Determination of binding constants and stoichiometries for platinum anticancer drugs and serum transport proteins by capillary electrophoresis using the Hummel-Dreyer method

A CE method has been developed to evidence and quantitatively characterize the interaction between platinum-based antitumor drugs and human serum proteins. This method is a variant of affinity CE modified regarding both experimental setup and data treatment so as to measure the peaks (or vacancies) that correspond to the bound drug when it slowly binds to the protein. Using the formalism of the Hummel-Dreyer method and cisplatin and oxaliplatin as test compounds, a protocol for determining albumin and transferrin binding constants and stoichiometries, including (and distinguished by) 48 hours of incubation of the reaction mixture, was elaborated. Relative affinities of drugs toward different proteins in aqueous solution at physiological pH, chloride concentration, and temperature were compared in terms of overall binding constants and numbers of drug molecules attached to the protein. The results indicate that both platinum drugs bind to albumin more strongly than to transferrin, supporting the concept that the albumin fraction is a major drug supply route for chemotherapeutical needs. From a comparison with the binding parameters measured previously for cisplatin by other methods, conclusions were drawn about the validity of CE as a simple and convenient method for assaying protein-drug reactions with slow kinetics.     

Flow/sequential injection determination of gaseous ammonia with a glass diffusion denuder

A new combination of a flow/sequential injection method for the analysis of ammonia has been developed. Gaseous ammonia is selectively absorbed in a phosphoric acid coated glass tube and determined with Berthelot reagents by flow injection. The combination of the gas diffusion denuder sampler with flow injection makes this method very sensitive and selective. The limit of detection of 0.15 mug NH(3).     

Quantitation in capillary electrophoresis-mass spectrometry

CE-MS has evolved into a strong alternative to LC-MS. Most of CE-MS applications deal with characterization and identification. However, quantitative aspects have gained importance in, e.g., pharmaceutical and biotechnological applications. Here we summarize and evaluate various methodological aspects in order to achieve sensitive and reproducible results. Similar to LC-MS, aspects of matrix influence on the electrospray process need to be carefully addressed when quantitative results are intended by CE-MS. Due to a more complicated coupling special emphasis needs to be put on the CE-MS interface. Generally linearity over more than three orders of magnitude can be achieved by CE-ESI-MS. Furthermore, a literature survey has been performed in order to give an overview over quantitative measurements performed by CE-MS. The precision can be doubled when changing from a structural related to an isotopically labeled internal standard. Thus a level of precision better than 5% RSD can be achieved.     

Operational variables in high-performance liquid chromatography-electrospray ionization mass spectrometry of peptides and proteins using poly(styrene-divinylbenzene) monoliths

Capillary reversed-phase high-performance liquid chromatography (RP-HPLC) utilizing monolithic poly(styrene-divinylbenzene) columns was optimized for the coupling to electrospray ionization mass spectrometry (ESI-MS) by the application of various temperatures and mobile phase additives during peptide and protein analysis. Peak widths at half height improved significantly upon increasing the temperature and ranged from 2.0 to 5.4 s for peptide and protein separations at 70 degrees. Selectivity of peptide elution was significantly modulated by temperature, whereas the effect on proteins was only minor. A comparison of 0.10% formic acid (FA), 0.050% trifluoroacetic acid (TFA), and 0.050% heptafluorobutyric acid (HFBA) as mobile phase additives revealed that highest chromatographic efficiency but poorest mass spectrometric detectabilities were achieved with HFBA. Clusters of HFBA, water, and acetonitrile were observed in the mass spectra at m/z values >500. Although the signal-to-noise ratios for the individual peptides diverged considerably both in the selected ion chromatograms and extracted mass spectra, the average mass spectrometric detectabilities varied only by a factor of less than 1.7 measured with the different additives. Limits of detection for peptides with 500 nl sample volumes injected onto a 60 mm x 0.20 mm monolithic column were in the 0.2-13 fmol range. In the analysis of hydrophobic membrane proteins, HFBA enabled highest separation selectivity at the cost of lower mass spectral quality. The use of 0.050% TFA as mobile phase additive turned out to be the best compromise between chromatographic and mass spectrometric performance in the analysis of peptides and proteins by RP-HPLC-ESI-MS using monolithic separation columns.     

