Simulation and fabrication of carbon nanotubes field emission pressure sensors

A novel field emission pressure sensor has been achieved utilizing carbon nanotubes (CNTs) as the electron source. The sensor consists of the anode sensing film fabricated by wet etching process and multi-wall carbon nanotubes (MWNTs) cathode in the micro-vacuum chamber. MWNTs on the silicon substrate were grown by thermal CVD. The prototype pressure sensor has a measured sensitivity of about 0.17-0.77 nA/Pa (101-550 KPa). The work shows the potential use of CNTs-based field-emitter in microsensors, such as accelerometers and tactile sensors.     

Surface and interfacial properties of PVDF/acrylic copolymer blends before and after UV exposure

Morphological and chemical properties of both the surface and interface of poly(vinylidene fluoride)/poly(methyl methacrylate)-co-poly(ethyl acrylate) (PVDF/PMMA-co-PEA) blend films have been investigated before and after the samples were exposed to ultraviolet (UV) irradiation using a xenon arc lamp at 50 °C and 9% relative humidity (RH) for 7 months. Surface and interfacial morphologies were studied by atomic force microscopy (AFM). Chemical composition information was obtained by confocal Raman microscopy, attenuated total reflection-FTIR spectroscopy (ATR-FTIR), X-ray photoelectron spectroscopy (XPS), and contact angle measurements. Results show an enrichment of the PVDF material at the air surface, while the acrylic copolymer enriches the interface. Blends having greater than 50% mass fraction of PVDF show little change in the surface morphology after UV exposure for 7 months. However, for a lower PVDF content, blends exhibit significant degradation of PMMA-co-PEA copolymer and a much rougher surface after UV exposure. Microstructural changes in the PVDF spherulites are also observed after UV degradation. It is found that the surface and interfacial morphologies are correlated with the chemical properties.     

Si衬底上ZnSe外延膜的低压MOCVD生长

以硒化氢（H2Se）和二甲基锌为源材料，生长温度是300℃时，用低压金属有机化学气相沉积（LP－MOCVD）系统在Si(111)衬底上外延生长了ZnSe薄膜。通过X射线衍射（XRD）、扫描电子显微镜的能量色散（EDS）以及光致发光（PL）实验验证ZnSe外延膜的质量，在X射线衍射谱中只有一个强的ZnSe(111)面衍射峰，这说明外延膜是（111）取向的单晶薄膜，在能量色散谱中除了Si,Zn和Se原子外，没有观测到其他原子，说明ZnSe外延膜中杂质含量较少。ZnSe外延膜中Zn/Se原子比接近1，有较好的化学配比。在ZnSe外延膜的77K光致发光谱中没有观测到与深中心发射相关的发光峰，表明ZnSe外延膜的晶格缺陷密度较小。77K时的近带边发射峰447nm在室温时移至465nm附近。     

宽带Ⅱ-Ⅵ族半导体及其低维结构的生长和光学性质研究进展

本文系自1979年以来，宽带Ⅱ-Ⅵ族半导体研究组取得的主要研究成果的简要介绍。取得的主要研究成果可分为如下六个方面：第一，系统地研究了宽带Ⅱ-Ⅵ族半导体在电场激发下的自由激子发射；第二，创造性地提出并实 利用宽带Ⅱ-Ⅵ族超晶格的室温激子效应来实现在蓝绿区快响应的光学双稳的物理思想；第三，深入研究了宽带Ⅱ-Ⅵ族超晶格中的激子行为以及激子与元激发态的相互作用，为利用激子获得有效蓝色自发和受激发射提供物理基础和实验途径；第四，研究了ZnSe基非对称双量子阱和组合超晶格中激子的隧穿以及激子的自发和受激发射；第五，CdSe和ZnSeS自组装量子点的生长及其形成机理；第六，ZnO薄膜的生长及其紫外发射特性。     

准Λ型四能级系统中的超窄谱线的研究

在一般Λ型三能级模型的基础上提出准Λ型四能级系统,并对准Λ型四能级模型的共振荧光谱作了详尽的研究.从上能级向两边下能级辐射的自发辐射谱中产生了三个超窄谱线,且在很大参数范围内光谱具有这一特性.三个超窄谱线的产生是和两个相干驱动场的Rabi频率密切相关,在较大的Rabi频率作用下谱线会变得更窄,而当只有一个驱动场作用时是不会产生谱线变窄效应的.能级间的碰撞弛豫和非相干激发严重地破坏了谱线变窄.这种超窄谱线效应是多通道量子干涉的结果 关键词： 准Λ型四能级系统 超窄谱线 多通道量子干涉     

