Dramatic enhancement of optical-field-ionization collisional-excitation x-ray lasing by an optically preformed plasma waveguide

Dramatic enhancement of optical-field-ionization collisional-excitation x-ray lasing is achieved by using an optically preformed plasma waveguide. With a 9-mm-long pure krypton plasma waveguide prepared by using the axicon-ignitor-heater scheme, lasing at 32.8 nm is enhanced by 400 folds relative to the case without the plasma waveguide. An output level of 8 x 10(10) photon/shot is reached at an energy conversion efficiency of 2 x 10(-6). The same method is used to achieve x-ray lasing in a gas jet for the high-threshold low-gain transition at 46.9 nm in neonlike argon.     

Development and validation of a high-performance liquid chromatographic method using fluorescence detection for the determination of vardenafil in small volumes of rat plasma and bile

A new, simple and sensitive high-performance liquid chromatography (HPLC) method with fluorescence detection was developed and validated for the determination of vardenafil in small volumes of rat plasma and bile. The absorbance and fluorescence characteristics of vardenafil were studied and factors that affect the HPLC resolution and fluorescence intensity were examined and optimized. Vardenafil and the internal standard cisapride were extracted using acetonitrile. The separation was achieved on a C18 column at 35 degrees C using acetonitrile-50 mM ammonium acetate aqueous solution (pH 6.8) (40:60) as mobile phase. At a flow rate of 1 ml/min, the total run time was 18 min. Fluorescence was measured with excitation and emission set at 280 and 470 nm, respectively. The calibration curves were linear from 10 to 1000 ng/ml and 0.2-100 microg/ml for plasma and bile samples, respectively. The intra- and inter-day imprecision did not exceed 10.8%, and the accuracy was within 9.6% deviation of the nominal concentration. The method was used successfully to investigate the disposition and biliary excretion of vardenafil in rats.     

A simple polysilsesquioxane sealing of nanofluidic channels below 10 nm at room temperature

We present a simple sealing method to fabricate nanofluidic channels, where plasma treated polysilsesquioxane (PSQ) thin film on a rigid support is used to bond to a hydrophilic glass surface permanently at room temperature. This method shows precise dimension control below 10 nm with easy experimental setup. Using this method, one dimensional confined shallow nanochannels with a depth as small as 8 nm and an aspect ratio of <4 x 10(-5), two dimensional confined nanochannel arrays, and integrated nano/microchannel devices with a micro-to-nano interface have been demonstrated. Smooth transfer of DNA fragments from microchannel to nanochannel through the interface area was observed.     

Iridium(I) pyridyl azolate complexes with saturated red metal-to-ligand charge transfer phosphorescence; fundamental and potential applications in organic light-emitting diodes

Preparation of a new series of neutral metal complexes [(cod)Ir(fppz)] (1), [(cod)Ir(bppz)] (2), [(cod)Ir(fptz)] (3) and [(cod)Ir(bptz)] (4), bearing one cod ligand and a pyridyl azolate chelate are reported. A single-crystal X-ray diffraction study of 3 reveals the expected distorted square-planar geometry. The lowest absorption band consists of IrI atom increased triplet dpi-->pi* transitions (3MLCT), the assignment of which is firmly supported by the theoretical approaches. Complexes 1-4 exhibit weak phosphorescence in degassed solution at room temperature, whereas much more intense, solid-state phosphorescence appears in the range 622-649 nm. The pure MLCT emission was used as a prototypical model to address its remarkable spectral differences from the IrIII isoquinoline pyrrolide complex (5), which has mainly 3pipi phosphorescence. Complex 3 was used as a dopant to fabricate red-emitting phosphorescent organic light-emitting diodes (OLEDs). For the 7 % doped device, a maximum brightness of 3010 cd m-2 was achieved at an applied voltage of 15 V and with CIE coordinates of (0.56, 0.33), demonstrating for the first time the potential of neutral IrI complexes in OLED applications.     

