Mercury-mercurous acetate indicator electrode for potentiometric titrations in anhydrous acetic acid

The authors describe a metallic mercury electrode covered with a mercurous acetate coating, its preparation, its use as an indicator electrode in anhydrous acetic acid neutralization titrations and its properties as compared with other electrodes used for the same purpose.     

Physicochemical study of ovalbumin in the presence of sodium dodecyl sulphate in aqueous media

The interactions of sodium dodecyl sulphate with ovalbumin in aqueous solution at room temperature are described for a wide concentration range of both substances. A phase diagram covering a wide range of concentrations shows a total of five different morphologies. Dynamic light scattering of the samples from each morphology offered better understanding of the different structures (between three and four) present in the solution. The amount of ovalbumin present in the solution was confirmed with differential scanning spectroscopy, while the interactions between sodium dodecyl sulphate and ovalbumin were interpreted by zeta potential and electrical conductivity measurements.     

Preconcentration of heavy metals ions from aqueous solutions by means of cellulose phosphate: an application in water analysis

Cellulose phosphate (CELLPHOS) was studied as a collector for analytical preconcentration of traces of Cd(II), Cr(III), Cu(II) and Ni(II) from aqueous sample solution. It has been proved that using chromatographic columns packed with CELLPHOS for preconcentration and 1.0 mol 1(-1) HCl for elution the adsorbed analytes are quantitatively enriched. An enrichment factor of 20 (100 ml sample, 5 ml concentrate) was achieved by this separation procedure, which was applied to a series of water analyses (river, sea, bog water).     

Multicommuted flow-through fluorescence optosensor for determination of furosemide and triamterene

Multicommutation implemented with flow-through optosensors is a very promising area of research. This recent approach benefits from the advantages of both methods and results in high sensitivity, selectivity, and speed, and little waste generation. This paper reports the simultaneous determination of furosemide and triamterene, two widely used diuretics, by measurement of their native fluorescence. The system has been proved to be useful for determination of both analytes in pharmaceutical preparations and for determination of triamterene in human urine and serum. A minicolumn filled with Sephadex SPC-25 microbeads was used to achieve separation of both analytes before detection in a flow-through cell filled with the same resin. The sensor is linear in the range 50–1200 and 0.4–8 ng mL⁻¹ with detection limits of 15 and 0.1 ng mL⁻¹ for furosemide and triamterene, respectively.     

Kinetics and Mechanism of Ni(II) Chelation in Model and Real Solutions of Xylem Sap of Quercus ilex

The kinetics of formation and dissociation of Ni(II) complexes with oxalic and citric acids was studied by cyclic voltammetry in model solutions of xylem sap of Q. ilex (the dominant tree growing on serpentine soils of Northeast Portugal) using representative concentrations, pH and ionic strength. The role of magnesium on complex formation was analyzed from solutions where Mg is present at concentration levels found in the xylem sap of Q. ilex growing on both nonserpentine and serpentine soils. Kinetics studies were also done in diluted solutions of real xylem sap samples, spiked with increasing amounts of magnesium. The values obtained for the apparent rate constants were those anticipated by the proposed model. To test the validity of the methodology and mechanisms, formation rate constants, k_f (M^?1 s^?1) of Ni(II) complexes with citrate and oxalate were evaluated that compare with the values from Eigen mechanism.     

Preconcentration Systems Using Polyurethane Foam/Me-BDBD for Determination of Copper in Food Samples

A new reagent, 6-[2′-(6′-methyl-benzothiazolylazo)]-1,2-dihydroxy-3,5-benzenedisulfonic acid (Me-BDBD), was synthesised and used in on-line and off-line systems for copper preconcentration by solid-phase extraction. Spectrophotometry and Flame Atomic Absorption Spectrometry (FAAS) were the detection techniques. Polyurethane foam loaded with Me-BDBD packed in a minicolumn was used as sorbent in both systems. The spectral characteristics of Me-BDBD were investigated. The optimum pH values for maximum sorption of the metal are between 7.0 and 8.5. Copper was desorbed with 0.05 and 0.50 mol L⁻¹ hydrochloric acid solutions, for on-line and off-line systems, respectively. The effects of several foreign substances on the adsorption of copper are reported. The enrichment factors obtained were 7 (on-line) and 26 (off-line) for the systems. The proposed procedures allowed the determination of copper with detection limits of 3.4 and 1.4 μg L⁻¹ (0.85 and 0.35 μg per gram of sample) for on-line and off-line systems, respectively. The precision of the procedures was also calculated: 3.2 (on-line) and 1.9% (off-line). The validation of the procedures was carried out by analysis of certified reference material. The copper contents in corn and rice flour and black tea samples were determined by applying the proposed procedures.     

