Asymptotics of Dirichlet Spectrum on Some Class of Noncompact Domains

We investigate the asymptotic behaviour of the counting function of Dirichlet eigenvalues on some class of noncompact manifolds. We prove that in cases when the volume or the perimeter (the volume of the boundary) of the manifold is infinite, some additional (nonclassical) terms appear in the precise asymptotics. The coefficients at the classical terms in those are regularized in some special way volume (resp. perimeter) of the manifold.     

Nitroxide‐mediated radical polymerization in miniemulsion: Bimolecular termination in monomer‐free model systems

Bimolecular termination in nitroxide‐mediated radical polymerization in miniemulsion has been investigated through the heating of a polystyrene–2,2,6,6‐tetramethylpiperidinyl‐1‐oxy macroinitiator and its 4‐hydroxy‐2,2,6,6‐tetramethylpiperidinyl‐1‐oxy analogue in an aqueous toluene dispersion with sodium dodecyl benzenesulfonate as a surfactant at 125 °C. The level of bimolecular termination by combination, evaluated from the high‐molecular‐weight shoulder, was higher in miniemulsion than in solution and increased with decreasing particle size. Quantitative analysis revealed that these results cannot be rationalized solely by nitroxide partitioning to the aqueous phase. The results are explained by an interface effect, by which nitroxide is adsorbed or located at the aqueous–organic interface. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 4995–5004, 2007     

Interference inspection of the aspherical components of an objective for nanolithography

Methods and schemes to inspect the EUV mirror shape are developed on the basis of a point diffraction interferometer with computer processing of interferograms. A measurement accuracy to within 0.001 of a wavelength in the visual range is achieved.     

Research problems

This section appears from time to time. Contributions are invited, and should be submitted to R. C. Thompson, Mathematics Department, University of California, Santa Barbara, CA 93106.     

New Heat-Resistant Polyimidates Derived from Bisphenols and Mono- and Dicarboxylic Acid Imidoyl Chlorides

New polyimidates were prepared from bisphenols and mono- and dicarboxylic acid imidoyl chlorides. The structures of the polymers were determined, and their physicochemical, chemical, and thermal properties were studied. The possibility of preparing film and compression materials with good mechanical characteristics from these polymers was examined.     

Numerical study of simultaneous natural convection heat transfer from both surfaces of a uniformly heated thin plate with arbitrary inclination

 Numerical studies were conducted to investigate the natural convection heat transfer around a uniformly heated thin plate with arbitrary inclination in an infinite space. The numerical approach was based on the finite volume technique with a nonstaggered grid arrangement. For handling the pressure–velocity coupling the SIMPLE-algorithm was used. QUICK scheme and first order upwind scheme were employed for discretization of the momentum and energy convective terms respectively. Plate width and heating rate were used to vary the modified Rayleigh number over the range of 4.8×10⁶ to 1.87×10⁸. Local and average heat transfer characteristics were compared with regarding to the inclination angle. The empirical expressions for local and average Nusselt number were correlated. It has been found that for inclination angle less than 10^∘, the flow and heat transfer characteristics are complicated and the average Nusselt number can not be correlated by one equation while for inclination angle larger than 10^∘, the average Nusselt number can be correlated into an elegant correlation. Received on 18 April 2001 / Published online: 29 November 2001     

A rapid and sensitive extractive spectrophotometric determination of copper(II) in pharmaceutical and environmental samples using benzildithiosemicarbazone.

Benzildithiosemicarbazone (BDTSC) is proposed as a sensitive and selective analytical reagent for the extractive spectrophotometric determination of copper(II). BDTSC reacts with copper(II) in the pH range 1.0-7.0 to form a yellowish complex. Beer's law is obeyed in the concentration range 0.5-0.4 microg cm(-3). The yellowish Cu(II)-BDTSC complex in chloroform shows a maximum absorbance at 380 nm, with molar absorptivity and Sandell's sensitivity values of 1.63 x 10(4) dm3 mol(-1) cm(-1) and 0.00389 microg cm(-2), respectively. A repetition of the method is checked by finding the relative standard deviation (RSD) (n = 10), which is 0.6%. The composition of the Cu(II)-BDTSC complex is established as 1:1 by slope analysis, molar ratio and Asmus' methods. An excellent linearity with a correlation coefficient value of 0.98 is obtained for the Cu(II)-BDTSC complex. The instability constant of the complex calculated from Edmond and Birnbaum's method is 7.70 x 10(-4) and that of Asmus' method is 7.66 x 10(-4), at room temperature. The method is successfully employed for the determination copper(II) in pharmaceutical and environmental samples. The reliability of the method is assured by analyzing the standard alloys (BCS 5g, 10g, 19e, 78, 32a, 207 and 179) and by inter-comparison of experimental values, using an atomic absorption spectrometer.     

Effective thermal conductivity of water-saturated sintered powder-metal plates

An experimental apparatus and related procedures for the determination of the effective thermal conductivity of sintered powder-metal plates saturated with distilled water at temperatures in the range 20–150°C are discussed. The apparatus and procedures are applied to two samples of sintered powder-metal plates, one made of nickel 200 and the other of stainless steel 316, with porosities of 28.10 and 46.45%, respectively, and each of nominal dimensions 127 mm × 127 mm × 6.35 mm. The experimental results are compared with corresponding predictions yielded by several correlations available in the literature. The correlations based on experimental data for packed beds of spherical particles and also porous plates made of cold-pressed (but not sintered) particles of angular shapes do not apply well to sintered powder-metal plates. A new correlation, which is based on extensions of ideas contained in earlier works and provides improved predictions, is proposed.     

Finite element method in the solution of the Euler and Navier-Stokes equations for internal flow

Finite element solutions of the Euler and Navier-Stokes equations are presented, using a simple dissipation model. The discretization is based on the weak-Galerkin weighted residual method and equal interpolation functions for all the unknowns are permitted. The nonlinearity is iterated upon using a Newton method and at each iteration the linear algebraic system is solved by a direct solver with all unknowns fully coupled. Results are presented for two-dimensional transonic inviscid flows and two- and three-dimensional incompressible viscous flows. Convergence of the algorithm is shown to be quadratic, reaching machine accuracy in very few iterations. The inviscid results demonstrate the existence of nonunique numerical solutions to the steady Euler equations.     

Vortex ring generation due to the coalescence of a water drop at a free surface

 Results are presented of an experimental investigation of vortex ring formation by a fluid drop contacting a free surface with negligible velocity. The pool fluid is mixed with fluorescein dye, and a laser sheet is used to illuminate a plane of the flow. A series of representative images is recorded by a CCD camera and speculation is made regarding specific sources of vorticity flux through the free surface. Two scaling analyses previously presented by other investigators are demonstrated to be equivalent under the assumptions of this experiment, and they provide the motivation for a series of test runs in which the duration of the coalescence process, τ_*, is related to variations in drop diameter L and fluid surface tension σ. Experimental results are in agreement with the analyses, showing τ_*∼σ^-1/2 and τ_*∼L ^3/2. Received: 22 December 1995 / Accepted: 15 October 1996