Low-frequency noise and inelastic tunneling spectroscopy in Fe(1 1 0)/MgO(1 1 1)/Fe(1 1 0) epitaxial magnetic tunnel junctions

We report on tunnelling magnetoresistance (TMR), current–voltage (IV) characteristics and low-frequency noise in epitaxially grown Fe(1 1 0)/MgO(1 1 1)/Fe(1 1 0) magnetic tunnel junctions (MTJs) with dimensions from 2×2 to 20×20 μm². The evaluated MgO energy barrier (0.50±0.08 eV), the barrier width (13.1±0.5 Å) as well as the resistance times area product (7±1 MΩ μm²) show relatively small variation, confirming a high quality epitaxy and uniformity of all MTJs studied. At low temperatures (T<10 K) inelastic electron tunneling spectroscopy (IETS) shows anomalies related to phonons (symmetric structures below 100 meV) and asymmetric features above 200 meV. We explain the asymmetric features in IETS as due to generation of electron standing waves in one of the Fe electrodes. The noise power, though exhibiting a large variation, was observed to be roughly anti-correlated with the TMR. Surprisingly, for the largest junctions we observed a strong enhancement of the normalized low-frequency noise in the antiparallel magnetic configuration. This behavior could be related to the influence of magnetostriction on the characteristics of the insulating barrier through changes in local barrier defects structure.     

Study of the structural, dielectric and magnetic properties of Bi2O3 and PbO addition on BiFeO3 ceramic matrix

In this paper we studied the effects of Bi₂O₃ and PbO addition on BiFeO₃ (BFO) ceramic matrix. The structural, dielectric and magnetic properties of fifteen BFO samples were discussed in view of possible applications in RF and microwave devices. The present work also reports the preparation of the samples. Polyvinyl alcohol (PVA) and tetraethyl orthosilicate (TEOS) were also added as a binder in the fabrication procedure. The samples have been studied by X-ray powder diffraction (XRD), scanning electron microscopy (SEM) and magnetic hysteresis measurements. Further, a study based on impedance spectroscopy also has been done. Dielectric permittivity (ε′) and dielectric loss (tan δ) were measured at room temperature in the frequency range 100 Hz-10 MHz, as well as a.c. conductivity. The -Im[Z(f)] versus Re[Z(f)] plot has been obtained. The samples were investigated in view of possible applications like miniaturized filters, diplexers and dielectric resonator antennas (DRA). In the RF and MW frequency region, the application of magneto-dielectric and multiferroic perovskite composite materials is desirable for the miniaturization of components.     

Synthesis of 3-iodothiophenes via iodocyclization of (Z)-thiobutenynes

A simple synthesis of 3-iodothiophenes was demonstrated using a wide range of (Z)-thioenynes. The key step in the iodocyclofunctionalization was the selective reduction of the triple bond in (Z)-thioenynes by the addition of iodine as an electrophilic agent. The 3-iodothiophenes were obtained in good to excellent yields of 61–92%. The 3-iodothiophenes were used as substrates in Sonogashira cross-coupling reactions to obtain thiophene acetylenes.     

A Robust Algorithm for Roots Selection and Saturation Pressure Calculation for Cubic Equations of State

Journal of Solution Chemistry - In this work, a robust and rigorous procedure for roots calculation and selection for a Cubic Equation of State is presented. Roundoff errors are detected and...     

Variable cant angle winglets for improvement of aircraft flight performance

Meccanica - Traditional winglets are designed as fixed devices attached at the tips of the wings. The primary purpose of the winglets is to reduce the lift-induced drag, therefore improving...     

Simulation of Organic Liquid Product Deoxygenation through Multistage Countercurrent Absorber/Stripping Using CO2 as Solvent with Aspen-HYSYS: Process Modeling and Simulation

