高压熔渗生长法制备金刚石聚晶中碳的转化机制研究

在6 GPa和1500 ℃的压力和温度范围内, 利用高压熔渗生长法制备了纯金刚石聚晶, 深入研究了高温高压下金刚石聚晶生长过程中碳的转化机制. 利用光学显微镜、X-射线衍射、场发射扫描电子显微镜检测, 发现在熔渗过程中金刚石层出现了石墨化现象, 在烧结过程中金刚石颗粒表面形貌发生了变化. 根据实验现象分析, 在制备过程中存在三种碳的转化机制: 1)金属熔渗阶段金刚石颗粒表面石墨化产生石墨; 2)产生的石墨在烧结阶段很快转变为填充空隙的金刚石碳; 3)金刚石直接溶解在金属溶液中, 以金刚石形式在颗粒间析出, 填充空隙. 本文研究碳的转化机制为在高温高压金属溶剂法合成金刚石的条件下(6 GPa和1500 ℃的压力和温度范围内)工业批量化制备无添加剂、无空隙的纯金刚石聚晶提供了重要的理论指导.     

质子滴线核8B的实验研究进展

质子滴线核8B的最后一个质子的分离能只有0.137 5 MeV,被认为是最有可能具有质子晕结构的候选核之一,对其反应机制和奇特结构的研究吸引了人们的关注。针对8B的奇特结构和反应机制研究是一个非常有趣的课题,研究人员在包括反应截面、碎裂产物动量分布宽度、电四极矩、熔合截面及弹性散射等方面开展了大量的工作。但是8B的研究至今仍不够充分,需要从理论和实验上对其进行更深入的研究。     

不同调制方式下偏振度与偏振模色散的关系

给出了偏振度与偏振模色散关系的理论模型,分析了非归零和归零两种调制方式下的偏振度与偏振模色散关系特性,结果表明偏振度町以作为实时检测偏振模色散的信号;且偏振度对偏振模色散的有效检测范围不大于调制光信号的占空比α,同时检测灵敏度与有效检测范围成反比;在非归零调制时偏振度对偏振模色散的有效检测范围最宽,为调制光信号的一个调制周期,是常规归零调制(占空比为0．5)时的2倍,但灵敏度只有常规归零调制时的一半。进一步探讨了在实际应用中改善偏振度对偏振模色散的有效检测范围和灵敏度的方法。实验验证了非归零调制时偏振度与偏振模色散关系特性。     

Effects of carbon convection field on large diamond growth under high-pressure high-temperature conditions

Large diamond crystals were successfully synthesized by FeNi-C system using temperature gradient method under high-pressure high-temperature conditions. The assembly of the growth cell was improved and the growth process of diamond was investigated. Effects of the symmetry of carbon convection field around the growing diamond crystal were investigated systematically by adjusting the position of seed crystal in the melted catalyst/solvent. The results indicate that morphologies and metal inclusion distributions of the synthetic diamond crystals vary obviously in both symmetric and non-symmetric carbon convection fields with temperature. Moreover, finite element method was applied to analyze carbon convection mode of the melted catalyst/solvent around the diamond crystal. This work is helpful for understanding the growth mechanism of diamond.     

Effect of FeS doping on large diamond synthesis in FeNi-C system

The large single-crystal diamond with FeS doping along the(111) face is synthesized from the FeNi–C system by the temperature gradient method(TGM) under high-pressure and high-temperature(HPHT). The effects of different FeS additive content on the shape, color, and quality of diamond are investigated. It is found that the(111) face of diamond is dominated and the(100) face of diamond disappears gradually with the increase of the FeS content. At the same time, the color of the diamond crystal changes from light yellow to gray-green and even gray-yellow. The stripes and pits corrosion on the diamond surface are observed to turn worse. The effects of FeS doping on the shape and surface morphology of diamond crystal are explained by the number of hang bonds in different surfaces of diamond. It can be shown from the test results of the Fourier transform infrared(FTIR) spectrum that there exists an S element in the obtained diamond. The N element content values in different additive amounts of diamond are calculated. The XPS spectrum results demonstrate that our obtained diamond contains S elements that exist in S–C and S–C–O forms in a diamond lattice. This work contributes to the further understanding and research of FeS-doped large single-crystal diamond characterization.     

