Rapid method for evaluating reversed-phase high-performance liquid chromatography column stability

A procedure is presented for the rapid evaluation of HPLC stationary phase stability at pH 8.4 or 10.1 using a temperature of 60 degrees C. Mobile phase (MeOH-0.1 mol l(-1) aqueous NaHCO3, 50:50, v/v) is continuously passed through the column with periodic injections of a test solution until the several chromatographic parameters of the resulting chromatograms are degraded. The tests were applied to several commercial and laboratory-made stationary phases. After degradation two of these phases, one commercial and one laboratory-made, were examined by elemental analysis and scanning electron microscopy to elucidate the degradation process.     

Persistent bissilylated arenium ions

A series of bissilylated arenium ions 1 with different substitution patterns on the aryl ring have been synthesized by hydride abstraction from 2-aryl-substituted 2,6-dimethyl-2,6-disilaheptanes (2) via transient silylium ions. The arenium ions have been identified by their characteristic NMR chemical shifts, (delta(29)Si=19.1-25.6, delta(13)C(ipso) =89.0-102.4, delta(13)C(ortho)=160.9-182.0, delta(13)C(meta)=132.5-146.9, delta(13)C(para)=150.2-169.9) supported by quantum mechanical calculations of structures, energies, and magnetic properties at the B3LYP/6-311G(d,p)//B3LYP/6-31G(d) + DeltaZPVE level of theory. The calculations clearly reveal the charge dispersing and stabilizing effect of the silyl substituents in arenium ions 1. The bissilylated benzenium ion 1a is more stable than the parent benzenium ion (C(6)H(7)(+)) by 37.6 kcalmol(-1). The synthesized arenium ions 1 are stable in solution at room temperature for periods ranging from a few hours to days. This unusual stability is attributed to: 1) the thermodynamic stabilization of the arenium ion by two beta-silyl substituents and 2) the essentially non-nucleophilic reaction conditions (the use of the weakly coordinating [B(C(6)F(5))(4)](-) anion and aromatic hydrocarbons as solvents). Addition of stronger nucleophiles than aromatic hydrocarbons (for example, acetonitrile) results in desilylation of the arenium ion 1 and recovery of the 2-aryl-2,6-disilaheptane moiety.     

High-performance liquid chromatographic determination of cocaine and benzoylecgonine by direct injection of human blood plasma sample into an alkyl-diol-silica (ADS) precolumn

A column-switching high-performance liquid chromatographic method with UV detection for the determination of cocaine (COC) and benzoylecgonine (BZE) in human blood plasma samples is described. The method uses an alkyl-diol-silica ADS-C18 extraction precolumn. A 50- micro L plasma sample was introduced to the ADS precolumn in order to separate the analytes from proteins and endogenous compounds. The fraction containing COC and BZE was back-flushed and transferred to an Alltech mixed-mode C(18)/cation-exchange analytical column for final separation. The validation of the method revealed quantitative recoveries from 95.0 to 99.0% for COC at three different concentrations (0.5, 1.0 and 2.0 micro g mL(-1)), and from 96.0 to 99.0% for BZE at the same concentration levels with coefficients of variation <4.00% (n=5). The detection limit (signal to noise ratio (S/N)>3) was 0.03 micro g mL(-1) for all the compounds with an injection volume of 50 micro L. However, it was possible to enhance the sensitivity further by injecting larger plasma volumes, up to 200 micro L, at the same optimal conditions. The overlap of sample preparation, analysis and reconditioning of the extraction column, increase the overall sample throughput to 5 samples h(-1). The developed method has been applied to human blood plasma samples from subjects suspected of cocaine abuse.     

Ligand adsorption on an activated carbon for the removal of chromate ions from aqueous solutions

The results presented in this work are related to the design of a guideline to develop specific properties at the surface of an activated carbon (AC). For this, two model aromatic compounds have been synthesized and their electrolytic behavior in aqueous solutions was studied by a potentiometric method. The textural characteristics of the activated carbon were determined by porosimetry methods. The nature of oxygen-carrying functions and the acid-base behavior of the AC surface were characterized by TPD and potentiometric titration methods, respectively. The adsorption and desorption equilibria of the aromatic compounds on activated carbon were measured in aqueous solutions, and the hysteresis between adsorption and desorption, which reveals irreversible adsorption, was discussed on the basis of the frontier orbital theory. HOMO and LUMO orbitals of the adsorbent and adsorbates were calculated, and irreversible adsorption was attributed to the small energy difference between HOMO and LUMO of the aromatic adsorbates and the adsorbent. Adsorption equilibria of K2CrO4 in aqueous solution on the AC alone and on the AC-aromatic ligand adsorbents, respectively, prove the efficient development of specific chemical functions at the carbon surface provided by the adsorbed aromatic compounds.     

Particle-size distribution of polycyclic aromatic hydrocarbons in urban air in southern Spain

The size distribution of polycyclic aromatic hydrocarbons (PAH) was determined for airborne particles from a large city with high vehicular traffic. The analytical method was optimised and validated using NIST standard reference material (SRM 1649a Urban Dust). The 16 priority PAH listed in the US-EPA were Soxhlet-extracted from filtered particulate matter and then fractionated using on-column chromatography. The aromatic fraction was quantified by gas chromatography-mass spectrometry. Real samples of particles collected in Seville (Spain) were analysed using the validated method. Values for the total concentration of PAH in the air, as well as the concentrations of each PAH in six particle-size ranges were obtained. Values of the PAH in TSP, PM₁₀, PM_2.5 and PM₁ were assessed.     

