轴流式水轮机三维非定常湍流计算及压力脉动预测

水轮机的稳定性研究是目前工程上大型水轮机组流动分析的重要课题,本文以某水电站的大型轴流转桨式水轮机原型为基础建立计算模型,完成了从蜗壳进口到尾水管出口整个流道的非定常湍流计算,预测了固定导叶进口、转轮后、尾水管进口等多个位置的压力脉动,并利用FFT变换进行分析得到了压力脉动的频率和幅值,探讨了水轮机全流道内压力脉动产生和传播的原理．     

铋化物发光玻璃中银表面等离激元对铒离子的发光增强作用

局域表面等离激元可以由自由空间的光直接激发,这也是局域表面等离激元的优点所在。研究铋化物发光玻璃中纳米银颗粒的表面等离激元对铒离子发光的增强效应、进一步的提高铋化物发光玻璃中铒离子的发光性能很有意义。首先,测量了(A)Er 3+(0.5%)Ag(0.5%):铋化物发光玻璃与(B)Er 3+(0.5%):铋化物发光玻璃样品的吸收谱,发现(A)Er 3+(0.5%)Ag(0.5%):铋化物发光玻璃在约600.0 nm处有一个较弱的宽的银表面等离激元共振吸收峰。同时发现两者都有典型的铒离子的吸收峰,它们的吸收几乎完全一样:在波峰形状、峰值强度和峰值波长等方面都很相近。测量了(A)Er 3+(0.5%)Ag(0.5%):铋化物发光玻璃和(B)Er 3+(0.5%):铋化物发光玻璃样品的激发谱,发现有位于379.0,406.0,451.0,488.0和520.5 nm的5个550.0 nm可见光的可见激发谱峰,和位于379.0,406.5,451.0,488.5,520.5,544.0,651.5和798.0 nm的8个1531.0 nm红外光的红外激发谱峰,容易指认出依次为Er 3+的4I 15/2→4G 11/2,4I 15/2→2H 9/2,4I 15/2→(4F 3/2,4F 5/2),4I 15/2→4F 7/2,4I 15/2→2H 11/2,4I 15/2→4S 3/2,4I 15/2→4F 9/2和4I 15/2→4I 9/2跃迁的吸收峰,通过测量发现(A)Er 3+(0.5%)Ag(0.5%):铋化物发光玻璃相对于(B)Er 3+(0.5%):铋化物发光玻璃样品的可见和红外激发谱的最大增强依次分别是238%和133%。最后,测量了它们的发光谱,发现有位于534.0,547.5和658.5 nm的三组可见发光峰,容易指认出依次为Er 3+的2H 11/2→4I 15/2,4S 3/2→4I 15/2,4F 9/2→4I 15/2荧光跃迁。还发现红外发光峰位于978.0和1531.0 nm,依次为Er 3+的4I 11/2→4I 15/2和4I 13/2→4I 15/2的荧光跃迁。通过测量发现(A)Er 3+(0.5%)Ag(0.5%):铋化物发光玻璃相对于(B)Er 3+(0.5%):铋化物发光玻璃样品的可见和红外发光谱的最大增强依次分别是215%和138%。对于银表面等离激元增强铒离子发光的机理,认为主要为纳米银颗粒的局域表面等离激元共振,造成金属纳米结构附近产生的局域电场的强度要远大于入射光的电场强度,从而导致了金属纳米结构对入射光产生强烈的吸收和散射,进而导致了荧光的增强;即局域表面等离子体共振局域场的场增强效应。     

定量核磁共振波谱法测定3种低聚果糖的含量北大核心CSCD

以蔗糖为内标物,氘代水为溶剂,采用氢-1核磁共振波谱法(1H-NMR)测定蔗果七糖、蔗果八糖、蔗果九糖等3种低聚果糖(FOS)的含量。优化后的1H-NMR参数如下:温度25℃,谱宽(2~14)×10^(-6),脉冲角度45°,脉冲延迟时间5 s,采样时间3 s,扫描次数16次。对蔗果七糖、蔗果八糖和蔗果九糖样品进行了仪器精密度和重复性试验,测定值的相对标准偏差(n=6)均小于0.50%。方法用于测定3种样品含量,测定结果与质量平衡法所得结果进行了比较,经F检验法评估,两种方法具有显著性差异。但由于定量核磁共振波谱法作为绝对含量的测定方法,仅需常见的化学品即可直接对待测成分进行测定,可以佐证质量平衡法的赋值结果。     

