表面包覆改性对纳米CeO2分散性的影响

了改善纳米CeO2在Zn-Al类共晶合金中的分散性,采用超声液相包覆法对纳米CeO2进行表面活性剂表面包覆改性,并用AES测定了包覆层的厚度,用TEM研究了CeO2的团聚状况,用TGA分析了有机物包覆层的炭化温度范围,最后用FE-SEM观察了CeO2在复合材料中的分散情况。结果表明,包覆在纳米CeO2表面的厚度约为20 nm的表面活性剂层提高了微粒的分散性,而且该包覆层在495℃时已经炭化。热力学计算的结果也表明,炭化层能与氧化膜反应,该反应提高了CeO2与基体间的润湿性,并使其均匀分布在基体合金中。     

微波辐射下苯亚磺酸钠的S-烃基化

在微波辐射下，不用任何有机溶剂和无机载体，苯亚磺酸钠和卤代烃能迅速发生反应生成相应的S-烃基化产物。     

钯催化α-炔醇立体专一合成α-（Z）-氯亚甲基-β-内酯

首次在一氧化碳存在下，以仲丁醇和苯为混合反应溶剂，氯化钯和氯化铜为催 化体系催化α-炔醇羰基化，立体专一合成α-（Z）-氯亚甲基-β-内酯环。     

含双键侧基的聚氧乙烯与苯乙烯的接枝共聚物及其产物的性质

由环氧乙烷及烯丙基缩水甘油醚合成含双键侧基的聚氧乙烯用苯乙烯接枝共聚,接枝效率可达50％左右.接枝产物经纯化,用IR及~1H NMR表征.该产物与LiClO_4的络合物有较高的室温导电率,其PEO含量在70％及EO/Li=20/1时,25℃的导电率接近10~(-4)S/cm.此外,该接枝共聚物有较高的乳化能力.在Williamson固液反应中具有良好的相转移催化作用.     

Characterization of low molecular weight components of [(ViMe2SiO1/2)x(PhSiO3/2)y(SiO4/2)z], [(ViMe2SiO1/2)x(SiO4/2)y], and [(SiO4/2)x(HO1/2)y(tBuO1/2)z] silsesquioxanes by electrospray ionization fourier transform mass spectrometry (ESI-FTMS)

This paper describes the characterization of low molecular weight components of four materials using electrospray ionization Fourier transform mass spectrometry (ESI-FTMS). The materials in the current study are [(ViMe₂SiO_1/2)_x(PhSiO_3/2)_y(SiO_4/2)_z] (MTQ), [(ViMe₂SiO_1/2)_x(SiO_4/2)_y] (MQ), and [(SiO_4/2)_x(HO_1/2)_y(^tBuO_1/2)_z] (Q) silsesquioxanes. Accurate mass measurements coupled with knowledge of resin chemistry afforded siloxane composition determination that was used to propose specific structures for the oligomers. Branched or linear (T_nQ_mM_n+2m+2), and monocyclic (T_nQ_mM_n+2m) structures are predominant structures for the low molecular weight species in MTQ. For MQ and Q, more condensed structures, such as partially opened cage structures (Q_mM_2m?6 and Q_mM_2m?8), were identified. The differences between MQ, Q, and MTQ are likely attributed to differences in intrinsic structure and reactivity of T and Q building blocks. The structural information obtained for these oligomeric species will ultimately provide a better understanding of new resin materials and their associated physical properties.     

双功能催化剂体系作用下乙烯二聚和共聚合的研究

用乙烯为原料在双功能催化剂体系的作用下通过二聚和共聚合反应，直接合成线性低密度聚乙烯（ＬＬＤＰＥ）．所用二聚反应催化剂为钛酸正丁酯（Ｔｉ（ＯＢｕ）_４），共聚催化剂为ＴｉＣｌ_４／ＭｇＣｌ_２（ＺＭ－１催化剂）．研究了二聚反应动力学行为及影响双功能催化剂体系动力学过程的一些因素．结果表明利用这两种催化剂组成双功能催化剂体系能够很方便地制得密度范围在０．９０－０．９３，Ｅｔ／１０００Ｃ在１０－４０的ＬＬＤＰＥ．     

胶束溶液中高氯酸二水(四胺)合钴(Ⅲ)配合物催化磷酸二酯水解的研究

本文合成了疏水性高氯酸二水（四胺）合钴（Ⅲ）配合物，研究了它与非离子表面活性剂Brij35形成的金属2胶束催化二（对硝基苯酚）磷酸二酯水解的动力学及其机理。结果表明此金属胶束对磷酸二酯水解的速率大约提高10^4倍，这主要是由于表面活性剂胶束的pH效应和浓聚效应所致，暗示着顺式二水类配合物形成的金属胶束是一个潜在的磷酸二酯水解剪切的催化剂。     

CuO/Al2O3催化剂高温固相反应的原位XRD和Raman研究

采用原位XRD和激光Raman光谱等技术对CuO/Al2O3系列催化剂高温下的表面组成和体相结构的变化进行研究.结果表明,随着焙烧温度升高,CuO首先与载体Al2O3发生固相反应生成CuAl2O4.CuAl2O4层能阻止外层CuO进一步向载体Al2O3扩散,从而使部分CuO稳定在CuO/Al2O3催化剂的表层.     

气相色谱法测定饮料中乙醇含量

采用样品用注射器吸附后直接经C18柱后进样，用气相色谱法测定，该方法适合多样饮料中的乙醇测定，平均回收率为98．6％，检出限为7．7mg/L。     

SYNTHESIS AND CATALYTIC PROPERTY OF POLYSTYRENE SUPPORTED GLUTAMIC ACID SCHIFF BASE COMPLEX OF Mn（ Ⅱ ） IN AEROBIC OXIDATION OF CYCLOHEXENE

The polystyrene supported glutamic acid Schiff base complex of Mn （ Ⅱ ） （PS-Sal-Glue-Mn） was prepared with chloromethylated styrene polymer beads, 2,4-dihydroxybenzaldehyde, L-glutamic acid and manganese （ Ⅱ ） acetate tetrahyrate. The polymeric ligand and the complex were characterized by FT-IR, small area X-ray photoelectron spectroscopy （XPS） and 1CP-AES. In the presence of the manganese complex, cyclohexene （1） was effectively oxidized by molecular oxygen without reductant. The major products of the reaction were 2-cyclohexen-l-ol （2）, 2-cyclohexen-l-one （3） and 2-cyclohexen-1- hydroperoxide （4）, which was different with typical oxidation of cyclohexene. The influence of reaction temperature and additive for oxidation had been studied. The selectivity of 2-cyclohexen-1-hydroperoxide varied with reaction time and different additives. The mechanism of cyclohexene oxidation had also been discussed.