Sensitivity of depolarized lidar signals to cloud and aerosol particle properties

Measurements from depolarized lidars provide a promising method to retrieve both cloud and aerosol properties and a versatile complement to passive satellite-based sensors. For lidar observations of clouds and aerosols, multiple scattering plays an important role in the scattering process. Monte Carlo simulations are carried out to investigate the sensitivity of lidar backscattering depolarization to cloud and aerosol properties. Lidar parameters are chosen to be similar to those of the upcoming space-based CALIPSO lidar. Cases are considered that consist of a single cloud or aerosol layer, as well as a case in which cirrus clouds overlay different types of aerosols. It is demonstrated that besides thermodynamic cloud phase, the depolarized lidar signal may provide additional information on ice or aerosol particle shapes. However, our results show little sensitivity to ice or aerosol particle sizes. Additionally, for the case of multiple but overlapping layers involving both clouds and aerosols, the depolarized lidar contains information that can help identify the particle properties of each layer.     

On Characterizations of Proper Efficiency for Nonconvex Multiobjective Optimization

In this paper, nonconvex multiobjective optimization problems are studied. New characterizations of a properly efficient solution in the sense of Geoffrion's are established in terms of the stability of one scalar optimization problem and the existence of an exact penalty function of a scalar constrained program, respectively. One of the characterizations is applied to derive necessary conditions for a properly efficient control-parameter pair of a nonconvex multiobjective discrete optimal control problem with linear constraints.     

双面电弧焊接的传热模型

将等离子焊接(PAW)电弧和钨极氩弧焊(TIG)电弧串接,相对作用于工件的正反面形成双面电弧焊接(DSAW)系统,可以引导焊接电流沿工件厚度方向流过小孔,补偿等离子电弧穿透工件时消耗的能量,以有效地提高等离子弧的穿透能力.综合考虑影响双面电弧焊接正反面熔池几何形状的力学因素,建立了熔池表面变形的控制方程,以此为基础并采用帖体曲线坐标系建立了DSAW焊接传热的数学模型,分析了DSAW,PAW焊接传热的差异,从传热的角度解释了DSAW焊接熔深增加的原因.焊接工艺实验表明,计算结果与实测结果吻合良好. 关键词： 双面电弧焊接(DSAW) 传热模型 熔池表面变形模型     

Temperature dependence of interband transition energy in InGaAsN strain-compensated quantum-well and ridge-waveguide lasers fabricated with pulsed anodic oxidation

Ridge-waveguide InGaAsN triple-quantum-well strain-compensated lasers grown by metal organic chemical vapor deposition were fabricated with pulsed anodic oxidation. The laser’s output power reached 145 mW in continuous-wave mode at room temperature for a 4-?m -stripe-width laser. Continuous-wave single longitudinal mode operation was maintained at a high injection current level with a wavelength of 1287.3 nm at room temperature. Single longitudinal mode operation at 1317.2 nm was achieved at twice the threshold current at 100 °C. The band gap of InGaAsN in the quantum wells at different temperatures was calculated and compared to the measured temperature-dependent laser wavelength.     

Current distribution and giant magnetoimpedance in composite wires with helical magnetic anisotropy

The giant magnetoimpedance effect in composite wires consisting of a non-magnetic inner core and soft magnetic shell is studied theoretically. It is assumed that the magnetic shell has a helical anisotropy. The current and field distributions in the composite wire are found by means of a simultaneous solution of Maxwell equations and the Landau–Lifshitz equation. The expressions for the diagonal and off-diagonal impedance are obtained for low and high frequencies. The dependences of the impedance on the anisotropy axis angle and the shell thickness are analyzed. Maximum field sensitivity is shown to correspond to the case of the circular anisotropy in the magnetic shell. It is demonstrated that the optimum shell thickness to obtain maximum impedance ratio is equal to the effective skin depth in the magnetic material.