以磷化铁为添加剂沿(111)面生长磷掺杂金刚石大单晶

掺杂是调控金刚石性能的一种重要手段。本文采用温度梯度法,在5.6 GPa、1 312 ℃的条件下,选用Fe₃P作为磷源进行磷掺杂金刚石大单晶的合成。金刚石样品的显微光学照片表明,随着Fe₃P添加比例的增加,金刚石晶体的颜色逐渐变深,包裹体数量逐渐增加,晶形由板状转变为塔状直至骸晶。金刚石晶形的变化表明Fe₃P的添加使生长金刚石的V形区向右偏移,这是Fe₃P改变触媒特性的缘故。红外光谱分析表明,Fe₃P的添加使金刚石晶体中氮含量上升,这说明磷的进入诱使氮原子更容易进入金刚石晶格中。激光拉曼光谱测试表明,随着Fe₃P添加比例的增加,所合成的掺磷金刚石的拉曼峰位变化不大,其半峰全宽(FWHM)值变大,这说明磷的进入使得金刚石晶格畸变增加。XPS测试结果显示,随着Fe₃P添加比例的增加,金刚石晶体中磷相对碳的原子百分含量也会增加,这意味着添加Fe₃P所合成的金刚石晶体中有磷存在。     

SI2-拟代数空间

在T0空间上引入了SI2-代数空间和SI2-拟代数空间的概念,讨论了它们的一些性质,证明了：(1)一个T0空间(X,τ)为SI2-代数的当且仅当(X,τSI2)为B-空间;(2)一个T0空间(X,τ)为SI2-拟代数的当且仅当(X,τSI2)为超紧基空间;(3)一个T0空间(X,τ)为SI2-代数的当且仅当(X,τ)为交SI2-连续和SI2-拟代数的。     

碳纳米纤维负载钯催化剂的制备及其催化性能研究

通过静电纺丝和碳化技术,将聚丙烯腈制备成碳纳米纤维并用于负载钯催化剂.扫描电镜(SEM)表征结果显示,碳化过程虽使部分纤维融合,但纤维结构保持良好;透射电镜(TEM)图显示,碳化过程中Pd原子有一定程度地聚集,形成了直径约为15nm的颗粒.催化结果表明,该催化剂对碘代芳烃和丙烯酸酯的Heck偶联反应具有良好的催化活性,生成物反式肉硅酸酯的产率较高;该催化剂至少可以重复使用5次（保持催化活性不变）,显示出良好的稳定性.     

Fe和Ni共掺杂ZnO的电子结构和光学性质

基于密度泛函理论的第一性原理研究Fe,Ni单掺杂和(Fe,Ni)共掺杂纤锌矿型ZnO的能带结构、电子态密度分布、介电函数、光学吸收系数,分析了掺杂后电子结构与光学性质的变化.计算结果表明：掺杂体系的费米能级附近电子态密度主要来源于Fe 3d,Ni 3d态电子的贡献;与纯净ZnO相比,Fe,Ni单掺杂和(Fe,Ni)共掺杂ZnO的介电函数虚部均在0.46eV左右出现了一个新峰;Fe,Ni单掺杂和共掺杂ZnO的吸收光谱均发生明显的红移,并都在1.3eV处出现较强吸收峰.结合他人的计算和实验结果,给出了定性的讨 关键词： 氧化锌 掺杂 第一性原理 光学性质     

Theoretical calculation of the partial cross section for first vibrational excitation in He-H2（D2,T2） collisions

In this paper, close-coupling method was applied to the He-H2 （D2,T2） system, and the first vibrational excitation cross sections of ＇00-10, 00-12, 00-14, 00-16＇ at different incident energy have been calculated. By analyzing the ditferences of these partial wave cross sections, this paper have obtained the change rules of the partial wave cross sections with increases of quantum number, and with change of reduced mass of system. Based on the calculation, influence on the partial wave cross sections brought by the variations in the reduced mass of systems and in the relative kinetic energy of incident atoms is discussed.[第一段]     

Be-composition effect on structure, electronic and optical properties of BexZn1-xO alloys

This paper carries out first principles calculation of the structure,electronic and optical properties of Be x Zn 1 x O alloys based on the density-functional theory for the compositions x = 0.0,0.25,0.5,0.75,1.0.The lattice constants deviations of alloys obey Vegard’s law well.The Be x Zn 1 x O alloys have the direct band gap(Γ-Γ) character,and the bowing coefficients are less than the available theoretical values.Moreover,it investigates in detail the optical properties(dielectric functions,absorption spectrum and refractive index) of these ternary mixed crystals.The obtained results agree well with the available theoretical and experimental values.     

Synthesis and characterization of p-type boron-doped IIb diamond large single crystals

High-quality p-type boron-doped IIb diamond large single crystals are successfully synthesized by the temperature gradient method in a china-type cubic anvil high-pressure apparatus at about 5.5 GPa and 1600 K.The morphologies and surface textures of the synthetic diamond crystals with different boron additive quantities are characterized by using an optical microscope and a scanning electron microscope respectively.The impurities of nitrogen and boron in diamonds are detected by micro Fourier transform infrared technique.The electrical properties including resistivities,Hall coefficients,Hall mobilities and carrier densities of the synthesized samples are measured by a four-point probe and the Hall effect method.The results show that large p-type boron-doped diamond single crystals with few nitrogen impurities have been synthesized.With the increase of quantity of additive boron,some high-index crystal faces such as {113} gradually disappear,and some stripes and triangle pits occur on the crystal surface.This work is helpful for the further research and application of boron-doped semiconductor diamond.