Dust acoustic wave in a dusty plasmas with streaming ions and nonadiabatic dust charge variation

The effects of nonadiabatic dust charge fluctuation on the nonlinear propagation of the dust acoustic (DA) solitary wave in collisionless dusty plasma with streaming ions have been investigated. By using the reductive perturbation technique, a modified Korteweg-de Vries (mKdV) equation governing the nonlinear waves was derived and the solitary solution of the mKdV equation was also obtained. It was shown that the damping rate of the slow mode DA solitary wave was strongly affected by the ion streaming velocity.     

Atomistic simulations of mechanical properties of graphene nanoribbons

The mechanical behavior of graphene nanoribbons (GNRs) was investigated by molecular dynamics (MD) simulations. The simulation results showed that GNRs behave nonlinear elastically under tensile loads. When the strain exceeds 18%, the stress stiffening causes an increase in the Young's modulus. The width of a GNR has slight effects on the Young modulus and fracture strength. The maximum strain at which fracture occurs can reach 30.26% with an intrinsic strength of about 0.175 TPa. The excellent flexibility is attributed to the elongation of the CC bonds and the variations of the bond angles.     

Choosing effective controlled nodes for scale-free network synchronization

Previous studies concerning pinning control of complex-network synchronization have very often demonstrated that in an unweighted symmetrical scale-free network, controlling the high-degree nodes is more efficient than controlling randomly chosen ones; due to the heterogeneity of the node-degree or edge-connection distribution of the scale-free network, small-degree nodes have relatively high probabilities of being chosen at random but their control has less influence on the other nodes through the network. This raises the question of whether or not controlling the high-degree nodes is always better than controlling the small ones in scale-free networks. Our answer to this is yes and no. In this study, we carry out extensive numerical simulations to show that in an unweighted symmetrical Barabasi-Albert scale-free network, when the portion of controlled nodes is relatively large, controlling the small nodes becomes better than controlling the big nodes and controlling randomly chosen nodes has approximately the same effect as controlling the big ones. However, we also show that for normalized weighted scale-free networks, controlling the big nodes is in fact always better than controlling the small ones.     

Dispersion of nanospheres on large glass substrate by amorphous or polycrystalline silicon deposition for localized surface plasmon resonance

Nanosphere lithography is a cost-effective way to fabricate noble metal nanostructures for plasmonics. However, dispersing nanospheres on a large area of glass substrate is a difficulty encountered when transparent substrate is required in applications such as localized surface plasmon resonance or surface enhanced Raman spectroscopy. Because poly(diallyldimethyl ammonium chloride) (PDDA) on silicon surface introduces a force that can disperse nanospheres on silicon, in this article, we modify the glass surface through amorphous or polycrystalline silicon deposition and thus well disperse polystyrene or silica nanospheres over a glass area of more than 2 cm × 2 cm. Transmission loss of the glass substrate caused by amorphous or polycrystalline silicon deposition is analyzed with good agreement to experimental spectra, and localized surface plasmon resonance signals generated from the gold nanostructures fabricated on these substrates are measured and yield a sensitivity of 317 nm/RIU, which prove the feasibility and effectiveness of our method.     

基于视觉的车辆与轨道相对振动状态测量方法研究

车辆与轨道相对振动状态对轨道线形测量有重要影响;分析了传统检测车辆与轨道相对振动状态测量方法的缺陷,提出一种基于视觉的车轨相对振动状态测量方法,以轨道建立世界坐标系,以车体建立车体坐标系。考虑相机镜头畸变,建立相机非线性模型,基于机器人手眼方法标定相机与车体,求解相机内外参数。依据车体运动姿态特征,推导基于双目机器视觉的车辆运动姿态偏移补偿计算方法;运用实验平台设计验证实验,通过计算所得的车体振动位移与真实值高度吻合,随着车速增加振动位移误差也随之增大,验证了该方法的正确性和可行性;提供一种车辆与轨道相对振动状态测量方法。     

基于SLAM的连续运动测量坐标转换算法研究

本文基于同步定位与地图创建(Simultaneous Localization and Mapping,SLAM)原理,通过双目视觉系统的坐标转换方法,建立动态坐标系与静态基准点之间的关系,实现连续运动测量。通过实验,设计运动路线,验证坐标转换算法,并得到了建立在世界坐标系下的空间线形曲线。实验结果表明：转换后的坐标,x、y、z三个方向的最大误差不超过0.734mm。     

Single-atom entropy squeezing and quantum entanglement in Tavis--Cummings model with atomic motion

We examine the single-atom entropy squeezing and the atom-field entanglement in a system of two moving twolevel atoms interacting with a single-mode coherent field in a lossless resonant cavity.Our numerical calculations indicate that the squeezing period,the squeezing time and the maximal squeezing can be controlled by appropriately choosing the atomic motion and the field-mode structure.The atomic motion leads to a periodical time evolution of entanglement between the two-atom and the field.Moreover,there exists corresponding relation between the time evolution properties of the atomic entropy squeezing and that of the entanglement between the two atoms and the field.     

一种数字全息图零级项消除的新方法

针对离轴数字全息图中的零级项问题,提出用独立分量分析方法对零级项进行压缩.首先通过CCD获取同一物体的两幅干涉强度不同的全息图构成观测信号,然后采用独立分量分析方法(Independent Component Analysis(ICA))从观测信号中分离出零级项和共轭项,再从获得的共轭项中减去残余的零级项分量,实现零级项的有效压缩,并用模拟结果论证该方法在处理零级项压缩方面的优越性和有效性.     

预处理对355nm激光作用下熔石英损伤增长的影响

测试了经化学蚀刻、紫外激光预处理及其共同处理后的熔石英355 nm激光损伤阈值;研究了处理前后其损伤斑面积随激光辐照脉冲数的增长情况。结果表明,处理后熔石英355 nm激光损伤阈值得到了提高,且损伤斑面积增长变慢。利用CO2激光对熔石英表面损伤点进行了修复处理,修复后的损伤点R-on-1抗损伤阈值和基底阈值相当,损伤增长得到有效抑制。     

箍缩背光照相

 利用PPG-Ⅰ脉冲功率装置（500 kV,400 kA,100 ns）驱动X箍缩负载,得到了μm量级的亚纳秒脉冲X射线辐射点源。在阴阳极轴线和回流柱上同时安装X箍缩负载,前者可作为背光照相的X射线点源;后者可作为被拍照的目标X箍缩。获得了X箍缩发展过程不同时刻的时间序列图像,在背光照相的图像中可以清晰观察到X箍缩交叉点处等离子体的外爆、箍缩以及最终的崩溃阶段。将阴阳极轴线上的X箍缩负载用Z箍缩丝阵负载代替,实现了对丝阵负载Z箍缩放电起始阶段的X射线背光照相,观察到了最初的各单丝电爆炸、等离子体膨胀及融合过程,同时观察到了双丝Z箍缩发展过程中的等离子体不稳定性。实验结果有助于深入理解Z箍缩发展的物理过程,同时可为有效的模拟建模分析提供基本的实验数据。