Color tuning associated with heteroleptic cyclometalated Ir(III) complexes: influence of the ancillary ligand

We report the preparation of a series of new heteroleptic Ir(III) metal complexes chelated by two cyclometalated 1-(2,4-difluorophenyl)pyrazole ligands (dfpz)H and a third ancillary bidentate ligand (L=X). Such an intricate design lies in a core concept that the cyclometalated dfpz ligands always warrant a greater pi pi* gap in these series of iridium complexes. Accordingly, the lowest one-electron excitation would accommodate the pi* orbital of the ancillary L=X ligands, the functionalization of which is then exploited to fine-tune the phosphorescent emission wavelengths. Amongst the L=X ligands designed, three classes (series 1-3) can be categorized, and remarkable bathochromic shifts of phosphorescence were observed by (i) replacing the 2-benzoxazol-2-yl substituent (1a) with the 2-benzothiazol-2-yl group (1b) in the phenolate complexes, (ii) converting the pyridyl group (2a) to the pyrazolyl group (2b) and even to the isoquinolyl group (2c) in the pyrazolate complexes and (iii) extending the pi-conjugation of the benzimidazolate ligand from 3a to 3b. Single-crystal X-ray diffraction study on complex [(dfpz)Ir(bzpz)] (2b) was conducted to confirm their general molecular architectures. Complex 2b was also used as a representative example for fabrication of multilayered, green-emitting phosphorescent OLEDs using the direct thermal evaporation technique.     

Polybenzoxazine as a mold-release agent for nanoimprint lithography

One of the most important tasks remaining to be resolved in nanoimprint lithography is the elimination of the resist sticking to the mold during demolding. Previously, the main approach was to apply a thin layer of fluorinated alkyl silane mold-release agent on the surface on the mold; however, this involves complicated steps and high costs. The low surface free energy material polybenzoxazine provides an efficient mold-release agent for silicon molds that is easier to process, costs less, and has no side reactions.     

Isomerization reactions of RSNO (R=H,C<Subscript><Emphasis Type="Italic">n</Emphasis></Subscript>H<Subscript>2<Emphasis Type="Italic">n</Emphasis>+1</Subscript><Emphasis Type="Italic">n</Emphasis>≤ 4)

We have applied various theoretical methods to gain detailed insights into the isomers as well as the transition states (TSs) along the corresponding reaction pathways for RSNO (R=H, C _n H_2n+1 n ≤ 4). On the basis of G2 and G2MP2 results, the relative order of stability for R=H is estimated to be trans-HSNO > cis-HSNO > HNSO > cis-HONS trans-HONS, while it is cis-CH₃SNO trans-CH₃SNO > CH₃NSO > trans-CH₃ONS > cis-CH₃ONS for R=CH₃. A similar trend is also obtained from the B3P86 method with considerably less computing effort if the nearly isoenergetic isomers cis-HONS and trans-HONS are ignored. Based on the results of B3P86, cis-RSNO is more stable than trans-RSNO when R=H is replaced by alkyl groups except for R=t-Bu. Natural bond orbital analyses allow us to explore whether the high reactivity of S-nitrosothiols is due to the strong negative hyperconjugation (). The mesomeric effect of S-nitrosothiols, although non-negligible, does not cause the breakage of N–O bond due to the compensation of columbic attraction between N and O.Electronic Supplementary Material Supplementary material is available for this article at and is accessible for authorized users.     

Interfacial Engineering for Oriented Crystal Growth toward Dendrite-Free Zn Anode for Aqueous Zinc Metal Battery

Zn deposition with a surface-preferred (002) crystal plane has attracted extensive attention due to its inhibited dendrite growth and side reactions. However, the nucleation and growth of the Zn(002) crystal plane are closely related to the interfacial properties. Herein, oriented growth of Zn(002) crystal plane is realized on Ag-modified surface that is directly visualized by in situ atomic force microscopy. A solid solution HCP-Zn (~1.10 at. % solubility of Ag, 30 °C) is formed on the Ag coated Zn foil (Zn@Ag) and possesses the same crystal structure as Zn to reduce its nucleation barrier caused by their lattice mismatch. It merits oriented Zn deposition and corrosion-resistant surface, and presents long cycling stability in symmetric cells and full cells coupled with V₂O₅ cathode. This work provides insights into interfacial regulation of Zn anodes for high-performance aqueous zinc metal batteries.     

Chaotic behaviour of the general symbolic dynamics

This paper extends symbolic dynamics to general cases. Some chaotic properties and applications of the general symbolic dynamics (∑(X),σ) and its special cases are discussed, where X is a separable metric space.     

Inf-dif-stability of oblique perturbation

Laurent and Rockafellar have studied certain problems of perturbation and of stability in convex minimization problems. Laurent has discussed inf-dif-stability conditions respectively for horizontal perturbation and for vertical perturbation. In this paper, we generalize some results of Laurent^[1] by giving several inf-dif-stability conditions of oblique perturbation.Project supported by the National Natural Science Foundation of China.