Rapid screening of selective serotonin re-uptake inhibitors in urine samples using solid-phase microextraction gas chromatography–mass spectrometry

In this paper a solid-phase microextraction–gas chromatography–mass spectrometry (SPME–GC–MS) method is proposed for a rapid analysis of some frequently prescribed selective serotonin re-uptake inhibitors (SSRI)—venlafaxine, fluvoxamine, mirtazapine, fluoxetine, citalopram, and sertraline—in urine samples. The SPME-based method enables simultaneous determination of the target SSRI after simple in-situ derivatization of some of the target compounds. Calibration curves in water and in urine were validated and statistically compared. This revealed the absence of matrix effect and, in consequence, the possibility of quantifying SSRI in urine samples by external water calibration. Intra-day and inter-day precision was satisfactory for all the target compounds (relative standard deviation, RSD, <14%) and the detection limits achieved were <0.4 ng mL^–1 urine. The time required for the SPME step and for GC analysis (30 min each) enables high throughput. The method was applied to real urine samples from different patients being treated with some of these pharmaceuticals. Some SSRI metabolites were also detected and tentatively identified.     

Diffusion layer titration of dipyrone in pharmaceuticals at a dual-band electrochemical cell

This paper describes the use of a thin-layered dual-band electrochemical cell operating at flow conditions to determine dipyrone (sodium salt of 1-phenil-2,3-dimethyl-4-methylaminomethanesulfonate-5-pyrazolone) by reaction with electrogenerated iodine. The electrolytic cell consisted of two closely spaced gold electrodes, the upper stream electrode serving as the generator electrode and the downstream electrode working as the collector electrode. A linear dynamic range from 2 to 15 μmol l⁻¹ dipyrone was obtained by using a sample volume of 100 μl, with a detection limit of 1.1 μmol l⁻¹. Standard deviation (S.D.) of 3.4% for 20 repetitive injections of a 40 μmol l⁻¹ dipyrone solution and sampling frequency of 90 h⁻¹ were achieved. The results obtained with the thin-layered dual-band electrochemical cell for dipyrone determination in three different pharmaceutical samples compared well with those found by iodimetry with coulometrically generated iodine.     

Multivariate optimisation of the experimental conditions for determination of three methylxanthines by reversed-phase high-performance liquid chromatography

Caffeine (1,3,7-trimethylxanthine), theobromine (3,7-dimethylxanthine) and theophylline (1,3-dimethylxanthine) are the most important naturally occurring methylxanthines. Caffeine is a constituent of coffee and other beverage and included in many medicines. Theobromine and theophylline are formed as metabolites of caffeine in humans, and are also present in tea, cocoa and chocolate products.

In order to improve the chromatographic resolution (R_s) with a good analysis time, experimental designs were applied for multivariate optimisation of the experimental conditions of an isocratic reversed-phase high-performance liquid chromatographic (RP-HPLC) method used for the simultaneous determination of caffeine, theobromine and theophylline. The optimisation process was carried out in two steps using full three-level factorial designs. The factors optimised were: flow rate and mobile phase composition. Optimal conditions for the separation of the three methylxanthines were obtained using a mixture of water/ethanol/acetic acid (75:24:1%, v/v/v) as mobile phase and a flow rate of 1.0 mL min⁻¹. The RP-HPLC/UV method was validated in terms of limit of detection (LOD), limit of quantitation (LOQ), linearity, recovery and the precision, calculated as relative standard deviation (R.S.D.). In these conditions, the LOD was 0.10 μg L⁻¹ for caffeine, 0.07 μg L⁻¹ for theobromine and 0.06 μg L⁻¹ for theophylline. The proposed method is fast, requires no extraction step or derivatization and was suitable for quantification of these methylxanthines in coffee, tea and human urine samples.     

Study of spectral analytical data using fingerprints and scaled similarity measurements

A new chemoinformatic model has been developed for enlarging the differences between spectra and applied to differentiation of wines according to the criteria grape origin and variety and ageing process. The model is based on generation of fingerprints from normalised spectra, using empirical parameters and a set of 120 samples. After generation of the fingerprints, similarity matrixes were built on the basis of the Tanimoto similarity index between the fingerprints of the samples. Calculation of the Tanimoto index was modified to adapt the index to the characteristics of the analytical measurements. Thus, scaling factors taking into account pattern fingerprints generated from a group of samples with common characteristics were used. In addition, a modified expression for calculating the Tanimoto index was employed. Principal-components analysis (PCA) and soft independent modelling of class analogy (SIMCA) were applied to the similarity matrixes. The results obtained are discussed as a function of the normalisation method employed, the empirical factor used in generation of the fingerprints, and selection of samples for building the pattern fingerprint, etc. Finally, results from differentiation of wines are compared with those obtained by applying PCA to the unprocessed spectra as stated by the proposed model.