Effect of Fe on the glass-forming ability,structure and devitrification behavior of Zr–Cu–Al bulk glass-forming alloys

We report on the glass-forming ability and devitrification behavior of Zr₆₀Cu₃₀Al₁₀, Zr₆₀Cu₂₅Al₁₀Fe₅ and Zr_62.5Cu_22.5Al₁₀Fe₅ bulk glass-forming alloys on heating. The effect of Fe addition on the structure of Zr–Al–Cu alloys is also discussed. Crystallization kinetics and structural changes in the glassy alloys were studied using X-ray diffraction, transmission electron microscopy, differential scanning and isothermal calorimetry methods. The results indicate that good glass-formers, such as Zr_62.5Cu_22.5Al₁₀Fe₅, are located somewhat beyond the equilibrium eutectic point. Possible phase separation in the supercooled liquid on heating and electron beam-induced in situ crystallization are observed and discussed.     

Spectral Database Systems: A Review

Abstract: Spectroscopy has been demonstrated to be an important method of analysis and detection. A spectral database system (SDBS) can not only satisfy the traditional requirements for spectral management but also provides several new functions, including spectra sharing on the website and web-based and real-time analysis and detection. Chemists and spectroscopists could analyze and detect pure materials and some mixtures rapidly with the help of standard SDBS, and now they are trying to improve these systems to fulfill rapid analysis for complex mixtures, even those as complex as agro-products. Overall, SDBS make it possible to analyze and detect unknown samples rapidly and nondestructively. This article focuses on significant progress in research on infrared (IR), near-infrared (NIR), and Raman SDBSs. Additionally, the drawbacks and obstacles of SDBSs are summarized and trends are discussed.     

Estimation of an important constant in sieve method

ζ _k is one of the most important constant in the sieve methods. This paper gives the relatively accurate lower bound and upper bound on it, that is, , wherec=1.22... andk>16.     

An improved evaluation of the neutron background in the PandaX-Ⅱ experiment

In dark matter direct detection experiments,neutron is a serious source of background,which can mimic the dark matter-nucleus scattering signals.In this paper,we present an improved evaluation of the neutron background in the PandaX-II dark matter experiment by a novel approach.Instead of fully relying on the Monte Carlo simulation,the overall neutron background is determined from the neutron-induced high energy signals in the data.In addition,the probability of producing a dark-matter-like background per neutron is evaluated with a complete Monte Carlo generator,where the correlated emission of neutron(s)andγ(s)in the(α,n)reactions and spontaneous fissions is taken into consideration.With this method,the neutron backgrounds in the Run 9(26-ton-day)and Run 10(28-ton-day)data sets of PandaX-II are estimated to be(0.66±0.24)and(0.47±0.25)events,respectively.     

CaPtAs: A new noncentrosymmetric superconductor

We report the discovery of a new noncentrosymmetric superconductor CaPtAs.It crystallizes in a tetragonal structure(space group I41md,No.109),featuring three dimensional honeycomb networks of Pt-As and a much elongated c-axis(a=b=4.18?,and c=43.70?).The superconductivity of CaPtAs with Tc=1.47 K was characterized by means of electrical resistivity,specific heat,and ac magnetic susceptibility.The electronic specific heat Ce(T)/T shows evidence for a deviation from the behavior of a conventional BCS superconductor,and can be reasonably fitted by a p-wave model.The upper critical fieldμ0Hc2 of CaPtAs exhibits a moderate anisotropy,with an in-plane value of around 204 mT and an out-of-plane value of 148 mT.Density functional theory calculations indicate that the Pt-5 d and As-4 p orbitals mainly contribute to the density of states near the Fermi level,showing that the Pt-As honeycomb networks may significantly influence the superconducting properties.     

