A phenol-induced structural transition in aqueous cetyltrimethylammonium bromide solution

The effect of phenol on the structure of micellar solution of a cationic surfactant, cetyltrimethylammonium bromide (CTAB) was investigated using viscosity, dynamic light scattering (DLS), small angle neutron scattering (SANS) and nuclear magnetic resonance (NMR) techniques. The relative viscosity and apparent hydrodynamic diameters of the micelles in CTAB solution increase initially and then decrease with addition of phenol. SANS studies indicate a prolate ellipsoidal structure of the micelles. The axial ratio of the prolate ellipsoidal micelles increases and then decreases with addition of phenol, consistently with DLS and viscosity measurements. NMR studies confirm the solubilization of phenol to the palisade layer and growth of the micelles at high concentration of phenol as revealed from the broadening of peaks.     

Microwave assisted preparation of efficient activated carbon from grapevine rhytidome for the removal of methyl violet from aqueous solution

Grapevine rhytidome (the outer layer of bark on trunk), as an abundant and low-cost precursor, was used to prepare granular activated carbon with high surface area for the removal of methyl violet from aqueous solution. Microwave heating source was used to reduce the treatment time and energy consumption. To optimize the preparation, the effects of the different parameters, such as phosphoric acid concentration, acid/precursor weight ratio, impregnation time, microwave power, radiation time, and oven heating time on the ability of the samples for removal of methyl violet were studied. The obtained activated carbon was characterized by N₂ adsorption/desorption, SAXS, TEM and SEM methods. The adsorption of methyl violet onto the activated carbon was studied from both equilibrium and kinetic point of view and the results were compared with the commercial granular activated carbon. The rate of adsorption onto the prepared activated carbon was faster than commercial activated carbon. Different kinetic models were used to analyze the experimental kinetic data. The obtained activated carbon showed higher adsorption capacity (more than twice) for the adsorption of methyl violet in comparison with the commercial one. The equilibrium data were analyzed using different isotherm models. Adsorption was found to be maximum in the pH range 7-9.     

Ab Initio and DFT Studies on CO2 Interacting with Znq+–Imidazole (q=0, 1, 2) Complexes: Prediction of Charge Transfer through σ‐ or π‐Type Models

Using first‐principles methodologies, the equilibrium structures and the relative stability of CO₂@[Zn^q+Im] (where q=0, 1, 2; Im=imidazole) complexes are studied to understand the nature of the interactions between the CO₂ and Zn^q+–imidazole entities. These complexes are considered as prototype models mimicking the interactions of CO₂ with these subunits of zeolitic imidazolate frameworks or Zn enzymes. These computations are performed using both ab initio calculations and density functional theory. Dispersion effects accounting for long‐range interactions are considered. Solvent (water) effects were also considered using a polarizable continuum model approach. Natural bond orbital, charge, frontier orbital and vibrational analyses clearly reveal the occurrence of charge transfer through covalent and noncovalent interactions. Moreover, it is found that CO₂ can adsorb through more favorable π‐type stacking as well as σ‐type hydrogen‐bonding interactions. The inter‐monomer interaction potentials show a significant anisotropy that might induce CO₂ orientation and site‐selectivity effects in porous materials and in active sites of Zn enzymes. Hence, this study provides valuable information about how CO₂ adsorption takes place at the microscopic level within zeolitic imidazolate frameworks and biomolecules. These findings might help in understanding the role of such complexes in chemistry, biology and material science for further development of new materials and industrial applications.     

Highly selective fluorescent recognition of Zn2+ based on naphthalene macrocyclic derivative

A new macrocyclic chemosensor containing two naphthalene fluorophores has been synthesized. The fluorescent properties of this receptor has been studied in the presence of various metal ions such as Na⁺, Ag⁺, Cr³⁺, Mn²⁺, Fe³⁺, Co²⁺, Ni²⁺, Cu²⁺, Zn²⁺, Cd²⁺ and Pb²⁺. When increasing concentrations of Zn²⁺ ions were introduced, the emission of L was drastically increased (EFE = 4.34). This special change was not observed when other metal ions were used; such highly selective fluorescent response indicates that this receptor can easily discriminate Zn²⁺ ions from other similar species. Model calculations at DFT level further suggest the possible interaction mode, and relatively steric position between the host and guest also influence the optical response.     

