Multicommuted fluorometric multiparameter sensor for simultaneous determination of naproxen and salicylic acid in biological fluids.

A combined approach based on solid-phase optosensing and multicommutation principles has been applied to develop a method for the simultaneous analysis of two pharmaceuticals (naproxen and salicylic acid) in biological fluids. The multicommuted flow-through optosensor was based on direct native fluorescence measurements of both analgesics using a non-polar sorbent (C18 silica gel) as a solid sensing zone. The flow system was controlled by Java-written home-made software and designed using three-way solenoid valves for an independent automated manipulation of sample and carrier solutions. Using an optimized sampling time, the method was calibrated in the range of 1 - 25 and 5 - 200 ng mL(-1). The obtained detection limits were 0.3 and 1.3 ng mL(-1) for naproxen and salicylic acid, respectively, with RSD (%) values of better than 2% for both analytes. The proposed methodology was successfully applied to urine, serum and pharmaceutical preparations. Recovery percentages ranging from 96.1 to 104% were obtained for both analytes.     

矩阵方程（A^TXA，B^TXB=（C，D）的反对称解及其最佳逼近

本利用矩阵对的标准相关分解，得到了矩阵方程(A^TXB，B^TXB)=(C，D)反对称解存在的充分必要条件及通解表达式，同时给出了解关于已知矩阵的最佳逼近．     

Carrier diffusion in InGaAs/GaAs quantum wells grown on vicinal GaAs(0 0 1) substrates

We have investigated the influence of vicinal GaAs substrates on the optical and electronic properties of InGaAs/GaAs quantum wells (QWs). A single In_0.10Ga_0.90As QW was grown by molecular-beam epitaxy on a vicinal GaAs(0 0 1) substrate with a miscut angle of 0° (nominal), 2°, 4° and 6° towards [1 1 0]. The carrier diffusion was obtained by a micro-photoluminescence scan technique that permits to observe the effective diffusion length characterized by the lateral spread of carriers in the QW followed by radiative recombination. The carrier diffusion length was obtained parallel (L_||) and perpendicular (L) to the atomic steps. The diffusion length decreases as the temperature increases up to 100 K. Above this temperature we found different behaviours that depend on the sample miscut angle.     

KxCoO2·yH2O(x《0.2,y≤0.8)的晶体结构、输运及磁学性质

利用熔融KOH和Co3O4在较低温度(480℃)下反应制备出K0.36CoO2,然后用高锰酸钾溶液和饱和的过硫酸钾溶液进行氧化处理.氧化的同时伴随有水分子嵌入.K0.36CoO2用高锰酸钾和过硫酸钾溶液处理后分别得到K0.12CoO2·0.8H2O和K0.16CO2·0.6H2O.这两种化合物都属于六角晶系,表现出金属行为,脱水后主相变为正交结构并且呈现出半导体特性.K0.16CoO2·0.6H2O在56K附近可能存在自旋玻璃转变行为或其他涨落.随着钾含量的减少和水含量的增多,样品的自旋玻璃行为受到抑制或发生磁性相分离.样品K0.12CoO2·0.8H2O在零场冷却和有场冷却曲线上的分叉现象基本上消失.还讨论了产生KxCoO2与NaxCoO2体系结构和物性差别的原因.     

土壤盐渍化的研究进展

根据近年来国内外土壤学者在土壤盐渍化的研究成果，从土壤盐渍化的基本理论，改良方法以及预测预报方面的研究，综述了土壤盐渍化的研究现状，通过分析土壤盐渍化研究多方面存在的问题，对其发展趋势和今后研究重点进行了展望，望能为进一步的深入研究工作提供帮助．     

Necessary conditions and duality for inexact nonlinear semi-infinite programming problems

First order necessary conditions and duality results for general inexact nonlinear programming problems formulated in nonreflexive spaces are obtained. The Dubovitskii–Milyutin approach is the main tool used. Particular cases of linear and convex programs are also analyzed and some comments about a comparison of the obtained results with those existing in the literature are given.     

Aggregation Properties of an Amphiphilic Methanofullerene Derivative in THFH_2O Solvent Mixtures

Water-soluble fullerenes not only have a number of important applications in biological chemistry1, but also form ordered aggregate structures that can be utilized in materials science2. There are reports that some water-soluble fullerene derivatives can form ordered structures in water, such as vesicle, nanorod and nanoparticle2-5. However, relatively few reports on the aggregation process have been reported. Knowledge of factors that affect the cluster formation in solution is of consider…     

Syntheses,crystal structures and blue emission of three zinc(II) coordination polymers with a 4,4′‐dicarboxybiphenyl sulfone ligand

Three novel zinc complexes [Zn(dbsf)(H₂O)₂] ( 1 ), [Zn(dbsf)(2,2′‐bpy)(H₂O)]·(i‐C₃H₇OH) ( 2 ) and [Zn(dbsf)(DMF)] ( 3 ) (H₂dbsf = 4,4′‐dicarboxybiphenyl sulfone, 2,2′‐bpy = 2,2′‐bipyridine, i‐C₃H₇OH = iso‐propanol, DMF = N,N‐dimethylformamide) were first obtained and characterized by single crystal X‐ray crystallography. Although the results show that all the complexes 1–3 have one‐dimensional chains formed via coordination bonds, unique three‐dimensional supramolecular structures are formed due to different coordination modes and configuration of the dbsf^2? ligand, hydrogen bonds and π–π interactions. Iso‐propanol molecules are in open channels of 2 while larger empty channels are formed in 3 . As compared with emission band of the free H₂dbsf ligand, emission peaks of the complexes 1–3 are red‐shifted, and they show blue emission, which originates from enlarging conjugation upon coordination. Copyright © 2006 John Wiley & Sons, Ltd.     

Synthesis of grafted poly(p‐phenyleneethynylene) with energy donor–acceptor architecture via atom transfer radical polymerization: Towards nonaggregating and hole‐facilitating light‐emitting material

In this contribution, we demonstrate a new effective methodology for constructing highly efficient and durable poly(p‐phenyleneethynylene) (PPE) containing emissive material with nonaggregating and hole‐facilitating properties through the introduction of hole‐transporting blocks into the PPE system as the grafting coils as well as building the energy donor–acceptor architecture between the grafting coils and the PPE backbone. Poly(2‐(carbazol‐9‐yl)ethyl methacrylate) (PCzEMA), herein, is chosen as the hole‐transporting blocks, and incorporated into the PPE system as the grafting coils via atom transfer radical polymerization. The chemical structure of the resultant copolymer, PPE‐g‐PCzEMA, was characterized by NMR and gel permeation chromatography, showing that the desirable copolymer was obtained with the narrow polydispersity. The increased thermal stability of PPE‐g‐PCzEMA was confirmed by thermogravimetric analysis and differential scanning calorimetry along with its macroinitiator. The optoelectronic properties of this copolymer were studied in detail by ultraviolet‐visible absorption, photoluminescence emission and excitation spectra, and cyclic voltammogram (CV). The results indicate that PPE‐g‐PCzEMA exhibits the solid‐state luminescent property dominated by individual lumophores, and also the energy transfer process from the PCzEMA blocks to the PPE backbone with a relatively higher energy transfer efficiency in the solid‐state compared to that of the solution state. Additionally, the hole‐injection property is greatly facilitated due to the presence of PCzEMA, as confirmed by CV profiles. All these data indicate that PPE‐g‐PCzEMA is a good candidate for use in optoelectronic devices. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 3776–3787, 2007