Hypernuclear fine structure in (9)(lambda)Be

With a germanium detector array (Hyperball), we observed two gamma-ray peaks corresponding to the two transitions (5/2(+)-->1/2(+) and 3/2(+)-->1/2(+)) in the (9)(Lambda)Be hypernucleus which was produced by the 9Be(K-,pi(-)) reaction. The energies of the gamma rays are 3029 +/- 2 +/- 1 keV and 3060 +/- 2 +/- 1 keV. The energy difference was measured to be 31.4(+2.5)(-3.6) keV, which indicates a very small Lambda-spin-dependent spin-orbit force between a Lambda and a nucleon. This is the smallest level splitting by far ever measured in a hypernucleus.     

迈克尔逊干涉仪中补偿板与干涉条纹

通过分析缺失补偿板的迈克尔逊干涉仪中的附加光程差,推出干涉条纹满足的方程式,并用计算机模拟了动镜移动过程中变化的干涉条纹,与实验结果相一致.     

气相传输平衡技术制备LiGaO2薄膜

为获得与GaN薄膜晶格失配小的衬底材料,报道了利用气相传输平衡技术(VTE)在(100)-βGa2O3单晶衬底上制备高度[001]取向LiGaO2薄膜的方法。经过X射线衍射分析表明得到的薄膜是由单相LiGaO2组成。利用扫描电镜(SEM)观察表面形貌,发现经气相传输平衡技术处理得到的薄膜表面形貌主要受温度的影响,表面晶粒尺寸随温度上升而增大。而X射线衍射测试表明随着温度上升,所得到的薄膜也从多晶向单晶化转变。在经过退火处理后,通过观察吸收谱发现LiGaO2薄膜中产生色心,并且色心的种类与温度有关。表明可以通过气相传输平衡技术技术,在远低于LiGaO2熔点的温度制备外延GaN用(001)LiGaO2∥(100)β-Ga2O3复合衬底。     

来自磁光阱中冷原子团的荧光干涉条纹及其应用

实验观察来自磁光阱中冷原子团的荧光经真空系统窗口的平板玻璃反射产生的干涉条纹，理论分析表明从从荧光干涉条纹的强度分布可获得关于俘获原子总数以及密度分布的信息。采用该方法实测了俘获原子总数，并模拟得到了不同密度分布时条纹的对比度变化。     

K2O-ZnO-Al2O3-B2O3-SiO2系掺Cr3+透明莫来石微晶玻璃的研究

采用了X射线衍射、透射电镜和吸收光谱及荧光光谱技术研究了K2O－ZnO-Al2O3-B2O3－SiO2系掺Cr^3 玻璃的析晶性能和光谱。研究结果表明：在K2O－Al2O3-B2O3-SiO2系掺Cr^3 玻璃的基础上引入ZnO后，析晶性能明显改善；析晶温度降低，析出的纳米莫来石微晶均匀、规则；微晶玻璃的发光强度明显增强。     

以(真空紫外光+紫外光)-共振加强式多光子游离法侦测交叉分子束之甲基生成物

用 (真空紫外光 +紫外光 ) 共振加强式多光子游离法侦测甲基自由基 .为证明此法之灵敏度 ,实验用交叉分子束反应F +CH4 (CD4 )→HF(DF) +CH3(CD3) ,其绝对灵敏度可达 10 7/cm3.由所得之光谱 ,更精确地得到两个里德堡态 3d2 E″及 3d2 A1′之光谱系数     

平面旋转场诱导下磁流变液的结构模型

针对平面旋转场下磁流变液中诱导产生的层状结构 ,提出了恰当的理论模型 ,该模型成功的解释了层状结构在同步旋转状态下 :层间距随磁场的变化关系 ;旋转层的滞后角随旋转角频率以及其他物理量之间的关系 ;层半径与旋转角频率之间的关系 .理论结果与文献中发表的实验结果相吻合     

A comparative study of the structure and crystallization of bulk metallic amorphous rod Pr60Ni30Al10 and melt-spun metallic amorphous ribbon Al87Ni10Pr3

Pr-based bulk metallic amorphous （BMA） rods （Pr60Ni30Al10） and Al-based amorphous ribbons （Al87Ni10Pr3） have been prepared by using copper mould casting and single roller melt-spun techniques, respectively. Thermal parameters deduced from differential scanning calorimeter （DSC） indicate that the glass-forming ability （GFA） of Pr60Ni30Al10 BMA rod is far higher than that of Al87Ni10Pr3 ribbon. A comparative study about the differences in structure between the two kinds of glass-forming alloys, superheated viscosity and crystallization are also made. Compared with the amorphous alloy Al87Ni10Pr3, the BMA alloy Pr60Ni30Al10 shows high thermal stability and large viscosity, small diffusivity at the same superheated temperatures. The results of x-Ray diffraction （XRD） and transmission electron microscope （TEM） show the pronounced difference in structure between the two amorphous alloys. Together with crystallization results, the main structure compositions of the amorphous samples are confirmed. It seems that the higher the GFA, the more topological type clusters in the Pr-Ni-Al amorphous alloys, the GFAs of the present glass-forming alloys are closely related to their structures.     

Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

Structural and thermodynamic properties of AlB2 compound

We employ a first-principles plane wave method with the relativistic analytic pseudopotential of Hartwigsen, Goedecker and Hutter (HGH) scheme in the frame of DFT to calculate the equilibrium lattice parameters and the thermodynamic properties of AlB₂ compound with hcp structure. The obtained lattice parameters are in good agreement with the available experimental data and those calculated by others. Through the quasi-harmonic Debye model, obtained successfully are the dependences of the normalized lattice parameters a/a₀ and c/c₀ on pressure P, the normalized primitive cell volume V/V₀ on pressure P, the variation of the thermal expansion α with pressure P and temperature T, as well as the Debye temperature \Theta_D and the heat capacity C_V on pressure P and temperature T.