Erbium(Ⅲ) PVC membrane sensor based on N-(benzyloxycarbonyloxy)succinimide as a new neutral ionophore

In this study,a new Er³⁺ sensor based on N-（benzyloxycarbonyloxy）succinimide（BCS） as a neutral carrier has been constructed. The sensor exhibits potential linear response with a Nernstian slope of 20.5±0.4 mV/decade in the concentration range of 1.0×10^-6to 1.0×10^-2mol/L of Er³⁺.It has a very short response time（<10 s）,detection limit of 6.3×10^-7 mol/L and a good selectivity relative to a wide variety of other metal ions including common alkali,alkaline earth,heavy,and transition metal ions.It can be used in the pH range of 2.5-10.6 without any considerable divergence in potentials.The proposed sensor was successfully applied for the recovery of Er³⁺ ions spiked in tap and river water samples.     

Bulk polymer nanoparticles containing a tetrakis(3-hydroxyphenyl)porphyrin for fast and highly selective separation of mercury ions

We report on the synthesis of polymeric nanoparticles (PNPs) containing a tetrakis(3-hydroxyphenyl)porphyrin, and their use for the separation of mercury(II) ion. The PNPs were prepared by bulk polymerization from methacrylic acid (the monomer), ethyleneglycol dimethacrylate (the cross-linker), 2,2′-azobisisobutyronitrile (the radical initiator) and the mercury(II) complex of 5,10,15,20-tetrakis(3-hydroxyphenyl)-porphyrin. The Hg(II) ion was then removed by treatment with dilute hydrochloric acid. The PNPs were characterized by colorimetry, FT-IR spectroscopy, and scanning electron microscopy. The material is capable of binding Hg(II) from analyte samples. Bound Hg(II) ions can be eluted with dilute nitric acid and then quantified by cold vapor AAS. The extraction efficiency, the effects of pH, preconcentration and leaching times, sample volume, and of the nature, concentration and volume of eluent were investigated. The maximum adsorption capacity of the PNPs is 249 mg g^?1, the relative standard deviation of the AAS assay is 2.2 %, and the limit of detection (3σ) is 8 ng.L^?1. The nanoparticles exhibit excellent selectivity for Hg(II) ion over other metal ions and were successfully applied to the selective extraction and determination of Hg(II) ion in spiked water samples.

Solanopubamine,a rare steroidal alkaloid from Solanum schimperianum: Synthesis of some new alkyl and acyl derivatives,their anticancer and antimicrobial evaluation

Solanopubamine (3β-amino-5α, 22αH, 25βH-solanidan-23β-ol), a steroidal alkaloid was isolated from the alkaloidal fraction of Solanum schimperianum in significant yield. Its structure was established by IR, positive ESI-MS, 1D and 2D NMR. The presence of -3β-NH₂ and -23β-OH groups was achieved through methylation, acetylation or coupling with octadecanoic and undec-11-enoic acids to produce six derivatives (2–7). Their structures were confirmed by spectroscopic analyses. Solanopubamine and semi-synthetic analogs are investigated for their in vitro cytotoxicity against a panel of human cancer cell lines and anti-microbial activity. Solanopubamine showed good antifungal activity only against Candida albicans and C. tenuis with MIC of 12.5 μg/mL. Semi-synthesized compounds (2–7) have failed to show anti-tumor and anti-microbial activities.     

Crystal structure of 1,2‐[4‐butoxybenzoyloxy‐4′‐pentyl]diphenylethane

The crystal structure of 1,2‐[4‐butoxybenzoyloxy‐4′‐pentyl]diphenylethane (C₃₀H₃₆O₃) has been determined by direct methods using single crystal X‐ray diffraction data. It crystallizes in the monoclinic system with space group P2₁/a and Z?=?4. The unit cell parameters are: a?=?8.098(1), b?=?10.926(1), c?=?29.643(2)?Å and β?=?94.01(1)°. The final reliability factor is R?=?0.073 and the goodness of fit is equal to 1.027. The molecular arrangement is very typical, with molecules associated in dimers very closely parallel to the Oz axis. In a given dimer, the backbones of the two molecules run alongside each other; this association can be attributed to strong dipole–dipole interactions through the polar ester and ether groups. In addition these dimers are connected to neighbours via dipole–dipole interactions along the Oy direction. There are numerous very weak van der Waals interactions, particularly between the terminal aliphatic chains.