小角X射线散射表征AOT/水层状溶致液晶的有序性

用小角X射线散射研究了AOT/水层状溶致液晶的有序性. 通过对散射曲线的解析, 讨论了表面活性剂浓度、温度和助表面活性剂等三个方面对溶致液晶层状相结构有序性的影响. 在一定的范围内, 提高温度, 改变表面活性剂浓度和加入少量助表面活性剂可使碳氢链排列由稀疏转变为密实, 层状相也相应地由“柔性双层”过渡到更加有序化的“平面双层”. 基于形状因子和体系内分子间作用力, 提出了层状相形成与有序化的机理, 同时采用分子模拟的方法展现了不同浓度下的液晶结构.     

Formation at low surfactant concentrations and characterization of mesoporous MCM-41

At low concentrations of cetyltrimethylammonium bromide,all silica-based mesoporous materials with hexagonal phase have been synthesized via interactions between self-assembled surfactant molecule aggregates and aniomc silicate polymers.The resulting materials are characterized by XRD,FT-IR,solid state 29Si MAS NMR,thermal analysis and N2 adsorption-desorption measurements.After soluble ions are removed,the interactors between surfactant micelles and silicate polymers are reorganized and then form mesostructures 1 he hexagonal framework is sonsistent with amorphous silica gel.The structures of materials depend on the synthesis conditions Hydrothermal process improves the interactions between molecules and increases the degree of framework silicon atom polymerization The.surface area and the mesopore volume of the material prepared at 100℃ increase by 87% and 71 %,respectively,compared with those obtained at room temperature.     

Flory状态方程理论与聚合物混合物的热力学

由Flory状态方程理论的化学位公式推导了二元混合物的亚稳单相极限线,同时导出了状态方程参数的温度、压力依赖性,计算表明Flory理论是可以像McMaster修正理论一样描述聚合物的相溶性行为的。 指出前人的工作由于假定相互作用能和熵参数均为0,分子量和状态方程参数对相界的影响被誇大了,相分离也只发生在很窄的浓度范围内。如果考虑了实际体系中相互作用能和熵参数均不为0,上述因素对相界的影响以及相界的形状将趋于合理。     

Studies on Phase Behavior of Alkyl Polyglucoside Based on Microemulsions with Modified Fishlike Phase Diagram

The three-phase behavior in the quaternary system of an alkyl (C8/10^- or C12/14^-)polyglucoside / 1-butanol / n-octane / water has been studied at 40℃ with the modified fishlike phase diagram, which is presented by us for the first time. The mass fraction of 1-butanol in the hydrophile-lipophile balanced interfacial layer, A^S, the coordinates of the start point B and the end point E of the phase diagram, and the solubilities of alkyl polyglucoside and 1-butanol in n-octane phase were calculated. The solubilization of the microemulsion was also discussed.     

Synthesis and Luminescence Property of 4,4＇-Bis（2,2-di（4-fluorophenyl）vinyl）biphenyl for Organic Blue-Light-Emitting Diodes

The novel fluorinated distyrylarylene, 4,4＇-bis（2,2-di（4-fluorophenyl）vinyl）biphenyl （DFPVBi）, was synthesized and fully characterized. The structure was confirmed with IR, 1↑H NMR, 13↑C NMR, 19↑F NMR and MS analyses. Its electronic and photoluminescence properties were investigated by UV-Vis absorption, cyclic voltammetry and fluorescence spectroscopy. The energy levels of the highest occupied molecular orbital （HOMO） and the lowest unoccupied molecular orbital （LUMO） are --5.77 and --2.75 eV, respectively. The electroluminescence proper- ties of the organic light-emitting diode fabricated by DFPVBi were also studied. The device exhibits a pure blue emission peaked at 454 nm, which indicates a maximum luminance of 5872 cd/m ^2 at 14.2 V and a maximum current efficiency of 2.82 cd/A at 10V, respectively.     

