic colliding at the south pole. An observer who is unaware of the curvature of the space will conclude that there is an attractive force acting between the particles. On the other hand, if particles travel at the same speed (initially parallel) along geodesics in the hyperbolic plane, then the particle paths diverge. Imagine two particles in the hyperbolic plane that are bound together at a constant distance with their center of mass traveling along a geodesic path at a constant velocity, then the force due to the curvature of the space acts to break the bond and increases as a quadratic function of the velocity. We consider this problem for the sphere and the hyperbolic plane and we give the exact formula for the apparent force between the particles. This revised version was published online in July 2006 with corrections to the Cover Date.