毛细管电泳/发光二极管诱导荧光法测定麻黄中麻黄碱与伪麻黄碱含量

基于麻黄碱及伪麻黄碱衍生物的光谱及化学性质,设计并构建了毛细管电泳/发光二极管诱导荧光检测系统.对关键光学元件进行组合选择,以蓝光发光二极管为光源,BP 470和BP 530分别为光源滤光片和荧光滤光片,光电倍增管检测信号,并对电泳分离系统的缓冲溶液、分离电压等参数进行优化;以FITC为衍生试剂,10 mmol/L Na2B4O7+ 16 mmol/L SDS为缓冲溶液,12 kV电压下可实现麻黄中麻黄碱和伪麻黄碱的基线分离.在0.25～10 mg/L范围内,麻黄碱和伪麻黄碱标准溶液的质量浓度与荧光响应的峰高之间呈较好的线性关系,相关系数(r)均大于0.99,其检出限分别为0.38 μg/L和0.29 μg/L,峰高的日内重复性(RSD)分别为2.0％和2.2％,日间重复性(RSD)分别为5.4％和5.1％.将该方法用于中药麻黄中麻黄碱和伪麻黄碱的测定,加标回收率分别为94％和107％.     

高温高压生长宝石级金刚石单晶的表面特征研究

本文利用高温高压温度梯度法,NiMnCo合金作为触媒,分别采用籽晶{100}和{111}作为生长面,合成了Ib型宝石级金刚石单晶,对其表面特征进行了分析和讨论.结果发现,宝石级金刚石单晶的表面特征不具有唯一性,多数情况下,晶体{111}面明显较{100}面平整,而且{100}面生长台阶的棱角不清晰,经常会出现经触媒融融过的痕迹,并且这种现象的出现跟籽晶生长面不同和合成温度条件高低无关;{111}面有时也会出现明显的生长台阶,棱角清晰,并且形状较为规则.宝石级金刚石晶体表面特征的不唯一性说明晶体表面特征对生长条件稳定性有更高的要求.     

双维位置灵敏CsI(Tl)闪烁探测器

介绍了一种双维位置灵敏CsI(Tl)闪烁探测器, 利用GEANT4对它进行了蒙特卡罗模拟, 得到了RIB 17N的位置分布谱及探测器的空间位置分辨,　模拟结果与实验测量值很好地吻合。给出了影响探测器分辨的主要因素及改进方案。A two dimensional position sensitive CsI(Tl) scintillation detector readout with PSPMT was introduced. The performance of detector was simulated by using Monte Carlo code GEANT4. The position spectrum of RIB 17N and the detector’s position resolution were obtained, and the simulation results accorded with the experimental ones. The main factors, which can affect performance of the detector, and some planned detector improvements were presented.     

在NiMnCo-Cu-C体系中生长宝石级金刚石单晶

利用温度梯度法在NiMnCo-Cu-C体系、于5.5 GPa、1250℃条件下进行了宝石级金刚石单晶的生长研究,结果发现,Cu片在触媒中的放置位置和其在金属触媒中所占体积分数对宝石级金刚石单晶的生长具有明显影响.当Cu片放置在碳源和触媒之间时,将不会有充足的碳源扩散到籽晶上,晶体无法生长;但放在触媒中其他位置,体积分数适当时,不会对晶体生长有明显影响.随着Cu体积分数增加,优质晶体生长将变得困难,当体积分数在20;时,晶体有生长,但晶体内部跟表面明显存在由于包裹体存在造成的生长坑洞;当体积分数在40;左右时,晶体将不再生长.不过当Cu在触媒中的体积分数适当时,会降低碳源在触媒中的输运,从而对抑制自发核生长起到一定的作用.