CS-CMC聚合物电解质膜的制备及在电生成FeO_4~(2-)中的应用

以戊二醛为交联剂,制备了壳聚糖(CS)-羧甲基纤维素(CMC)聚合物电解质膜.用电子显微镜观察其表面形貌.IR分析表明该聚合物薄膜含有COOH,NH 3官能团,具有两性离子的特征.与CS膜或CMC膜相比,该膜能稳定存在于酸碱溶液中.膜特性研究表明CS-CMC聚合物电解质膜具有离子交换和选择性渗透能力,可作为隔膜电解制备高铁酸盐.     

荧光标记-高效液相色谱测定多肽（PC2～PC6）的研究

基于多肽(Polypeptides PC2~PC6)中富有巯基(-SH)官能团,其与单溴二胺(Monobromobimanes mBBr)能够发生缩合反应,生成具有荧光信号的多肽衍生物;通过优化色谱分离条件,建立了高效液相色谱(荧光检测器)测定多肽的方法;试验中利用质谱鉴定了PCs与mBBr缩合反应的比例关系。结果显示,通过比较PCs标记前后化合物的质谱图,PCs与mBBr反应比例关系为1∶1,稳定性好;高效液相色谱-荧光法测定多肽化合物,五种化合物间分离度较好,出峰时间集中在16.6~22.0min间;PC2,PC3,PC4,PC5和PC6线性相关性系数>0.999 1,方法定量限分别为0.3,0.05,0.3,0.5和0.8 mg·L-1,回收率范围为83.0%~102.0%;重线性较好,RSD<2.0%,该方法实现了多肽类化合物快速、准确定量分析。     

Synthesis and Characterization of Titanium-doped Ordered Mesoporous Alumina

Titanium-doped ordered mesoporous alumina with specific structural properties has been prepared by the evaporation induced self-assembly sol-gel method. The results show that the doped titanium helps to stabilize the ordered mesoporous alumina material without influencing the ordered mesoporosity. The textural properties of the obtained sample are related to the amount of doped titanium. When the molar ratio of aluminum to titanium(n(Al)/n(Ti)) is controlled as 10.2, the titanium-doped ordered mesoporous alumina exhibits high surface area(up to 218 m2 g-1), large pore volume(0.42 cm3 g-1) and narrow pore diameter(6.1 nm) after treating at 900 ℃, showing high thermal stability. Moreover, the obtained sample calcined at 900 ℃ still maintains ordered mesoporous structure and exhibits high thermal stability.     

Preliminary communication - The synthesis and thermotropic liquid crystalline behaviour of novel main chain poly(aryl ether ketone)s containing a lateral phenyl group

Novel main chain poly(aryl ether ketone)s containing a lateral phenyl group were synthesized by nucleophilic substitution reactions of 4,4-biphenol and phenylhydroquinone with either 4,4-difluorobenzophenone or 1,4-bis(4-fluorobenzoyl)benzene and their thermotropic liquid crystalline properties were characterized by a variety of experimental techniques. Thermotropic liquid crystalline behaviour was observed in the copolymers containing 50 and 70 mol% biphenol. Melting (Tm) and isotropization (Ti) transitions both appeared on the DSC thermograms. A banded texture was formed after shearing the sample in the liquid crystalline nematic state. As expected, each of the copolymers had a relatively lower melting transition than the biphenol-based homopoly(aryl ether ketone)s because of the copolymerization effect of the crystal-disrupting monomer phenylhydroquinone.     

新型聚苯胺共聚物季铵盐的合成与性能研究

以邻硝基苯甲酸和苯胺为原料,经6步反应合成了一种新型的聚[苯胺-N-(2-氯乙基)-2-氨基苯甲酰胺]共聚物季铵盐(6),其结构和性能经UV-Vis,IR,X-射线衍射和离子交换容量表征。结果表明,季铵化成盐后,6的IR和UV吸收带发生了明显蓝移;6具有较好的共轭性,可能呈导电性;6呈非晶态结构,能溶于甲醇和DMF等极性溶剂,具有一定的离子交换能力。     

实验室安全环保意识的调查与分析——以中山大学化学类专业学生为例

A survey about students' laboratory safety and environmental protection consciousness was performed in the freshmen majored in chemistry at Sun Yat-Sen University. Results showed that laboratory safety and environmental protection consciousness of most students' are weak. After analyzing the reasons, we put forward some suggestions. Cultivating students' laboratory safety and environmental protection consciousness should be carried out from several aspects such as emphasizing and regulating from school level, training in laboratory teaching, maintaining good cultural atmosphere of laboratory, as well as providing perfect laboratory safety and environmental protection facilities. We should guide students to actively learn knowledge and skills of laboratory safety and environmental protection in order to develop their good behavior and raise their consciousness.     

不同碱基物质对燃煤烟气脱氯的影响

实验探究NaOH、Na₂CO₃、NaHCO₃这三种常见的碱基物质在模拟燃煤烟气中的实际表现，发现三种碱基物质均具有一定的脱氯性能，NaOH、Na₂CO₃、NaHCO₃的脱氯性能依次下降，以脱氯效率70%为目标，使用三种碱基物质Na/Cl比分别需要达到5.8、7.1、8.7。高浓度SO₂的存在对烟气脱氯有竞争作用，随着SO₂浓度的提高，脱氯效率线性下降，不同碱基物质下，SO₂浓度对脱氯效率的影响规律基本一致，SO₂浓度每增加100 mg/m³，脱氯效率下降约1.4%。由于三种碱基物质达到相同脱氯效率时的Na/Cl比不同，综合考虑成本和溶解性，NaOH最具工业应用价值。     

低温燃烧法制备Mn-CeO_x催化剂及其NH_3-SCR脱硝性能

通过低温燃烧法(LCS)制备了不同金属硝酸盐与柠檬酸物质的量比的系列Mn-CeO_x(LCS)锰铈催化剂,将其与共沉淀法(CP)制备的Mn-CeO_x(CP)锰铈催化剂相对比,结合XRD、XPS、FESEM和H2-TPR等技术表征,对其NH_3-SCR脱硝催化性能进行了研究。结果表明,金属硝酸盐与柠檬酸的物质的量比是影响Mn-CeO_x(LCS)催化剂脱硝性能的重要因素。虽然两种催化剂中的锰氧化物组分均为无定型,但相较于Mn-CeO_x(CP),Mn-CeO_x(LCS)表面具有较高的锰含量与Oα/(Oα+Oβ)比,其脱硝催化性能也较高;同时,Mn-CeO_x(LCS)锰铈催化剂上有更多的多级孔,有利于气体在催化剂上的吸附和反应。硝酸盐与柠檬酸物质的量比为36∶22的Mn-CeO_x(LCS)锰铈催化剂在80-180℃下脱硝率可达75%-100%;即使通入SO2,180℃下的脱硝率仍可稳定于74%。