亲水性交联聚合物载体的合成表征及其固定化α-淀粉酶

选用丙烯酰胺(AM)、N-羟基琥珀酰亚胺为单体(NHS),以N,N/-亚甲基双丙烯酰胺(MBAA)为交联剂,以乙醇水溶液为制孔剂条件下进行反相悬浮聚合,得到珠状共聚物载体,该载体是一种新的酶载体形式,在国内外的相关文献中均未见报道.用红外光谱、扫描电子显微镜测定其结构和表观活性.结果表明,在固定单体配比[W(AM)/W(NHS)=10∶1]和致孔剂用量的情况下,测得交联剂用量为4%时,交联聚合物载体的溶胀性最好(287.5%);交联剂用量为5%时,交联聚合物载体固定化α-淀粉酶表现出高的表观活性(522.53U/g).测得固定化酶载体表现出良好的操作稳定性.比较固定化酶和游离态酶的最适反应温度发现,固定化酶的最适反应温度(70℃)比游离态酶高20℃;固定化酶的最适反应pH值范围较游离态酶广.     

Synthesis of Highly Porous Organic/Inorganic Hybrids by Ambient Pressure Sol-Gel Processing

This paper reports the synthesis of highly porous organic/inorganic hybrids by a two-step acid-base catalyzed sol-gel process and ambient pressure drying. In the method organic and inorganic precursors are copolymerized so as to incorporate organic ligands into the solid network. The two-step acid-base catalyzed process was used to prevent phase segregation during the hydrolysis and co-condensation of organic and inorganic precursors. The organic ligands incorporated into the solid gel network modify the surface chemistry. Thus, the wetting angle is significantly increased so that the collapse of the gel network is greatly reduced upon the removal of pore fluid during drying. Organic/inorganic hybrids with BET surface areas above 1250 m2/g, porosities above 75% and pore sizes of 8 nm have been synthesized.     

Studies on the Phase Properties of Winsor Ⅰ-Ⅲ Type Microemulsions with Dielectric Relaxation Spectroscopy

The dielectric relaxation spectroscopy （DRS） of Winsor I -Ⅲ microemulsions for nonionic surfactant octyl polyglucoside CsG1.46/1-butanol/cyclohexanedwater system was studied. The experiment shows that the permittivity decreases with the increase in the frequency and clear dielectric relaxation phenomena were observed. Permittivity obviously decreases with the change of the microstructure of the microemulsion, W/O, B.C. and O/W can be distinguished by the permittivity.     

A New Amperometric Biosensor Based on HRP/Nano-Au/L-Cysteine/Poly（o-Aminobenzoic acid）-Membrane-Modified Platinum Electrode for the Determination of Hydrogen Peroxide

The third generation amperometric biosensor for the determination of hydrogen peroxide （H2O2） has been described. For the fabrication of biosensor, o-aminobenzoic acid （oABA） was first electropolymerized on the surface of platinum （Pt） electrode as an electrostatic repulsion layer to reject interferences. Horseradish peroxidase （HRP） absorbed by nano-scaled particulate gold （nano-Au） was immobilized on the electrode modified with polymerized o-aminobenzoic acid （poABA） with L-cysteine as a linker to prepare a biosensor for the detection of H2O2. Amperometric detection of H2O2 was realized at a potential of ＋20 mV versus SCE. The resulting biosensor exhibited fast response, excellent reproducibility and sensibility, expanded linear range and low interferences. Temperature and pH dependence and stability of the sensor were investigated. The optimal sensor gave a linear response in the range of 2.99×10^-6 to 3.55×10^-3 mol·L^-1 to H2O2 with a sensibility of 0.0177 A·L^-1·mol^-1 and a detection limit （S/N = 3） of 4.3×10^-7 mol·L^-1. The biosensor demonstrated a 95% response within less than 10 s.     

样品价态对激光气化产生Cu/Cl团簇的组成和稳定性的影响

研究团控的形成条件、形成机理是目前团簇科学中的一个热点领域［‘］．产生气相团簇的方法主要有Knudsen高温炉扩散法、粒子溅射法、激光气化／分子束法、直接激光气化法·因为不需要另加缓冲气体，直接激光气化法【刀具有对体系真空要求较低，装置简单，容易和飞行时间质谱结