Vibrational and high pressure conformational studies of 1,1,2-trichloroethane

The infrared spectra of 1,1,2-trichloroethane were recorded from 4000 to 50 cm^?1 in the vapour and liquid states. Additional spectra above 200 cm^?1 of the low temperature crystal and of two crystalline solids, prepared by compressing the sample in a diamond anvil cell, were obtained. Also, infrared spectra of the liquid and of the compound dissolved in CS₂ were recorded at increased pressures. Raman spectral data of the liquid (including polarization measurements) and of the low temperature crystal were obtained.The fundamental frequencies for each of the two conformers, C₁ and C_s, were assigned and the results checked by normal coordinate analysis. The same diagonal and off-diagonal force constants were employed for the two conformers and the force fields were derived by means of a least squares refinement, including data for chloroethane, 1,1-dichloroethane and various deuterated species. A standard deviation of 3 % was obtained in the final fit.From the changes in relative intensities for infrared bands belonging to the C₁ and C_s conformers with increasing pressure, the volume differences (ΔV¯between the conformers were determined in CS₂ solution and in the pure liquid.     

Strukturen ladungsgestörter oder räumlich überfüllter Moleküle. 15. Tetracyanethen-Natrium-Dimethoxyethan

Structures of Charge-Perturbed or Sterically Overcrowded Molecules. 16. Tetracyanoethylene Sodium Dimethoxyethane The Single crystal structure of [(NC)₂C? C(CN)₂?·Na⊕(H₃CO? CH₂CH₂? OCH₃)]∞ reveals two formula units within the triclinic (P1 ) unit cell. The tetracyanoethylene radical anions are arranged along parallel double layers, which are shifted relative to each other, and in between which are interspersed the sodium counter cations and their dimethoxyethane ligands. The distances within the double layers amount to 300 pm and the ones between them to 385 pm. The six-fold coordinated Na⊕ centers are surrounded by four radical anions with contact distances Na…?N between 250 and 254 pm as well as by a twofold solvent ligand with Na…?O of 238 and 241 pm. Due to the electron transfer to the acceptor molecule, its (NC)₂C-halves twist by 8° and the bond lengths of the N?C? C subunits, bent by each 3°, are shortened up to 2 pm. The structural parameters are compared to those of the analogous potassium salt [TCNE^?K^⊕DME], of the dianion , of the sodium salts [(NC)₃C^?Na^⊕]∞ as well as [(NC)₂C? C(CHCH)₂? C(CN)₂^?Na^⊕]_∞ and, in addition, are discussed based on geometry-optimized MNDO calculations.     

Substituent control of hydrogen bonding in palladium(II)-pyrazole complexes

Inter- and intramolecular hydrogen bonding of an N-H group in pyrazole complexes was studied using ligands with two different groups at pyrazole C-3 and C-5. At C-5, groups such as methyl, i-propyl, phenyl, or tert-butyl were present. At C-3, side chains L-CH(2)- and L-CH(2)CH(2)- (L = thioether or phosphine) ensured formation of chelates to a cis-dichloropalladium(II) fragment through side-chain atom L and the pyrazole nitrogen closest to the side chain. The significance of the ligands is that by placing a ligating side chain on a ring carbon (C-3), rather than on a ring nitrogen, the ring nitrogen not bound to the metal and its attached proton are available for hydrogen bonding. As desired, seven chelate complexes examined by X-ray diffraction all showed intramolecular hydrogen bonding between the pyrazole N-H and a chloride ligand in the cis position. In addition, however, intermolecular hydrogen bonding could be controlled by the substituent at C-5: complexes with either a methyl at C-5 or no substituent there showed significant intermolecular hydrogen bonding interactions, which were completely avoided by placing a tert-butyl group at C-5. The acidity of two complexes in acetonitrile solutions was estimated to be closer to that of pyridinium ion than those of imidazolium or triethylammonium ions.