Flow injection determination of bismuth in urine by successive retention of Bi(III) and tetrahydroborate(III) on an anion-exchange resin and hydride generation atomic absorption spectrometry

Bismuth as BiCl₄⁻ and BH₄⁻ ware successively retained in a column (150 mm × 4 mm, length × i.d.) packed with Amberlite IRA-410 (strong anion-exchange resin). This was followed by passage of an injected slug of hydrochloric acid resulting in bismuthine generation (BiH₃). BiH₃ was stripped from the eluent solution by the addition of a nitrogen flow and the bulk phases were separated in a gas–liquid separator. Finally, bismutine was atomized in a quartz tube for the subsequent detection of bismuth by atomic absorption spectrometry. Different halide complexes of bismuth (namely, BiBr₄⁻, BiI₄⁻ and BiCl₄⁻) were tested for its pre-concentration, being the chloride complexes which produced the best results. Therefore, a concentration of 0.3 mol l⁻¹ of HCl was added to the samples and calibration solutions. A linear response was obtained between the detection limit (3σ) of 0.225 and 80 μg l⁻¹. The R.S.D.% (n = 10) for a solution containing 50 μg l⁻¹ of Bi was 0.85%. The tolerance of the system to interferences was evaluated by investigating the effect of the following ions: Cu²⁺, Co²⁺, Ni²⁺, Fe³⁺, Cd²⁺, Pb²⁺, Hg²⁺, Zn²⁺, and Mg²⁺. The most severe depression was caused by Hg²⁺, which at 60 mg l⁻¹ caused a 5% depression on the signal. For the other cations, concentrations between 1000 and 10,000 mg l⁻¹ could be tolerated. The system was applied to the determination of Bi in urine of patients under therapy with bismuth subcitrate. The recovery of spikes of 5 and 50 μg l⁻¹ of Bi added to the samples prior to digestion with HNO₃ and H₂O₂ was in satisfactory ranges from 95.0 to 101.0%. The concentrations of bismuth found in six selected samples using this procedure were in good agreement with those obtained by an alternative technique (ETAAS). Finally, the concentration of Bi determined in urine before and after 3 days of treatment were 1.94 ± 1.26 and 9.02 ± 5.82 μg l⁻¹, respectively.     

Determination of amino acids in apple extracts by high performance liquid chromatography

Summary A rapid and sensitive method for the simultaneous determination of primary amino acids in apple is described. After sample preparation, amino acids were derivatized with o-phthaldialdehyde/2-mercaptoethanol and separated on a reversed phase column with a gradient of phosphate buffer-tetrahydrofuran-methanol as the mobile phase. Detection was carried out with a fluorescence detector at excitation and emission wavelengths of 340 nm and 425 nm respectively. Recovery studies showed good results for all substances (91–109%) (with coefficients of variation ranging, from 0.1 to 9.0%). This method was applied to the monitoring of amino acids during the ripening of apples.     

Selenium speciation in animal tissues after enzymatic digestion by high-performance liquid chromatography coupled to inductively coupled plasma mass spectrometry

A procedure is described for the enzymatic digestion of tuna and mussel samples that allows the determination of selenium species by high-performance liquid chromatography in conjunction with inductively coupled plasma mass spectrometry. The species were extracted by two-step enzymatic hydrolysis with a non-specific protease (subtilisin). The selenium species were separated on a Spherisorb 5 ODS/AMINO column using two different chromatographic conditions, namely phosphate buffers at pH 2.8 and pH 6.0 as mobile phases. The method determines organic (trimethylselenonium, selenocystine, selenomethionine and selenoethionine) and inorganic selenium species (selenite and selenate), but only organic selenium species were found in the samples. The sum of identified selenium species in the sample was about 30% of the total selenium present in the enzymatic extract despite the fact that recoveries of total hydrolysed selenium were 93-102%. Trimethylselenonium ion and selenomethionine were found in both tuna and mussel samples and an unknown selenium species was also found in tuna samples.     

Determination of zinc by flow injection with fluorimetric detection in a micellar medium

A room-temperature flow injection spectrofluorimetric method is presented for the determination of Zn(II), based on the use of salicylaldehyde thiocarbohydrazone in the presence of Triton X-100 and sodium acetate-acetic acid buffer. Various physical and chemical variables affecting the reaction in the flow system were evaluated. The proposed method is very selective. The calibration graph is linear over the range 10-1000 ng/ml, with a detection limit of 5 ng/ml and a relative standard deviation at the 50 ng/ml level of 1.8 %. The method was successfully applied to the determination of Zn(II) in drinking waters and biological samples.     

On the Structure and Formation of Self-Assembled Lattices of Gold Nanoparticles

The structure and ordering of nanoparticles of gold functionalized with n-alkyl thiol molecules are studied both experimentally and theoretically. Samples where produced using n=6 to n=16 alkyl thiol molecules. High Resolution Electron Microscopy coupled with image processing was used to study the gold particle structure. The details of the particle structure are discussed. We found that when the gold surface is saturated with thiol molecules there is some tendency to produce molecules with a disulphide structure. We also show that ordered arrays of particles can be produced using Langmuir-Blodgett techniques. The crystal structure of the films produced is studied and found to be 3D hcp. We also report that thiol covered gold particles with a size of 5 nm present a rounded shape suggesting that thiol molecules might induce an isotropic surface energy. It is found in the theoretical calculations that a strong bond between gold and sulphur is required to stabilize the complex metal-n-alkyl thiol. It is predicted that otherwise a heavily distorted nanocore will be formed. This is contrary to the observed structure of the particles.