基于连续量子级联激光器的1103.4cm–1处NH3混叠吸收光谱特性研究

由于NH3在大气气溶胶化学中具有重要作用,所以快速和精确反演NH3浓度对环境问题非常重要.本文以9.05μm的室温连续量子级联激光器(quantum cascade laser,QCL)作为光源,采用波长扫描直接吸收可调谐二极管激光吸收光谱(tunable diode laser absorption spectroscopy,TDLAS)技术,研究了QCL在1103.4 cm–1的光谱特性,获得了激光器控制的温度电流与波长的关系.设计了QCL二级温控的低压实验平台,测量氨气在1103.4 cm–1处的6条混叠吸收线,在降低压强的情况下谱线展宽变小,使混叠光谱分离,由此计算各条吸收线的线强,进一步对测量不确定度进行分析.针对混叠严重的光谱提出了低压分离单光谱精确反演气体浓度的方法,并进行了实验验证.通过与HITRAN数据库进行结果对比,得出氨气在1103.4 cm–1的实验测量线强值与数据库偏差为2.71%-4.71%,实验测量线强值的不确定度在2.42%-8.92%,极低压条件下反演浓度与实际值的偏差在1%-3%.     

Real-time phase measurement and correction of dynamic multimode beam using a single spatial light modulator

In this Letter,a novel system for adaptively correcting the phase of a dynamic multimode beam is proposed.While using merely one spatial light modulator,the phase measurement of the first-order diffraction pattern and the correction of the zeroth diffraction order are simultaneously realized.The real-time experimental result is obtained at a control rate of 10 Hz.The power-in-the-bucket value is improved from 38.5%to 61.8%,even with fundamental mode content that is consistently below 30%.To the best of our knowledge,this is the first implementation of real-time adaptive correction of the entire multimode beam.     

Multi-reference lens-less Fourier-transform holography with a Greek-ladder sieve array

Lens-less Fourier-transform holography has been actively studied because of its simple optical structure and its single-shot recording.However,a low-contrast interferogram between the reference and object waves limits its signal to noise ratio.Here,multi-reference lens-less Fourier-transform holography with a Greek-ladder sieve array is proposed in the experiment and demonstrated effectively to improve the signal to noise ratio.The key technique in our proposed method is a Greek-ladder sieve array,which acts as not only a wave-front modulator but also a beam splitter.With advantages of the common path,single shot,and no need for a lens,this system has enormous potential in imaging and especially in extreme ultraviolet and soft X-ray holography.     

Generation of 131 fs mode-locked pulses from 2.8μm Er:ZBLAN fiber laser

We demonstrated a femtosecond mode-locked Er:Zr F4-Ba F2-La F3-Al F3-Na F(Er:ZBLAN)fiber laser at 2.8μm based on the nonlinear polarization rotation technique.The laser generated an average output power of 317 m W with a repetition rate of 107 MHz and pulse duration as short as 131 fs.To the best of our knowledge,this is the shortest pulse generated directly from a mid-infrared mode-locked Er:ZBLAN fiber laser to date.Numerical simulation and experimental results confirm that reducing the gain fiber length is an effective way to shorten the mode-locked pulse duration in the Er:ZBLAN fiber laser.The work takes an important step towards sub-100-fs mid-infrared pulse generation from mode-locked Er:ZBLAN fiber lasers.     

介质材料二次电子发射特性对微波击穿的影响

以介质填充的平行板放电结构为例,本文主要研究了介质填充后微波低气压放电和微放电的物理过程.为了探究介质材料特性对微波低气压放电和微放电阈值的影响,本文采用自主研发的二次电子发射特性测量装置,测量了7种常见介质材料的二次电子发射系数和二次电子能谱.依据二次电子发射过程中介质表面正带电的稳定条件,计算了介质材料稳态表面电位与二次电子发射系数以及能谱参数的关系.在放电结构中引入与表面电位相应的等效直流电场后,依据电子扩散模型和微放电中电子谐振条件,分别探讨了介质表面稳态表面电位的大小对微波低气压放电和微放电阈值的影响.结果表明,介质材料的二次电子发射系数以及能谱参数越大,介质材料的稳态表面电位也越大,对应的微波低气压放电和微放电阈值也越大.所得结论对于填充介质的选择有一定的理论指导价值.