In this work, the deoxygenation of organic liquid products (OLP) obtained through the thermal catalytic cracking of palm oil at 450 °C, 1.0 atmosphere, with 10% (wt.) Na₂CO₃ as a catalyst, in multistage countercurrent absorber columns using supercritical carbon dioxide (SC-CO₂) as a solvent, with an Aspen-HYSYS process simulator, was systematically investigated. In a previous study, the thermodynamic data basis and EOS modeling necessary to simulate the deoxygenation of OLP was presented. This work addresses a new flowsheet, consisting of 03 absorber columns, 10 expansions valves, 10 flash drums, 08 heat exchanges, 01 pressure pump, and 02 make-ups of CO₂, aiming to improve the deacidification of OLP. The simulation was performed at 333 K, 140 bar, and (S/F) = 17; 350 K, 140 bar, and (S/F) = 38; 333 K, 140 bar, and (S/F) = 25. The simulation shows that 81.49% of OLP could be recovered and that the concentrations of hydrocarbons in the extracts of absorber-01 and absorber-02 were 96.95 and 92.78% (wt.) on a solvent-free basis, while the bottom stream of absorber-03 was enriched in oxygenated compounds with concentrations of up to 32.66% (wt.) on a solvent-free basis, showing that the organic liquid products (OLP) were deacidified and SC-CO₂ was able to deacidify the OLP and obtain fractions with lower olefin contents. The best deacidifying condition was obtained at 333 K, 140 bar, and (S/F) = 17.     

The effects of lignin removal and drying on the porosity and enzymatic hydrolysis of sugarcane bagasse

The porosity of lignocellulosic materials is a key feature for the enzymatic hydrolysis of the constituent polysaccharides, being affected by its drying and lignin content. Here we evaluated the influence of both parameters in the porosity of sugarcane bagasse, using raw and chlorite-delignified samples. A fraction of these samples was air dried at room temperature and the remainder one was kept wet. All the samples were subjected to porometry (solute exclusion technique), determination of water retention value and assessment of enzymatic saccharification of polysaccharides. Samples with higher lignin contents had lower porosities and exhibited worse enzymatic conversions of polysaccharides. Mild drying collapsed only the smaller pores, which already were inaccessible to enzymes, and therefore did not affect the efficiencies of saccharification. Our results show that the lignin content plays an important role in the porosity of the material and that its removal improves the enzymatic saccharification of the constituent polysaccharides.     

Synthesis of Na<Subscript>2</Subscript>Ti<Subscript>3</Subscript>O<Subscript>7</Subscript> nanoparticles by sonochemical method for solid state electrolyte applications

Na₂Ti₃O₇ ceramic materials have been widely used in sodium-ion battery applications with relative good results; however, there are still several studies that might be carried out in the improvement of the Na₂Ti₃O₇ properties and the overall batteries’ performance. In this direction, we used sonochemical method following a thermal treatment in order to synthetized pure phase Na₂Ti₃O₇ nanopowders. X-ray diffraction characterization revealed that Na₂Ti₃O₇ is the primary phase in nanopowders and ceramic sample; although, a high level of amorphization was observed in the sonicated nanopowder without heat treatment process. Nanopowder-prepared ceramic sample showed a crystallite size of 50 nm after sintering at 900 °C for 1 h. The specific surface area, pore volume, and pore size were obtained from the B.E.T. measurements, being 51 m² g^?1, 0.07 cm³ g^?1, and 55 Å, respectively. The capacitance values of the nanopowder-prepared ceramic sample were in the order of microfarad. The total energy of the system was used to determine relaxation time of the sample (τ ₀ = 31 ms).     

Optimisation of a key cross-coupling reaction towards the synthesis of a promising antileishmanial compound

During the course of a research program aimed at identifying novel antileishmanial compounds, a multi-gram synthesis of N-(trans-4-((4-methoxy-3-((R)-3-methylmorpholino)-1H-pyrazolo[3,4-d]pyrimidin-6-yl)amino)cyclohexyl)-2-methylpropane-1-sulfonamide ((R)-1) was required. This letter describes optimisation of the reaction conditions and protecting group strategy for a key Buchwald-Hartwig coupling, delivering the required quantities of (R)-1, as well as further compounds in the series.     

Production of recombinant bleaching enzymes from thermophilic microorganisms in fungal hosts

Cost-effective production of enzymes for industrial processes makes the appropriate selection of the host-vector expression system critical. We have developed two systems for the bulk production of bleaching enzymes from thermophiles. Kluyveromyces lactis has been developed as a secretion host employing expression vectors based on the 2μ-like plasmid pKD1 of Kluyveromyces drosophilarium. Our second system involves the filamentous fungus Trichoderma reesei. Fusion and nonfusion vectors have been constructed using the strong cellobiohydrolase 1 (cbh1) promoter. The KEX2 protease cleavage site and a 6 × HIS-tag have been incorporated to facilitate both cleavage and purification of the mature foreign proteins.